-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
- “8 Pin IC Base – DIP IC Socket Connector” already exists in your wishlist
-
DT-830B LCD Digital Multimeter AC/DC 750/1000V Amp Volt Ohm Tester Meter
- 3 1/2 digits, 7segment, 0.5″high LCD Display
- Max display: 1999, Auto polarity display
- Small and compact design
- Sampling 2~3 times readings per second
- Diode assembly test / Temperature test/Transistor hFE test.
₹175.00 (excl. GST)DT-830B LCD Digital Multimeter AC/DC 750/1000V Amp Volt Ohm Tester Meter
₹175.00 (excl. GST) -
₹62.00 (excl. GST)3-Cell 18650 Battery Holder Series-Parallel
₹62.00 (excl. GST) -
Solder Tin Wire Spool Reel 50 Gram
- Rosin Core Solder
- Minimum Resistance
- No Additional Flux or paste is required
- No dry Solder
- Low Melting Point
- Widely applied in electrical repairs
- Easy to use, flows well and heats evenly.
- With the solder wire reel, soldering can be accomplished quickly.
₹105.00 (excl. GST)Solder Tin Wire Spool Reel 50 Gram
₹105.00 (excl. GST) -
Castor wheel with steel ball
- Dimensions: 22 x 15 mm (Diameter x Height)
- Weight: 10 gm
- Body Case Material: Plastic
- Ball Material: 304 Stainless Steel
- Application:Â for MiniQ robot
₹20.00 (excl. GST)Castor wheel with steel ball
₹20.00 (excl. GST) -
100K Potentiometer Preset Variable Trimmer
- Product Name : 100K ohm Variable ResistorÂ
- Usage : Breadboarding and Prototyping
- Resistor Value : 0-100K ohms
- Package Include :5 pcs X 100k ohm variable resist
₹8.00 (excl. GST)100K Potentiometer Preset Variable Trimmer
₹8.00 (excl. GST) -
HT12D and HT12E Encoder Decoder IC
Feature:
- Operating voltage: 2. 4V~12v
- Easy interface with an rf or an infrared transmission medium
- Minimal external components
- 18 Pin IC
₹75.00 (excl. GST)HT12D and HT12E Encoder Decoder IC
₹75.00 (excl. GST) -
DRV8825 Stepper Motor Driver with Aluminum Heat Sink
Features :
- Microstep resolutions:Â full, 1/2, 1/4, 1/8, 1/16, and 1/32.
- Simple step and direction control interface
- Six different step resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step
- Adjustable current control lets you set the maximum current output with a potentiometer. Hence lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates
- Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay)
- 45Â V maximum supply voltage
- Built-in regulator (no external logic voltage supply needed)
- Can interface directly with 3.3Â V and 5Â V systems
- Over-temperature thermal shutdown, over-current shutdown, and under-voltage lockout
- Short-to-ground and shorted-load protection
- 4-layer, 2Â oz copper PCB for improved heat dissipation
- Exposed solderable ground pad below the driver IC on the bottom of the PCB
₹126.00 (excl. GST)DRV8825 Stepper Motor Driver with Aluminum Heat Sink
₹126.00 (excl. GST) -
820k ohm 1 Watt Resistor (Pack of 5)
Features-
Resistance:Â 820K Ohm,
Power Rating:Â 1 Watt,
Approximate Maximum Current:Â 1.1mA
₹8.00 (excl. GST)820k ohm 1 Watt Resistor (Pack of 5)
₹8.00 (excl. GST) -
A4988 driver Stepper Motor Driver
Features :
- Automatic current decay mode detection/choice.
- Mixed with slow current decay mode.
- The low power dissipation of synchronous rectifier.
- Internal UVLO(ultra voltage lockout).
- Crossover current protection.
- Thermal shutdown circuit.
- Ground fault protection.
- Loading and short circuit protection.
- The optional five-step mode: full, 1/2, 1/4, 1/8 and 1/16.
₹78.00 (excl. GST)A4988 driver Stepper Motor Driver
₹78.00 (excl. GST) -
Soldering Iron Temperature-280 to 450 Degree Celsius
Features :
- The workhorse of electronic industries. The highest and the most popular product.
- General purpose for all electronic applications.
- Attains full operating Temperature within a seconds.
- Slide on a Replaceable tip.
- Cool Grip Insulating Nylon Handle.
- High Quality Built Material.
- Hook provided to Hang.
- Portable, Lightweight and easy to use.
- With Durable heating element designed for long Life.
₹125.00 (excl. GST)Soldering Iron Temperature-280 to 450 Degree Celsius
₹125.00 (excl. GST) -
0.28inch 0-100V Three Wire DC Mini Voltmeter Display Green
- Don’t compromise best price and high quality
- Package Includes :- 1pcs voltmeter
- Operating Voltage: 0-100 VDC
- this voltmeter will automatically move the decimal point’s position according to the different measuring voltage
- It is a 3-wire display.
₹80.00 (excl. GST)0.28inch 0-100V Three Wire DC Mini Voltmeter Display Green
₹80.00 (excl. GST) -
Breadboard Power Supply Module 3.3V 5V
Input Voltage: 6.5-12 V (DC) or USB power supply
Output Voltage: 3.3V or 5V can switch over
Maximum Output Current: <700 ma
Fluctuation two road independent control, can switch over to 0 V, 3.3 V, 5 V
On-board two groups of 3.3V, 5V DC output plug pin, convenient external lead use₹65.00 (excl. GST)Breadboard Power Supply Module 3.3V 5V
₹65.00 (excl. GST)
