No products in the cart.
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹390.00 (Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (Price is Exclusive of GST)
600VA/360Watt Uninterrupted Power Supply -UPS FPS-755
- Compact Design Line Interactive UPS with Load Capacity of 360Watts / 600VA. Output Frequency (sync to mains) : 47 – 63 Hz Sync to mains
- Three Battery Backed up and Surge Protected 6A, 2/3 Pin Output Indian Power Socket
₹2,000.00 (Price is Exclusive of GST)600VA/360Watt Uninterrupted Power Supply -UPS FPS-755
₹2,000.00 (Price is Exclusive of GST)606ZZ Bearing 6x17x6 Stainless Steel Shielded Miniature Bearings – 2 Pcs
606ZZ Bearing 6x17x6
- Model: 606ZZ
- Inside diameter (ID): 6 mm.
- Outside diameter (OD): 17 mm.
- Width: 6 mm.
- Weight: 5 gm (each)
₹42.00 (Price is Exclusive of GST)606ZZ Bearing 6x17x6 Stainless Steel Shielded Miniature Bearings – 2 Pcs
₹42.00 (Price is Exclusive of GST)6200ZZ Bearing 10x30x9 Shielded Miniature Ball Bearings
6200ZZ Bearing
- Model: 6200ZZ
- Inside diameter: 10 mm.
- Outside diameter: 30 mm.
- Width: 9 mm.
- Weight: 118 gm. (Each has 29.5 gm).
₹30.00 (Price is Exclusive of GST)6200ZZ Bearing 10x30x9 Shielded Miniature Ball Bearings
₹30.00 (Price is Exclusive of GST)6200ZZ Bearing 10x30x9 Shielded Miniature Ball Bearings (2pcs)
- Inside diameter: 10 mm.
- Outside diameter: 30 mm.
- Width: 9 mm.
- Weight: 118 gm. (Each has 29.5 gm).
₹68.00 (Price is Exclusive of GST)6200ZZ Bearing 10x30x9 Shielded Miniature Ball Bearings (2pcs)
₹68.00 (Price is Exclusive of GST)650nm 6mm 5V DC 5mW Mini Laser Dot Diode Module
- Output Power: 5mW
- Working Voltage: 5V DC
- Working temperature: -10 ℃~＋40 ℃
- Housing material: Copper
- Working life: more than 2000 hours
- Spot mode: Dot Facula (continuous output)
- Laser wavelength: 650nm red-colored.
- Operating current: <40mA
- Power lead length: 120mm.
₹9.50 (Price is Exclusive of GST)650nm 6mm 5V DC 5mW Mini Laser Dot Diode Module
₹9.50 (Price is Exclusive of GST)684 ZZ Bearing 4x9x4 Shielded Miniature Ball Bearings-4Pcs
The shield protects the working parts of the bearing from environmental debris that may be introduced and could reduce the ball bearing speed and lifespan.
Rolling bearings are used in a range of applications from agricultural machinery to conveying equipment, robotics, dental equipment, elevators, rolling mills, ship rudder shafts, and aggregate crushers, among others.
Each bearing has a HIGH load carrying capacity, which is around 250 kg to 500 kg.
- Inner Diameter (ID): 4 mm
- Outer Diameter (OD): 9 mm
- Width (mm): 4
₹130.00 (Price is Exclusive of GST)684 ZZ Bearing 4x9x4 Shielded Miniature Ball Bearings-4Pcs
₹130.00 (Price is Exclusive of GST)- ₹10.00 (Price is Exclusive of GST)
68E 5W 5% Axial Lead Ceramic Encased White Wire Wound Resistors
₹10.00 (Price is Exclusive of GST) 696ZZ Bearing 6x15x5 Stainless Steel Shielded Miniature Bearings (4Pcs)
696ZZ Bearing 6x15x5
- Model: 696ZZ
- Inside diameter (ID): 6 mm.
- Outside diameter (OD): 15 mm.
- Width: 5 mm.
- Weight: 16 gm. (Each has 3 gm).
₹82.00 (Price is Exclusive of GST)696ZZ Bearing 6x15x5 Stainless Steel Shielded Miniature Bearings (4Pcs)
₹82.00 (Price is Exclusive of GST)6E8 ohm 5 Watt Wire Wound Resistor (Pack of 2)
Features/Specs:
- Resistor Value: 6.8 ohm
- Wattage: 5 Watt
- Type: Wire Wound
₹30.00 (Price is Exclusive of GST)6E8 ohm 5 Watt Wire Wound Resistor (Pack of 2)
₹30.00 (Price is Exclusive of GST)- ₹15.00 (Price is Exclusive of GST)
6K8 Wire Wound Resistor 10W ±5%
₹15.00 (Price is Exclusive of GST) 6MM Flange Linear Motion Ball Bearing LMF6UU
Features :
- Metric Flange Linear Bearing
- Circular Flange
- Four Mount Hole
₹139.00 (Price is Exclusive of GST)6MM Flange Linear Motion Ball Bearing LMF6UU
₹139.00 (Price is Exclusive of GST)6x15x5 696ZZ Stainless Steel Shielded Miniature Bearings – 4Pcs
The 6x15x5 696ZZ Bearings protects the working parts of the bearing from environmental debris that may be introduced and could reduce the ball bearing speed and lifespan.
Rolling bearings are used in a range of applications from agricultural machinery to conveying equipment, robotics, dental equipment, elevators, rolling mills, ship rudder shafts, and aggregate crushers, among others.
₹80.00 (Price is Exclusive of GST)6x15x5 696ZZ Stainless Steel Shielded Miniature Bearings – 4Pcs
₹80.00 (Price is Exclusive of GST)
