-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
-
11.1V 2200mAh Lipo Lithium Polymer Rechargeable Battery
- Lithium-Polymer (Li-Po) Battery For RC, Planes and Drones
- 3 Cell (3S) 11.1V 2200MAH 35C
- Very Small in size and weight
- Connector Plug: XT60 Plug connector
- Discharge Current: 35*2200maH = 77Amp
₹1,500.00 (excl. GST)11.1V 2200mAh Lipo Lithium Polymer Rechargeable Battery
₹1,500.00 (excl. GST) -
DC Pump 24V 150PSI for Mist Fog Spray in Sanitizer Dispenser Tunnel
- Watering configuration: much the same, additional sprinklers and timers are required
- The price is the price of a pump, without other accessories
- Maximum pressure: 0.48MP.
₹1,500.00 (excl. GST)DC Pump 24V 150PSI for Mist Fog Spray in Sanitizer Dispenser Tunnel
₹1,500.00 (excl. GST) -
MLX90614 Non-Contact Human Body Infrared Temperature Measurement Module
- Operating Voltage(V): 3- 5
- Operating Current(mA): 2
- Communication protocol: I2C
- Power saving mode
- Automotive grad
- Small size, low cost
₹1,500.00 (excl. GST)MLX90614 Non-Contact Human Body Infrared Temperature Measurement Module
₹1,500.00 (excl. GST) -
Original Arduino Nano
Nano’s got the breadboard-ability of the Boarduino and the Mini+USB with a smaller footprint than either, so users have more breadboard space. It’s got a pin layout that works well with the Mini or the Basic Stamp (TX, RX, ATN, GND on one top, power and ground on the other).
This new version 3.0 comes with ATMEGA328 which offers more programming and data memory space. It is two layers. That makes it easier to hack and more affordable.
You end up paying less with Nano than Mini and USB combined.
₹1,476.00 (excl. GST)Original Arduino Nano
₹1,476.00 (excl. GST) -
TS835 FPV 5.8G Wireless AV Transmitter – 600Mw 48Ch (2-6S)
TS835 FPV 5.8G Wireless AV Transmitter
1 x 48 CH AVTransmitter.1 x Power cable1 x A Removable Antenna₹1,450.00 (excl. GST)TS835 FPV 5.8G Wireless AV Transmitter – 600Mw 48Ch (2-6S)
₹1,450.00 (excl. GST) -
Robotics DIY Learning Kit with Arduino UNO – V1
- Great for Starting with Arduino Programming
- A variety of components are included in this pack to try out different projects.
- The kit comes with quality components
- All-in-one kit, a great starter kit for learning to code.
- Microcontroller ATmega328 (SMD) – Interface CH340G
₹1,450.00₹1,850.00(excl. GST)Robotics DIY Learning Kit with Arduino UNO – V1
₹1,450.00₹1,850.00(excl. GST) -
NEEMA 23-JK57HS76-2804-1.89N m Stepper Motor – Round Type Shaft
Features :
- The input pulse decides the rotation angle of the motor.
- High accuracy of around 3 to 5% a step.
- It provides good starting, stopping, and reversing.
- Control of this motor is less costly because of the exclusion of complex control circuitry.
- The speed is proportional to the frequency of the input pulses.
₹1,430.00 (excl. GST)NEEMA 23-JK57HS76-2804-1.89N m Stepper Motor – Round Type Shaft
₹1,430.00 (excl. GST) -
Orange 11.1V 2200mAh 30C 3S Lithium Polymer Battery Pack
Features :
- Product Type: Lithium Polymer Battery Pack
- The Orange LiPo battery has matched resistance.
- Good Temperature Control.
- Minimum weight in Class
₹1,424.00₹1,500.00(excl. GST)Orange 11.1V 2200mAh 30C 3S Lithium Polymer Battery Pack
₹1,424.00₹1,500.00(excl. GST) -
Lemon 1550mAh 3S Lithium Polymer Battery Pack ( 45C/90C)
Features:
- Guaranteed leakproof operation in any position except inverted
- The expected life span of two to three years in float service applications
- Operation in a broad range of ambient temperatures
- Recovery capabilities even after deep discharges
- Compact, quick and simple to install, require low maintenance
₹1,420.00 (excl. GST)Lemon 1550mAh 3S Lithium Polymer Battery Pack ( 45C/90C)
₹1,420.00 (excl. GST) -
Robo Car DIY Kit with UNO Line Follower Obstacle Detector Edge Detector Maze Solver
Package Contents:
1x UNO R3 Board with USB Cable
1x 2WD Robo Car Kit
4x IR Sensor Module
1x Ultrasonic Sensor
1x L293D Motor Driver Board
3x Jumper Wire , 1x Male to Male, 1x Male to Female, 1x Female to Female with 20 Wires Each₹1,400.00₹1,900.00(excl. GST)Robo Car DIY Kit with UNO Line Follower Obstacle Detector Edge Detector Maze Solver
₹1,400.00₹1,900.00(excl. GST) -
BMS 4S 12V 60A Daly Lifepo4 -Battery Management System
- Brand: Daly
- Model: 4S 12V 60A
- Charge Current: 30A
- Discharge Current: 60A
- Battery Type: Lithium-Ion Battery
- Input Voltage (V): 12V
- Number of cells in series: 4S
₹1,395.00 (excl. GST)BMS 4S 12V 60A Daly Lifepo4 -Battery Management System
₹1,395.00 (excl. GST) -
SeeedStudio Grove GPS (Air530)
Features:
- Positioning error within 10 meters
- Multi-mode satellite positioning & navigation and support more than 6Â satellites at the same time
- The position still quickly and accurately under the condition of bad signal
- Low power consumption at only 31uA
- Compatible hard/soft interface for other modules
- Adopt the integrated design of RF baseband, which integrates DC/DC, LDO, LNA, RF front-end, baseband processing, 32-bit RISC based chip, RAM, FLASH storage, RTC and power management functions
- Cost-effective
- Compact size for easy deployment
₹1,378.00 (excl. GST)SeeedStudio Grove GPS (Air530)
₹1,378.00 (excl. GST)
