-
SN74LS136N GATE IC
SN74LS136N
XOR (Exclusive OR) IC 4 Channel Open Collector 14-PDIP
₹120.00 (excl. GST)SN74LS136N GATE IC
₹120.00 (excl. GST) -
LM741N PDIP-8 Operational Amplifier (Pack of 3 ICs)
LM741N
- Overload protection on the input and output
- No latch-up when the common mode range is exceeded
- Applications: Audio, Communications & Networking, Signal Processing
₹27.00 (excl. GST)LM741N PDIP-8 Operational Amplifier (Pack of 3 ICs)
₹27.00 (excl. GST) -
Charger Board Protection Module for Lithium Battery 3S 10A 12V 18650
Charger Board Protection
Features :
- Operating current : 6 – 8A.
- Current limit : 10 – 13A.
- Storage condition : -40 ~ +80 ℃.
- Resting current: less than 30uA.
- Effective lifetime: over 30,000 hours.
- Internal resistance: less than 100mΩ.
- Short-circuit protection: protection.
- Self-recovery delay.
₹46.00 (excl. GST)Charger Board Protection Module for Lithium Battery 3S 10A 12V 18650
₹46.00 (excl. GST) -
Air Pressure (0-40Kpa) Sensor Module-Hx710B
Air Pressure
Features:
- Two Selectable Differential Input Channels.
- On-Chip Active Low Noise PGA.
- Selectable Gain of 32,64 and 128.
- On-Chip Power Supply Regulator For Load Cell and ADC Analog Power Supply.
- On-Chip Power-ON-Reset
- Simple Digital Control And Serial Interface.
₹113.00 (excl. GST)Air Pressure (0-40Kpa) Sensor Module-Hx710B
₹113.00 (excl. GST) -
A4988 Stepper Motor Driver Controller Board- RED
Controller Board
- Compact size, easy to install and use.
- All jumpers hit the ON position to indicate 16 subdivisions (4988) or 32 subdivisions (8825).
- Jm connection motor: Jv Connects 5V and 12V-24V Power Supply.
- E /S /D /G of Jc corresponds to Enable /Step /Dir /Gnd driving signal output on the connection respectively.
₹49.00 (excl. GST)A4988 Stepper Motor Driver Controller Board- RED
₹49.00 (excl. GST) -
SeeedStudio Grove GSR sensor
SeeedStudio
Features:
- Detects conductance of the skin
- Finger Straps for electrodes
₹840.00 (excl. GST)SeeedStudio Grove GSR sensor
₹840.00 (excl. GST) -
Telemetry Kit 433Mhz 100MW
Telemetry Kit
Features :
- Very small size & Lightweight (under 4 grams without antenna)
- Transparent serial link
- MAVLink protocol framing and status reporting
- Frequency hopping spread spectrum (FHSS)
- Adaptive time division multiplexing (TDM)
- Support for LBT and AFA
- Configurable duty cycle
- Interchangeable air and ground modules
- Micro-USB port
- 6-position DF13 connector
- 100 mW maximum output power (adjustable)
- Based on HopeRF’s HM-TRP module
- RP-SMA connector
- 2-way full-duplex communication through adaptive TDM
- UART interface
- Transparent serial link
- MAVLink protocol framing
- Frequency Hopping Spread Spectrum (FHSS)
- Configurable duty cycle
- Error correction corrects up to 25% of bit errors
- Configurable through Mission Planner and APM Planner
- Built-in error correcting code (can correct up to 25% data bit errors)
- The demonstrated range of several kilometers with a small Omni antenna
- Can be used with a bi-directional amplifier for even more range
- AT commands for radio configuration
- RT commands for remote radio configuration
- Adaptive flow control when used with APM
- Based on the HopeRF HM-TRP radio module, featuring a SiLabs Si1000 RF microcontroller.
₹6,000.00 (excl. GST)Telemetry Kit 433Mhz 100MW
₹6,000.00 (excl. GST) -
DC Geared Motor with Encoder 16 RPM 138N.Cm 12V SPG30E-270K
DC Geared Motor
- Rated Voltage: 12 V
- No-load Current: 70 mA
- Rated Current: 410 mA
- Rated Torque: 14 kg-cm
- Shaft Diameter: 6 mm
- Gear Ratio: 270:1
₹1,690.00 (excl. GST)DC Geared Motor with Encoder 16 RPM 138N.Cm 12V SPG30E-270K
₹1,690.00 (excl. GST) -
Set of M5 X 65 MM Socket Head Cap (Allen) Bolt and Nut-12 pcs
M5 X 65 MM
- Bolt Head Outer Diameter: 8.5 mm
- Bolt Length: 65 mm
- Bolt Head Style: Round
- Bolt Drive Style: Hex Socket
- Color: Black
- Nut Type: Hex
- Nut Outer Diameter: 8 mm
- Allen Key size Required: 4 mm.
- Hardness is 2 times higher than copper,10 times higher than aluminum.
₹335.00 (excl. GST)Set of M5 X 65 MM Socket Head Cap (Allen) Bolt and Nut-12 pcs
₹335.00 (excl. GST) -
Set of 1 ALLEN KEY and 10 GRUB Screw M4*5 Set for Timing Pulley of 3D Printers
Timing Pulley
- Material: Steel
- Length of Allen Key: 48 mm
- Width of Allen Key: 1.4 mm
- Inner Diameter of grub: 2 mm
- Outer Diameter of Grub: 3.8 mm
₹12.00 (excl. GST) -
M3 X 8mm Bolt and Nut Set-25 pcs.
M3 X 8mm
- Type: M3 (3.0mm Diameter)
- Material: Mild Steel
- Bolt Length: 8mm
- Bolt Head Style: Slotted & Round
- Pack Quantity: 25 sets.
₹48.00 (excl. GST)M3 X 8mm Bolt and Nut Set-25 pcs.
₹48.00 (excl. GST) -
M3 x 25mm CHHD Bolt and Nut Set-20pcs.
M3 x 25mm
- Type: M3 (3.0mm Diameter)
- Material: Mild Steel
- Bolt Head Style: Slotted & Round
- Pack Quantity: 20 sets.
- Nut Type: Hex
₹48.00 (excl. GST)M3 x 25mm CHHD Bolt and Nut Set-20pcs.
₹48.00 (excl. GST)
All Categories
- Atal Tinkering Lab (ATL)
- 3D Printer & Accessories
- Communications & Interfacing
- Connector & Cable Wires
- Consumer Products
- Development Boards
- Educational DIY & STEM Kits
- Electronic Components
- Electronic Modules & Displays
- Mechanical Hardware Tools and Accessories
- Power Supply and Prototypes
- Robotics and Hobbies
- Sensors
- Scientific Tools and Equipments
- Other Tools and Equipment’s
- Bulk/Wholesale