-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹638.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹638.00(Price is Exclusive of GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹264.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹264.00 (Price is Exclusive of GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST) -
ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
- This DHT11 temperature and humidity sensor shield is specially designed for ESP8266 ESP-01 ESP-01S development board.
- On-board 8pin socket enable you plug the wifi transceiver to the board directly perfect for DIY your wireless temperature/humidity webserver system.
- Working Voltage: DC 3.7 – 12V
- The weight of about 10 grams
- Package Included: 1 X DHT11 Humidity Temperature Sensor
₹130.00 (Price is Exclusive of GST)ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
₹130.00 (Price is Exclusive of GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹207.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹207.00 (Price is Exclusive of GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)
-
1 Channel 12V Relay Module
- The relay high-level pull-in, the module contains current-limiting resistance, a high level can be DC +, microcontroller I / O port can be set high;
- Fault-tolerant design, even if the control line is broken, the relay will not move;
- Power indicator (red), 1 relay status indicator (blue)
- User-friendly interface design, all interfaces can be directly connected through the terminal leads, very convenient
- With four fixing bolt holes, easy to install
₹45.00 (Price is Exclusive of GST)1 Channel 12V Relay Module
₹45.00 (Price is Exclusive of GST) -
Original Arduino Uno Rev3 SMD Atmega328P Development Board
Features-
- Flash Memory – 32 KB (ATmega32u4) of which 4 KB used by boot loader
- SRAM – 2 KB (ATmega328P)
- EEPROM – 1 KB (ATmega328P)
₹1,635.00₹1,999.00(Price is Exclusive of GST)Original Arduino Uno Rev3 SMD Atmega328P Development Board
₹1,635.00₹1,999.00(Price is Exclusive of GST) -
IMAX B3 7-4V 11-1V Lithium Lipo RC Battery Balance Charge
Input voltage: AC 110V-240V
Balance charge current: 850mA
Display: Green & Red LED
Case: Plastic
Max charge power:10WBalance Charger for 7.4V-11.1V
₹215.00 (Price is Exclusive of GST)IMAX B3 7-4V 11-1V Lithium Lipo RC Battery Balance Charge
₹215.00 (Price is Exclusive of GST) -
16×2 Yellow or Green Backlight Alphanumeric Character LCD Display
- 16×2 LCD display Green LED Backlight
- The contrast of the screen can also be controlled by varying the voltage at the contrast control pin
- It is easy to interface with most micro controllers
₹90.00 (Price is Exclusive of GST)16×2 Yellow or Green Backlight Alphanumeric Character LCD Display
₹90.00 (Price is Exclusive of GST) -
ULN2003 Stepper Motor Driver IC
- 500-mA-Rated Collector Current (Single Output)
- High-Voltage Outputs: 50 V
- Output Clamp Diodes
- Inputs Compatible With Various Types of Logic
- Relay-Driver Applications
₹15.00 (Price is Exclusive of GST)ULN2003 Stepper Motor Driver IC
₹15.00 (Price is Exclusive of GST) -
Raspberry Pi 4 Model B 2GB RAM
Raspberry Pi 4 Model 2GB RAM capacity provides a huge scope for various multi-tasking activities, running powerful data servers, projects, virtual machines etc. This mini-computer is a better alternative since it is both energy efficient and cost effective. It is a silent machine and uses less energy than any other computer. It provides faster networking as it comes with a Gigabit Ethernet and onboard wireless networking along with better bluetooth connectivity. It can transfer data 10 times faster with the help of two USB 3.0 ports and two USB 2.0 ports.
₹3,954.00₹4,899.00(Price is Exclusive of GST)Raspberry Pi 4 Model B 2GB RAM
₹3,954.00₹4,899.00(Price is Exclusive of GST) -
PCB Mounting Type 2 Cell Holder 18650 Battery Holder
- Material Plastic, Steel
- No Soldering Just Plug and Use standatd battery
- High quality and strong material
₹40.00 (Price is Exclusive of GST)PCB Mounting Type 2 Cell Holder 18650 Battery Holder
₹40.00 (Price is Exclusive of GST) -
ATmega328P Micro-Controller IC
- True read while write operation
- Programming lock for software security
- Two 8-bit timer/counters with separate prescaler and compare mode
- One 16-bit timer/counter with separate prescaler, compare mode, and capture mode
- Real-time counter with separate oscillator
₹300.00 (Price is Exclusive of GST)ATmega328P Micro-Controller IC
₹300.00 (Price is Exclusive of GST) -
XL6009 boost converter DC-DC Booster Step Up Power supply module
- The performance is much higher than LM2577.
- Non-isolated Boost converter.
- It has a non-synchronous rectifier.
- Low ultra wide input voltage 3 v ~ 32 v, the best is 5 ~ 32 v working voltage range;
- Low ultra wide output voltage 5 v ~ 35 v;
₹46.00 (Price is Exclusive of GST)XL6009 boost converter DC-DC Booster Step Up Power supply module
₹46.00 (Price is Exclusive of GST) -
₹10.00 (Price is Exclusive of GST)TTP223 Touch Sensor Module
₹10.00 (Price is Exclusive of GST) -
White Type C cable – 1m for Arduino Nano V3.0
Features:
- Allows you to connect Arduino NanoV3.0 with USB port to the computer.
- Good data transfer rate.
₹42.70 (Price is Exclusive of GST)White Type C cable – 1m for Arduino Nano V3.0
₹42.70 (Price is Exclusive of GST) -
Thermoelectric Peltier Refrigeration Cooling System DIY Kit with 12706 Peltier
Package Includes:
1 x Cooling Fan
1 x Fan Gauze
1 x Guide cold plate
1 x Radiator
1 x Thermal insulation gasket
1 x Pack of Screws₹460.00₹635.00(Price is Exclusive of GST)Thermoelectric Peltier Refrigeration Cooling System DIY Kit with 12706 Peltier
₹460.00₹635.00(Price is Exclusive of GST)
