No products in the cart.
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹390.00 (Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (Price is Exclusive of GST)
3 in 1 Raspberry Pi Aluminium Heat Sink for Pi 3
This heat sinks haves short profiles that are enough to fit within standard raspberry pi cases. Includes one large and two small heat sinks.Easy to apply heatsinks for a raspberry pi board.
₹11.00 (Price is Exclusive of GST)3 in 1 Raspberry Pi Aluminium Heat Sink for Pi 3
₹11.00 (Price is Exclusive of GST)LG INR18650M26 2600mAh (4c) LI-ION BATTERY
- Model No.: INR18650 M26
- Capacity (mAh): 2600
- Output Voltage: 3.7V
- Charge Rate: 1C
- High energy density
- High working voltage for single battery cells.
- Pollution-free
- Long cycle life
₹461.00 (Price is Exclusive of GST)LG INR18650M26 2600mAh (4c) LI-ION BATTERY
₹461.00 (Price is Exclusive of GST)LG INR18650MH1 3100mAh (3c) LI-ION BATTERY
- Brand: LG
- Nominal Voltage: 3.7V
- Charge Rate: 2C
- Max. Charge Voltage: 4.2±0.05V
- Rechargeable: Yes
- Cycle life: 800 Times
₹428.00 (Price is Exclusive of GST)LG INR18650MH1 3100mAh (3c) LI-ION BATTERY
₹428.00 (Price is Exclusive of GST)LG INR18650MJ1 3400mAh (3c) LI-ION BATTERY
- Model No : LG 18650 MJ1
- Capacity (mAh): 3400
- Output Voltage: 3.7V
- Charge Rate: 3C
- High energy density
- High working voltage for single battery cells.
- Pollution-free
- Long cycle life
₹333.00 (Price is Exclusive of GST)LG INR18650MJ1 3400mAh (3c) LI-ION BATTERY
₹333.00 (Price is Exclusive of GST)Original Arduino Nano
Nano’s got the breadboard-ability of the Boarduino and the Mini+USB with a smaller footprint than either, so users have more breadboard space. It’s got a pin layout that works well with the Mini or the Basic Stamp (TX, RX, ATN, GND on one top, power and ground on the other).
This new version 3.0 comes with ATMEGA328 which offers more programming and data memory space. It is two layers. That makes it easier to hack and more affordable.
You end up paying less with Nano than Mini and USB combined.
₹1,476.00 (Price is Exclusive of GST)Original Arduino Nano
₹1,476.00 (Price is Exclusive of GST)Original Arduino Uno Rev3
The Original Arduino Uno Rev3 board is the first in a series of USB Arduino boards and the reference model for the Arduino platform; for an extensive list of current, past or outdated boards see the Arduino index of boards.
₹1,625.00 (Price is Exclusive of GST)Original Arduino Uno Rev3
₹1,625.00 (Price is Exclusive of GST)Original Arduino Uno Rev3 SMD Atmega328P Development Board
Features-
- Flash Memory – 32 KB (ATmega32u4) of which 4 KB used by boot loader
- SRAM – 2 KB (ATmega328P)
- EEPROM – 1 KB (ATmega328P)
₹1,635.00₹1,999.00(Price is Exclusive of GST)Original Arduino Uno Rev3 SMD Atmega328P Development Board
₹1,635.00₹1,999.00(Price is Exclusive of GST)Pro-Range INR 18650 P28A 11.1V 2800mAh 3S1P 30A/35A Discharge Li-ion Drone Battery Pack
- Nominal Capacity (mAh): 2800
- Nominal Voltage (v): 11.1
- Max Charging Voltage (v): 12.6
- Charge Port: 4 Pin JST XH
- Discharge Port: Amass XT60
₹1,551.00 (Price is Exclusive of GST)Pro-Range INR 18650 P28A 11.1V 2800mAh 3S1P 30A/35A Discharge Li-ion Drone Battery Pack
₹1,551.00 (Price is Exclusive of GST)Pro-Range INR 18650 P28A 11.1V 2800mAh 3S1P 30A/35A Discharge Li-ion Drone Battery Pack (Triangle)
- Nominal Capacity (mAh): 2800
- Nominal Voltage (v): 11.1
- Max Charging Voltage (v): 12.6
- Charge Port: 4 Pin JST XH
- Discharge Port: Amass XT60
₹1,551.00 (Price is Exclusive of GST)Pro-Range INR 18650 P28A 11.1V 2800mAh 3S1P 30A/35A Discharge Li-ion Drone Battery Pack (Triangle)
₹1,551.00 (Price is Exclusive of GST)Pro-Range INR 18650 P28A 11.1V 5600mAh 3S2P 60A/70A Discharge Li-ion Drone Battery Pack (Triangle)
- Nominal Capacity (mAh): 5600
- Nominal Voltage (v): 11.1
- Max Charging Voltage (v): 12.6
- Charge Port: 4 Pin JST XH
- Discharge Port: Amass XT60
₹3,061.00 (Price is Exclusive of GST)Pro-Range INR 18650 P28A 11.1V 5600mAh 3S2P 60A/70A Discharge Li-ion Drone Battery Pack (Triangle)
₹3,061.00 (Price is Exclusive of GST)Pro-Range INR 18650 P28A 14.8V 2800mAh 4S1P 30A/35A Discharge Li-ion Drone Battery Pack
- Nominal Capacity (mAh): 2800
- Nominal Voltage (v): 14.8
- Max Charging Voltage (v): 16.8
- Charge Port: 5 Pin JST XH
- Discharge Port: Amass XT60
₹2,054.00 (Price is Exclusive of GST)Pro-Range INR 18650 P28A 14.8V 2800mAh 4S1P 30A/35A Discharge Li-ion Drone Battery Pack
₹2,054.00 (Price is Exclusive of GST)Pro-Range INR 18650 P28A 14.8V 2800mAh 4S1P 30A/35A Discharge Li-ion Drone Battery Pack with XT30
- Nominal Capacity (mAh): 2800
- Nominal Voltage (v): 14.8
- Max Charging Voltage (v): 16.8
- Charge Port: 5 Pin JST XH
- Discharge Port: Amass XT60
₹2,054.00 (Price is Exclusive of GST)Pro-Range INR 18650 P28A 14.8V 2800mAh 4S1P 30A/35A Discharge Li-ion Drone Battery Pack with XT30
₹2,054.00 (Price is Exclusive of GST)
