-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
-
Orange 2200mAh Lithium Polymer Battery Pack 1S 25C/50C (3.7V)
Features :
- Product Type: Lithium Polymer Battery Pack
- The Orange LiPo battery has matched resistance.
- Good Temperature Control.
- Minimum weight in Class
Precautions :
- Avoid over-charging or over-discharge batteries
- Do not put it besides the high-temperature condition
- Don’t directly expose it into the fire
- Avoid the contact of water.
- Do not Short Circuit the battery Terminals
₹755.00 (excl. GST)Orange 2200mAh Lithium Polymer Battery Pack 1S 25C/50C (3.7V)
₹755.00 (excl. GST) -
Power Adaptor Dual Pin 12 Volt 1 Amps
- Stabilized Output, low ripple & low interference Ideal for CCTV Cameras / Routers / Modems / Cordless Phones / Set Top Boxes / Wireless Devices / POS Machines etc.
- Plug Type – 2 Pin
- 5.5mm DC Pin & 4.00mm Pin Combo
- Power supply for LED, SMD, LED strip, RGB LED strip
- Color as show on picture. Package includes 1 item.
₹90.00 (excl. GST)Power Adaptor Dual Pin 12 Volt 1 Amps
₹90.00 (excl. GST) -
1 Channel 12V Relay Module with Optocoupler
- Maximum Voltage: 5V
- Maximum Current: 10A
- Operating Temperature: -40 to 85°C
- Contact Load: Low Power
- Power Source: DC
- LED Indication of Relay ON
₹39.00 (excl. GST)1 Channel 12V Relay Module with Optocoupler
₹39.00 (excl. GST) -
Soldering Iron Stand
- Heavy-duty base to uphold the weight of Soldering iron 25W or lesser
- Nickel-plated spring holder
- Spring holder provides substantial room for holding the soldering iron support
₹55.00 (excl. GST)Soldering Iron Stand
₹55.00 (excl. GST) -
Li-Ion Rechargeable 2S Battery – 7.4V 2200mAH
1. High quality and durable
2. Provide excellent continuous power sources to your device
3. High energy density, large capacity and long life battery
4. No memory effect, recharge up to many times
5. Rechargeable type and professional design, safe and convenient to use₹190.00 (excl. GST)Li-Ion Rechargeable 2S Battery – 7.4V 2200mAH
₹190.00 (excl. GST) -
₹490.00 (excl. GST)4-Axis Multi-Rotor Quadcopter Frame – F450
₹490.00 (excl. GST) -
12 Volt LED Light Strips Aluminum for Holiday/Home/Party/Indoor/Outdoor Decoration
12 Volt LED Light Strips
- Very suitable for indoor outdoor lighting and decor
- the working voltage is 12V
- Super bright and Safe to use
- It is touchable
- Every 1-LED cuttable without damaging the rest strip, to help you meet different size need
₹140.00 (excl. GST) -
₹15.00 (excl. GST)6K8 Wire Wound Resistor 10W ±5%
₹15.00 (excl. GST) -
Orange A Grade10Ah Prismatic LiFePO4 Battery-3.2V
Features:
- Safest Lithium Chemistry.
- High specific energy and High capacity.
- Long Life Cycles and extended shelf life.
- High capacity, low internal resistance, good coulombic efficiency.
- The orange team takes a great effort to meet projects on time.
₹2,900.00 (excl. GST)Orange A Grade10Ah Prismatic LiFePO4 Battery-3.2V
₹2,900.00 (excl. GST) -
Resistor Kit 150 Pieces 30 Values 1/4W for Electronics DIY
- Carbon film assorted resistors
- 30 values
- Quantity: 150 pieces (5 each)
- Tolerance: 5%
- Power Rating: 0.25 wat
₹150.00 (excl. GST)Resistor Kit 150 Pieces 30 Values 1/4W for Electronics DIY
₹150.00 (excl. GST) -
1200W DC-DC Boost Module 20A Step-up Boost Convertor 8-60V to 12-80V Adjustable Power Supply
- 1200W DC to DC step-up power supply module for electronic equipment with adjustable power supply module where you can set the output voltage according to device.
- Input and output are designed with screw terminals for convenient wire connection and disconnection.
- Input voltage: 8-60V
- Output voltage: 12-80V continuously adjustable
₹795.00 (excl. GST) -
₹180.00 (excl. GST)Avr Usb Programmer Usbasp Usbisp Isp For Atmel Atmega Attiny Microcontrollers
₹180.00 (excl. GST)
