-
7404 NOT Logic Gate IC
- IC 74LS04 can deliver -0.4 mA current when the output is high.
- It can deliver 16 mA current when the output is low.
- When the Vcc is 5V and the input signal is 5V then the IC draws 1 mA current.
- When the Vcc is 5V and the input signal is 2.7V then the IC draws 20 to 40 micro-ampere currents.
- When the Vcc is 5V and the input signal is 0.4V then the IC draws -1.6 mA current.
₹12.007404 NOT Logic Gate IC
₹12.00 -
AT89S52-24PU DIP-40 Microcontroller
- Package/Case: DIP-40
- 8K Bytes of In-System Reprogrammable Flash Memory
- Endurance: 1,000 Write/Erase Cycles
- Fully Static Operation: 0 Hz to 33 MHz
- Three-level Program Memory Lock
- 256 x 8-Bit Internal RAM
- 32 Programmable I/O Lines
- Three 16-bit Timer/Counters
- Eight Interrupt Sources
- Programmable Serial Channel
- Low Power Idle and Power Down Modes
₹60.00 -
ULN2003 Stepper Motor Driver IC
- 500-mA-Rated Collector Current (Single Output)
- High-Voltage Outputs: 50 V
- Output Clamp Diodes
- Inputs Compatible With Various Types of Logic
- Relay-Driver Applications
₹15.00 -
NE555 Delay Monostable Switch Module with Relay
- Input voltage: DC 12V
- Adjustable time: 0-10 s
- AC Control voltage: 250V/max. 10A
- Max. load: 2200W
₹70.00 -
DS1307 PDIP-8 Real Time Calendar and Clock
- Operating temperature range from -40°C to 85°C
- Automatic power fail to detect and switch circuitry
- Timekeeping current of 300nA
- Completely manages all timekeeping functions
- 56byte, battery backed, general purpose RAM with unlimited writes
₹30.00 -
L293D Motor Driver IC
- Can be used to run Two DC motors with the same IC.
- 4 microcontroller pins
- Speed and Direction control is possible
- Motor voltage Vcc2 (Vs): 4.5V to 36V
- Maximum Peak motor current: 1.2A
- Maximum Continuous Motor Current: 600mA
- Supply Voltage to Vcc1(vss): 4.5V to 7V
₹30.00L293D Motor Driver IC
₹30.00 -
IRS2104 PDIP-8 Gate Driver
IRS2104 PDIP-8 Gate Driver
Features:Â
- Floating channel designed for bootstrap operation
- Fully operational to +600 V
- Tolerant to negative transient voltage, dV/dt immune
- Gate drive supply range from 10 V to 20 V
- Undervoltage lockout
- 3.3 V, 5 V, and 15 V input logic compatible
- Cross-conduction prevention logic
- Internally set deadtime
- High-side output in phase with input
- Shutdown input turns off both channels
- Matched propagation delay for both channels
₹82.00IRS2104 PDIP-8 Gate Driver
₹82.00 -
TL082 JFET Input Operational Amplifier (Op-Amp) IC DIP-8 Package
TL082 JFET Input Operational Amplifier
- IC Name: TL082
- Package/Case: DIP-8
₹109.00 -
IR2110 High and Low Side Driver IC DIP-14 Package
IR2110 High and Low Side Driver
Features:-
- Floating channel designed for bootstrap operation Fully operational to +500V or +600V Tolerant to negative transient voltage dV/dt immune
- Gate drive supply range from 10 to 20V
- Undervoltage lockout for both channels
- 3.3V logic compatible Separate logic supply range from 3.3V to 20V Logic and power ground ±5V offset
- CMOS Schmitt-triggered inputs with pull-down
- Cycle by cycle edge-triggered shutdown logic
- Matched propagation delay for both channels
- Outputs in phase with inputs
₹108.00 -
MC1458P Amplifier IC
MC1458P Amplifier IC
This general purpose amplifier MC1458P OP amp is a simple circuit component used for signal amplification. Its typical dual supply voltage is ±9|±12 V, with a minimum of ±5 V and maximum of ±15 V. This op amp has a temperature range of 0 °C to 70 °C. This device uses dual power supplies. It has 2 channels per chip. This device utilizes bipolar technology.
₹57.00MC1458P Amplifier IC
₹57.00 -
OP07CP Amplifier ICs
OP07CP Amplifier ICs
- IC Name: OP07
- Package/Case: DIP-8
₹16.00OP07CP Amplifier ICs
₹16.00
All Categories
- Atal Tinkering Lab (ATL)
- 3D Printer & Accessories
- Communications & Interfacing
- Connector & Cable Wires
- Consumer Products
- Development Boards
- Educational DIY & STEM Kits
- Electronic Components
- Electronic Modules & Displays
- Power Supply & Prototypes
- Robotics & Hobbies
- Sensors
- Tools & Equipments
- Bulk/Wholesale
