-
XBee Shield V03 Module Wireless Control
Applications :
- PC via a USB cable directly connected with XBee adapters.
- Bluetooth Bee configures or uses as a data-transmission.
- Arduino board pro mini downloader.
Features :
- Stackable design, easy to plug into the ARDUINO development board.
- Coupled with the Arduino Bluetooth Bee Bluetooth module, and other Bluetooth devices can communicate Wirelessly.
- Coupled with the XBee module, you can achieve two or more sets of communication between Arduino or Arduino and PC Communications.
- 3.3v and 5v dual power output.
- 3.3v and 5v IO compatible.
- USB 2.0 protocol.
- Bitbang mode ready.
- Easily connected to a PC via mini USB Cable.
- XBee-setting support software X-CTU.
₹126.00 -
RF Wireless Transmitter Receiver Module (Red) – 433 MHz
Features:
- Transmitter Module employs a crystal-stabilized oscillator, ensuring accurate frequency control for best range performance
- Range in open space (Standard Conditions) : 100 Meters
- No requirement of external RF components except Antenna
- RX Supply Current: 3.5 mA. RX Typical Sensitivity: 105 Dbm
- Low Power Consumption
₹125.00 -
MFRC-522 RC522 RFID Module
- Integrated MF RC522
- 13.56MHz contactless communication card chip.
- The low-voltage, low-cost, small size of the non-contact card chip to read and write.
- Working current：13 – 26mA / DC 3.3V
- Standby current：10 – 13mA / DC 3.3V
- Sleep current：<80uA
- Peak current：<30mA
- Working frequency：13.56MHz
- Card reading distance ：0～60mm （Mifare1 card）
₹125.00MFRC-522 RC522 RFID Module
₹125.00 -
ESP-01 ESP8266 Serial WIFI Wireless Transceiver Module
Features :
- Wi-Fi Direct (P2P), soft-AP
- Integrated TCP/IP protocol stack
- It features an integrated TR switch, balun, LNA, power amplifier and matching network
- Equips integrated PLL, regulators, DCXO and power management units
- Integrated low power 32-bit CPU could be used as an application processor
- SDIO 1.1 / 2.0, SPI, UART
- STBC, 1×1 MIMO, 2×1 MIMO
- A-MPDU & A-MSDU aggregation & 0.4ms guard interval
- Wake up and transmit packets in < 2ms
- Standby power consumption of < 1.0mW (DTIM3)
₹86.00 -
RFID Card 125kHz – Pack of 5
Features:
- Contactless transmission of data and supply energy (no battery needed)
- Anti-collision
- EEPROM
- 1Kbit, organized in 16 sectors, each district two passwords
- User definable access conditions for each memory block
- Data retention of 10 years.
- Write endurance 100 000 cycles
- Security
- Individual key set per sector (per application) to support multi-application with key hierarchy
- A unique serial number for each device
- Transport key protects access to EEPROM on-chip delivery
₹65.00RFID Card 125kHz – Pack of 5
₹65.00 -
NRF24L01 Wireless Transceiver Module-2.4GHz
The embedded baseband protocol engine (Enhanced ShockBurst) is based on packet communication and supports various modes from manual operation to advanced autonomous protocol operation.
Features :
- Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability,
- Particularly suitable for industrial control applications.
- 125 Channels, Multi-point communication, and frequency hopping to meet the communication needs
- Built-in hardware CRC error detection, Multipoint communication address control.
- Low-power 1.9 ~ 3.6V, only 1uA on Power down mode
- Built-in 2.4Ghz antenna
- Available software to set the address only received local Address when output data(Provide interrupt instruction), can be directly connected to a variety of microcontrollers, Software programming is very convenient.
- Built-in voltage regulator
- Standard DIP Pitch Interface for embedded applications.
₹65.00 -
RFID 13.56MHz Card (Pack of 5)
Features:
- Contactless transmission of data and supply energy (no battery needed)
- Anticollision
- EEPROM
- 1Kbit, organized in 16 sectors, each district two passwords
- User definable access conditions for each memory block
- Data retention of 10 years.
- Write endurance 100 000 cycles
- Security
- Individual key set per sector (per application) to support multi-application with key hierarchy
- A unique serial number for each device
- Transport key protects access to EEPROM on-chip delivery
₹60.00 -
RFID Card for Smart Access Control
Features:
- High security.
- The recorded content can be erased repeatedly.
- Can run away from the computer platform to achieve the Internet and offline automatic conversion mode of operation, to achieve a wide range of use, less wiring needs.
-
RF Wireless Transmitter Receiver Module (Green)
- Operating voltage: 5V.
- Quiescent Current: 4mA.
- Receiving frequency: 315MHz.
- Receiver sensitivity: -105 dB.
- Communication Distance (m): 20 ~ 200 meter.
All Categories
- Atal Tinkering Lab (ATL)
- 3D Printer & Accessories
- Communications & Interfacing
- Connector & Cable Wires
- Consumer Products
- Development Boards
- Educational DIY & STEM Kits
- Electronic Components
- Electronic Modules & Displays
- Power Supply & Prototypes
- Robotics & Hobbies
- Sensors
- Tools & Equipments
- Bulk/Wholesale
