-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
-
Set of M5 X 65 MM Socket Head Cap (Allen) Bolt and Nut-12 pcs
M5 X 65 MM
- Bolt Head Outer Diameter: 8.5 mm
- Bolt Length: 65 mm
- Bolt Head Style: Round
- Bolt Drive Style: Hex Socket
- Color: Black
- Nut Type: Hex
- Nut Outer Diameter: 8 mm
- Allen Key size Required: 4 mm.
- Hardness is 2 times higher than copper,10 times higher than aluminum.
₹335.00 (excl. GST)Set of M5 X 65 MM Socket Head Cap (Allen) Bolt and Nut-12 pcs
₹335.00 (excl. GST) -
Set of 1 ALLEN KEY and 10 GRUB Screw M4*5 Set for Timing Pulley of 3D Printers
Timing Pulley
- Material: Steel
- Length of Allen Key: 48 mm
- Width of Allen Key: 1.4 mm
- Inner Diameter of grub: 2 mm
- Outer Diameter of Grub: 3.8 mm
₹12.00 (excl. GST) -
M3 X 8mm Bolt and Nut Set-25 pcs.
M3 X 8mm
- Type: M3 (3.0mm Diameter)
- Material: Mild Steel
- Bolt Length: 8mm
- Bolt Head Style: Slotted & Round
- Pack Quantity: 25 sets.
₹48.00 (excl. GST)M3 X 8mm Bolt and Nut Set-25 pcs.
₹48.00 (excl. GST) -
M3 x 25mm CHHD Bolt and Nut Set-20pcs.
M3 x 25mm
- Type: M3 (3.0mm Diameter)
- Material: Mild Steel
- Bolt Head Style: Slotted & Round
- Pack Quantity: 20 sets.
- Nut Type: Hex
₹48.00 (excl. GST)M3 x 25mm CHHD Bolt and Nut Set-20pcs.
₹48.00 (excl. GST) -
M4 x 20mm CHHD Bolt and Nut Set-20Pcs.
M4 x 20mm
- Type: M4 (4.0mm Diameter)
- Material: Mild Steel
- Bolt Head Style: Slotted & Round
- Pack Quantity: 20 sets.
- Nut Type: Hex
₹48.00 (excl. GST)M4 x 20mm CHHD Bolt and Nut Set-20Pcs.
₹48.00 (excl. GST) -
Set of 1 ALLEN KEY and 10 GRUB Screw M3*4 Set for Timing Pulley of 3D Printers
Timing Pulley
Set of 1 ALLEN KEY and 10 GRUB Screw M3*4 Set for 3D Printers
₹11.00 (excl. GST) -
6200ZZ Bearing 10x30x9 Shielded Miniature Ball Bearings
6200ZZ Bearing
- Model:Â 6200ZZ
- Inside diameter: 10 mm.
- Outside diameter: 30 mm.
- Width: 9 mm.
- Weight: 118 gm. (Each has 29.5 gm).
₹30.00 (excl. GST)6200ZZ Bearing 10x30x9 Shielded Miniature Ball Bearings
₹30.00 (excl. GST) -
M3 x 10mm CHHD Bolt and Nut Set-25 pcs.
Bolt and Nut Set
- Type: M3 (3.0mm Diameter)
- Material: Mild Steel
- Bolt Head Style: Slotted & Round
- Pack Quantity: 25 sets.
- Nut Type: Hex
₹48.00 (excl. GST)M3 x 10mm CHHD Bolt and Nut Set-25 pcs.
₹48.00 (excl. GST) -
Aluminium NEMA23 Shaft Coupling 6.35mm X 8mm
NEMA23 Shaft Coupling
- Exhibits good strength.
- High-grade aluminum couplings.
- Fit for all CNC projects
₹70.00 (excl. GST)Aluminium NEMA23 Shaft Coupling 6.35mm X 8mm
₹70.00 (excl. GST) -
T48 Universal Programmer Kit with 6 IC Adapters
 T48 Universal Programmer
   Features:
- This programmer is equipped with the upgrading Function of the built-in hardware firmware program that can make sure your programmer’s firmware flash and application software can be timely updated
- Supports most of the chips for programming
- English Language Support
- It can program faster than another programmer
₹4,650.00 (excl. GST)T48 Universal Programmer Kit with 6 IC Adapters
₹4,650.00 (excl. GST) -
Liquid pH Value Detection Sensor for Arduino
  pH Value Detection
- Heating voltage: 5±0.2V
- Working current: 5-10mA
- The detection concentration range: PH0-14
- The detection range of temperature: 0-60 centigrade
- The response time: ≤ 5S
- Stability time: ≤ 60S
- Power consumption: ≤ 0.5W
₹680.00 (excl. GST)Liquid pH Value Detection Sensor for Arduino
₹680.00 (excl. GST) -
Aluminum Brazing Wire Dia 2.0 (5 Meter Flux Cored Aluminum Brazing Wire)-pack of 3
Aluminum Brazing Wire
It significantly reduces the leakage problems found after brazing process as it’s manufactured with non-corrosive KAIF4/CSKAIF4 Flux injection technology patented and registered as complete seamless in the wires or rings. It does not require cleaning or little cleaning is needed post brazing as it is made with non-corrosive flux. Controlled flux ratio percentage to ensure that the flux is consistent across the wire for repeated high performance flow of the alloy.
₹425.00 (excl. GST)
