-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹638.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹638.00(Price is Exclusive of GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹264.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹264.00 (Price is Exclusive of GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST) -
ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
- This DHT11 temperature and humidity sensor shield is specially designed for ESP8266 ESP-01 ESP-01S development board.
- On-board 8pin socket enable you plug the wifi transceiver to the board directly perfect for DIY your wireless temperature/humidity webserver system.
- Working Voltage: DC 3.7 – 12V
- The weight of about 10 grams
- Package Included: 1 X DHT11 Humidity Temperature Sensor
₹130.00 (Price is Exclusive of GST)ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
₹130.00 (Price is Exclusive of GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹207.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹207.00 (Price is Exclusive of GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)
- “555 Timer IC” already exists in your wishlist
-
ADS1115 16-Bit ADC- 4 Channel with Programmable Gain Amplifier
- Wide Supply Range: 2.0v To 5.5v
- Low Current Consumption
- Continuous Mode: Only 150µa Single-shot
- Auto Shut-down
- Programmable Data Rate: 8SPS to 860SPS
- It has Internal low-drift voltage reference
₹90.00 (Price is Exclusive of GST)ADS1115 16-Bit ADC- 4 Channel with Programmable Gain Amplifier
₹90.00 (Price is Exclusive of GST) -
₹2,795.00 (Price is Exclusive of GST)SmartElex Bharat AI Innovators Kit Powered by Arduino | UNO EK R4 WiFi
₹2,795.00 (Price is Exclusive of GST) -
Pro-Range NEMA17 PR42HS40-1204AF-02 4.2kg-cm Stepper Motor-D Type Shaft
- Model: NEMA17 PR42HS40-1204AF-02
- Shaft Type: D Type
- Step Angle: 1.8
- Holding Torque: 4.2kg-cm
- The input pulse decides the rotation angle of the motor.
- High accuracy of around 3 to 5% a step.
- Provides good starting, stopping, and reversing.
- Control of this motor is less costly because of the exclusion of complex control circuitry.
- The speed is proportional to the frequency of the input pulses.
₹540.00 (Price is Exclusive of GST)Pro-Range NEMA17 PR42HS40-1204AF-02 4.2kg-cm Stepper Motor-D Type Shaft
₹540.00 (Price is Exclusive of GST) -
Electronic Metal Detector DIY Kit
- Operating Voltage: 3-5VDC
- Operating Current: 40mA
- DIY Kit
- Comes With all components.
- Comes with all the components
- Good Quality PCB
- Onboard detection coil
₹92.00 (Price is Exclusive of GST)Electronic Metal Detector DIY Kit
₹92.00 (Price is Exclusive of GST) -
ESP32-CAM-MB WIFI BLUETOOTH DEVELOPMENT BOARD WITH OV2640 CAMERA MICRO USB CONNECTION TO SERIAL
- The heart of the ESP32-CAM-MB is the ESP32
- WiFi and Bluetooth Connectivity
- OV2640 Camera Module
- Micro USB Connection
- I/O Pins and GPIO Headers
- MicroSD Card Slot
₹527.00 (Price is Exclusive of GST)ESP32-CAM-MB WIFI BLUETOOTH DEVELOPMENT BOARD WITH OV2640 CAMERA MICRO USB CONNECTION TO SERIAL
₹527.00 (Price is Exclusive of GST) -
PANASONIC NCR18650GA 3300mAh (3c) LI-ION BATTERY
- Size: 18650.
- Chemistry: NCR
- Nominal Capacity (min.) (mAh): 3350
- Nominal Capacity (typ.) (mAh): 3300
- Nominal Voltage: 3.6V
- Discharge: 10A Max Continuous
₹503.00 (Price is Exclusive of GST)PANASONIC NCR18650GA 3300mAh (3c) LI-ION BATTERY
₹503.00 (Price is Exclusive of GST) -
1210 (3528) Surface Mount Round LED Blue
- Low power consumption
- Wide viewing angle
- Ideal for backlight and indicator
₹2.00 (Price is Exclusive of GST)1210 (3528) Surface Mount Round LED Blue
₹2.00 (Price is Exclusive of GST) -
ALLIGATOR CLIP 4.5MM
The WD026 insulated alligator clips are perfect for use in electrical laboratory work. These small-sized alligator clips range in size from 35mm in length and are made from high-quality steel material. They come with an insulated coating to protect against accidental contact with live wires. These clips have a current rating of 5A and are available in various colors such as red, black, yellow, blue, green, and white. You can choose from three different lengths of 27.5 mm, 35 mm, and 42.5 mm depending on your requirements. These alligator clips come with crimp or solder termination options, making them versatile and easy to use in a variety of applications.
₹9.00 (Price is Exclusive of GST)ALLIGATOR CLIP 4.5MM
₹9.00 (Price is Exclusive of GST) -
6V to 12V Mini Vacuum/Air Pump
- Wide operating voltage range (6V – 12V DC) for flexible power options.
- Compact and lightweight design for easy installation in tight spaces.
- Low noise and low power consumption for efficient operation.
- Durable construction ensures long-lasting performance.
- Ideal for vacuum suction, air sampling, and small pneumatic applications.
₹95.00 (Price is Exclusive of GST)6V to 12V Mini Vacuum/Air Pump
₹95.00 (Price is Exclusive of GST) -
CJMCU-34725 TCS34725 Color Sensor RGB Module
- Operating Voltage: 3.3V
- Supply Voltage: 3.3V-5V
- The TCS3472 device provides digital return values for red, green, blue (RGB) and bright light sensing
- Color management is more accurate.
- The high sensitivity.
- Wide dynamic range.
- IR shading filters make the TCS3472 ideal.
₹168.00 (Price is Exclusive of GST)CJMCU-34725 TCS34725 Color Sensor RGB Module
₹168.00 (Price is Exclusive of GST) -
4G Lte Gsm Modem (A7672S)
- Model Name/Number: A7672S
- Output Voltage:Â 3.4V ~ 4.2V
- Compact size with abundant interfaces
- Suitable for LTE and GSM networks
- Abundant software functions: FOTA, LBS, SSL
- Form factor is compatible with the SIM7000/SIM7070 series
-
DOBOT Magician Educational Kit
1. Robot Arm
2. Vacuum Pump Kit
3. Gripper
4. Writing and Drawing Kit
5. 3D Printing Kit
6. Bluetooth Module
7. Laser Engraving Kit
8. Wi-Fi Module
9. Joystick Control Kit₹136,615.00 (Price is Exclusive of GST)DOBOT Magician Educational Kit
₹136,615.00 (Price is Exclusive of GST)
