-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
-
Heartbeat Measuring Sensor Module
- Use IR LED and an optical transistor to detect pulsation in fingers
- Small and Compact module
- Easy to use.
₹38.00 (excl. GST)Heartbeat Measuring Sensor Module
₹38.00 (excl. GST) -
LM393 Sound Sensor Detection Module
- Working voltage: DC 3.3-5V.
- IC Chip: LM393
- Signal output indication.
- The output is digital.
- Single channel signal output.
- With the retaining bolt hole, convenient installation.
- Output low level and the signal light when there is sound.
₹38.00₹45.00(excl. GST)LM393 Sound Sensor Detection Module
₹38.00₹45.00(excl. GST) -
XT90 Female Connector with Housing (1pcs)
Features:
- Plug Type: 5mm gold bullet connector in nylon shroud
- Housing shape provides protection against shorting and reverse polarity
- Can accept up to 8AWG wires
- Semicircular solder terminals make it easy to install wires
- Able to sustain 90A+ continuous current
₹38.00 (excl. GST)XT90 Female Connector with Housing (1pcs)
₹38.00 (excl. GST) -
Solderless 400 pin breadboard – Normal Quality – Without Packing
Specifications and features:
- 400 tie points
- 1 Double strip, Total 300 tie points
- 2 Power lanes, Total 100 tie points in power lanes
- Perfect for Arduino shield prototyping and testing
- Plastic housing, metal contact clips
₹38.00₹58.00(excl. GST)Solderless 400 pin breadboard – Normal Quality – Without Packing
₹38.00₹58.00(excl. GST) -
0.1MM Copper Soldering Solder PPA Enamelled Repair Reel Wire
Specifications and Features:
- Wire Diameter: 0.1 mm.
- Length: about 15m
- Color: Copper
- Flux Content:about 15m
- Material: Copper / Copper Alloy
- Spool Size: 3.1cm x 3.1cm x 1.9cm.
- 100% Brand new and high quality!
- 1 roll of 0.1 mm Enamelled wire.
- It can be used to connect Fly line(Jump wire) for computer and mobile phone motherboard repair.
- No need to remove the lacquer, welding directly.
₹38.00₹44.00(excl. GST)0.1MM Copper Soldering Solder PPA Enamelled Repair Reel Wire
₹38.00₹44.00(excl. GST) -
LED Traffic Lights Signal Module / Digital Signal Output Traffic Light Module
- PCB Size: 60 x 20 x 13.5 (LxWxH)mm.
- Color: red, yellow, green
- LED Size: 10mm x 7.
- Brightness: Normal brightness.
- Voltage: 5V.
- Interface: common cathode red yellow green control.
₹38.00 (excl. GST) -
Laser sensor Module 650nm 6mm 5V 5mW Red Laser
- Voltage: 3.0 V – 5 V.
- Driver: APC circuit.
- Line length: about 135 mm.
- Transmit power: 58mW.
- Operating Current: 40mA.
- Operating Current: 40mA.
- Operating temperature: -36â—¦C ~ 65â—¦C.
₹39.00 (excl. GST)Laser sensor Module 650nm 6mm 5V 5mW Red Laser
₹39.00 (excl. GST) -
400 Points Breadboard
Features:
Material: abs plastic and tinned phosphor bronze
Uses: experiment, testing, robot
Self adhesive
Perfect for Arduino shield prototyping and testing₹39.00 (excl. GST)400 Points Breadboard
₹39.00 (excl. GST) -
1 Channel 5V Relay Module with Optocoupler
1 channel relay board
– Operating Voltage 5V
– Max Current : 20mA
– Relay Contact Current Capacity at AC250V: 10A₹39.00 (excl. GST)1 Channel 5V Relay Module with Optocoupler
₹39.00 (excl. GST) -
1 Channel 12V Relay Module with Optocoupler
- Maximum Voltage: 5V
- Maximum Current: 10A
- Operating Temperature: -40 to 85°C
- Contact Load: Low Power
- Power Source: DC
- LED Indication of Relay ON
₹39.00 (excl. GST)1 Channel 12V Relay Module with Optocoupler
₹39.00 (excl. GST) -
LM358DR SOIC-8 High Gain Operational Amplifier
Features:
- Single supply voltage from 3V to 32V and dual supply range from ±1.5V to ±16V
- Slew rate at unity gain is 0.3 V/µs
- Wide unity gain bandwidth of 0.7MHz
- Low drain supply current is 0.7mA independent of supply voltage
- Input offset voltage of 3mV
- Input offset current of 2nA
- Input bias current of -20nA
- Differential input voltage range equal to the maximum rated supply voltage of 32V
- Common mode rejection ratio (CMRR) of 80dB
- Operating temperature range from 0°C to 70°C
- Applications: Signal Processing, Sensing & Instrumentation, Consumer Electronics, Portable Devices, Motor Drive & Control
₹39.00 (excl. GST)LM358DR SOIC-8 High Gain Operational Amplifier
₹39.00 (excl. GST) -
Metal Touch Sensor Module
Features:
Working voltage: DC 5V
Low level output signal used for human body touch sensor alarm
Adjustable sensitivity
Single channel signal output
With fixed bolt hole for easy installation₹40.00₹55.00(excl. GST)Metal Touch Sensor Module
₹40.00₹55.00(excl. GST)
