NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹390.00 (Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (Price is Exclusive of GST)
330K Ohm 2W Carbon Film Resistor 5% (Pack of 5)
Features-
Resistance: 330K Ohm,
Power Rating: 2 Watt,
Tolerance: 5 %
₹24.00 (Price is Exclusive of GST)330K Ohm 2W Carbon Film Resistor 5% (Pack of 5)
₹24.00 (Price is Exclusive of GST)TL084 Quad JFET Input Operational Amplifier (Op-Amp) IC DIP
TL084 Quad Amplifier
Features:-
• Low Power Consumption: 1.4 mA/ch Typical
• Wide Common-Mode and Differential Voltage Ranges
• Low Input Bias Current: 30 pA Typical
• Low Input Offset Current: 5 pA Typical
• Output Short-Circuit Protection
• Low Total Harmonic Distortion: 0.003% Typical
• High Input Impedance: JFET Input Stage
• Latch-Up-Free Operation
• High Slew Rate: 13 V/μs Typical
• Common-Mode Input Voltage Range
• Includes VCC+
₹24.00 (Price is Exclusive of GST)TL084 Quad JFET Input Operational Amplifier (Op-Amp) IC DIP
₹24.00 (Price is Exclusive of GST)3.3 Ohm Carbon Film Resistor- Pack of 50 pcs
- Resistance Value: 3.3 Ohms
- Rated Power: 0.25 Watt (1/4W); Tolerance : +/- 5%
- Carbon Film Resistor – Through Hole; Flame Retardant Coating
- Stiff 24 gauge leads (0.022 inches, 0.55 mm) perfect for solderless plug-in breadboards
- Package Include 10 x 3.3 Ohm (Note: Color of resistor may change, so please contact us if you need specific color resistors
₹25.00 (Price is Exclusive of GST)3.3 Ohm Carbon Film Resistor- Pack of 50 pcs
₹25.00 (Price is Exclusive of GST)10 Ohm Carbon Film Resistor- Pack of 50 pcs
- Resistance Value: 10 Ohms
- Rated Power: 0.25 Watt (1/4W); Tolerance : +/- 5%
- Carbon Film Resistor – Through Hole; Flame Retardant Coating
- Stiff 24 gauge leads (0.022 inches, 0.55 mm) perfect for solderless plug-in breadboards
- Package Include 10 x 10 Ohm (Note: Color of resistor may change, so please contact us if you need specific color resistors
₹25.00 (Price is Exclusive of GST)10 Ohm Carbon Film Resistor- Pack of 50 pcs
₹25.00 (Price is Exclusive of GST)100 Ohm Carbon Film Resistor 0.25 Watt – Pack of 50 pcs
- Resistance Value: 100 Ohms
- Rated Power: 0.25 Watt (1/4W); Tolerance : +/- 5%
- Carbon Film Resistor – Through Hole; Flame Retardant Coating
- Stiff 24 gauge leads (0.022 inches, 0.55 mm) perfect for solderless plug-in breadboards
- Package Include 10 x 100 Ohm (Note: Color of resistor may change, so please contact us if you need specific color resistors
₹25.00 (Price is Exclusive of GST)100 Ohm Carbon Film Resistor 0.25 Watt – Pack of 50 pcs
₹25.00 (Price is Exclusive of GST)220 Ohm Carbon Film Resistor- Pack of 50 pcs
- Resistance Value: 220 Ohms
- Rated Power: 0.25 Watt (1/4W); Tolerance : +/- 5%
- Carbon Film Resistor – Through Hole; Flame Retardant Coating
- Stiff 24 gauge leads (0.022 inches, 0.55 mm) perfect for solderless plug-in breadboards
- Package Include 10 x 220 Ohm (Note: Color of resistor may change, so please contact us if you need specific color resistors
₹25.00 (Price is Exclusive of GST)220 Ohm Carbon Film Resistor- Pack of 50 pcs
₹25.00 (Price is Exclusive of GST)Water Level Depth Detection Sensor
The Sensor is the Analog type which produces analog output signals according to the water pressure with its Detection Area of 40x16mm. Below are some details:
- Operating voltage: DC3-5V
- Operating current: less than 20mA
- Sensor Type: Analog
- Detection Area: 40mmx16mm
- Operating temperature: 10℃-30℃
- Humidity: 10% -90% non-condensing
₹25.00₹65.00(Price is Exclusive of GST)Water Level Depth Detection Sensor
₹25.00₹65.00(Price is Exclusive of GST)- ₹25.00 (Price is Exclusive of GST)
22E 2w Carbon Film Resistor – Pack of 5
₹25.00 (Price is Exclusive of GST) - ₹25.00 (Price is Exclusive of GST)
22E 2w Carbon Film Resistor – Pack of 5
₹25.00 (Price is Exclusive of GST) 150mm FrSky Receiver Antenna new version IPEX4
Features:
- 2.4G remote control
- Smaller IPEX port
- gold plated head
- precision machining, low loss, and high sensitivity
₹25.20 (Price is Exclusive of GST)150mm FrSky Receiver Antenna new version IPEX4
₹25.20 (Price is Exclusive of GST)1S 3.7V 3A 2MOS BMS Li-ion 18650 Battery Protection Board
1S 3.7V 3A 2MOS
Features:
- Small size designed for a four-cell battery pack.
- Simple and convenient circuit for easy connections
- Over-charge/Over-discharge Protection.
- Pre-soldered Nickel Strip ready to mount on battery.
₹26.00 (Price is Exclusive of GST)1S 3.7V 3A 2MOS BMS Li-ion 18650 Battery Protection Board
₹26.00 (Price is Exclusive of GST)DC Geared Motor Clamp for Mounting
- Material: Mild Steel
- Thickness: 1.5 mm
- Motor Mounting Hole: 3 mm
- Bracket Mounting Hole: 3 mm
- Weight: 18 gm (each)
₹27.00 (Price is Exclusive of GST)DC Geared Motor Clamp for Mounting
₹27.00 (Price is Exclusive of GST)
