-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
-
₹115.00 (excl. GST)ACS712 Test Current Sensor Module 20A
₹115.00 (excl. GST) -
ACS712 – 30A Range Current Sensor Module
- Low-noise analog signal path
- Device bandwidth is set via the new FILTER pin
- 5 µs output rise time in response to step input current
- Small footprint, low-profile SOIC8 package
- 2.1 kVRMS minimum isolation voltage from pins 1-4 to pins 5-8
- Supply Voltage: 4.5V~5.5V DC
- Measure Current Range: 30A
- Sensitivity: 100mV/A
₹150.00 (excl. GST)ACS712 – 30A Range Current Sensor Module
₹150.00 (excl. GST) -
ACS712 Test Current Sensor Module 5A
- Low-noise analog signal path.
- Device bandwidth is set via the new FILTER pin.
- 5 µs output rise time in response to step input current.
- Small footprint, low-profile SOIC8 package.
- 2.1 kV RMS minimum isolation voltage from pins 1-4 to pins 5-8.
₹115.00 (excl. GST)ACS712 Test Current Sensor Module 5A
₹115.00 (excl. GST) -
AD633JNZ IC ANALOG MULTIPLIER 8-DIP
AD633JNZ IC
1.The AD633 is a complete four-quadrant multiplier offered in low cost 8-lead SOIC and PDIP packages. The result is a product that is cost effective and easy to apply.
2.No external components or expensive user calibration are required to apply the AD633.
3.Monolithic construction and laser calibration make the device stable and reliable.
4.High (10 MΩ) input resistances make signal source loading negligible.
5.Power supply voltages can range from ±8 V to ±18 V. The internal scaling voltage is generated by a stable Zener diode; multiplier accuracy is essentially supply insensitive.
₹1,600.00 (excl. GST)AD633JNZ IC ANALOG MULTIPLIER 8-DIP
₹1,600.00 (excl. GST) -
AD8232 ECG Sensor Module Kit for Heart Rate Monitoring
- This electrical activity can be charged as an ECG or Electrocardiogram and output as an analog reading.
- Leads-Off Detection.
- Shutdown Pin.
- LED Indicator.
- Analog Output.
- 3.5 mm Jack for Biomedical Pad Connection
₹550.00 (excl. GST)AD8232 ECG Sensor Module Kit for Heart Rate Monitoring
₹550.00 (excl. GST) -
ADC0809CCN-IC ADC 8BIT SAR 28DIP
ADC0809CCN
Reference Type :External
Voltage – Supply, Analog : 4.5V ~ 6.5V
Voltage – Supply, Digital : 4.5V ~ 6.5V
Features
-Operating Temperature : -40°C ~ 85°C
Package / Case : 28-DIP (0.600″, 15.24mm)
Supplier Device Package : 28-DIP
Mounting Type : Through Hole
₹75.00 (excl. GST)ADC0809CCN-IC ADC 8BIT SAR 28DIP
₹75.00 (excl. GST) -
Adjustable Resistor Box Kit 10 Values 3296W
Adjustable Resistor Box Kit
Package List
101 5pcs
201 5pcs
501 5pcs
102 5pcs
202 5pcs
502 5pcs
103 5pcs
203 5pcs
503 5pcs
104 5pcs₹460.00 (excl. GST)Adjustable Resistor Box Kit 10 Values 3296W
₹460.00 (excl. GST) -
Advanced Johnson/Mini Gear Motor L Clamp (Bracket)
Advanced Johnson/Mini Gear Motor L Clamp
- Material: Mild Steel
- Thickness: 1.5 mm
- Motor Mounting Hole: 3 mm
- Bracket Mounting Hole: 4 mm
- Weight: 34 gm
₹126.00 (excl. GST)Advanced Johnson/Mini Gear Motor L Clamp (Bracket)
₹126.00 (excl. GST) -
ADXL345 3 Axis Accelerometer Gravity Module
- On-board ADXL345, it’s a low cost cap-based accelerometer sensor
- Support 5V/3.3V voltage input, onboard RT9161, better performance than 1117, faster load the appropriate speed, it is ideal for high noise power supply environment
- Common Pins were lead out, Pin distance is standard 100mil (2.54mm), compatible for your new system
- Communication: I2C
₹155.00 (excl. GST)ADXL345 3 Axis Accelerometer Gravity Module
₹155.00 (excl. GST) -
Air Pressure (0-40Kpa) Sensor Module-Hx710B
Air Pressure
Features:
- Two Selectable Differential Input Channels.
- On-Chip Active Low Noise PGA.
- Selectable Gain of 32,64 and 128.
- On-Chip Power Supply Regulator For Load Cell and ADC Analog Power Supply.
- On-Chip Power-ON-Reset
- Simple Digital Control And Serial Interface.
₹113.00 (excl. GST)Air Pressure (0-40Kpa) Sensor Module-Hx710B
₹113.00 (excl. GST) -
Alligator Clips10pcs of Double-ended Crocodile Clips Roach Clip
- Colour: Red, Green, Yellow, White, and Black, etc.
- Cable length: 45 cm.
- Net weight: 82 gm.
- They are very useful for connecting components to wires.
- It is insulation covered clips connected to the wire from both ends.
₹110.00 (excl. GST)Alligator Clips10pcs of Double-ended Crocodile Clips Roach Clip
₹110.00 (excl. GST) -
Aluminium NEMA23 Shaft Coupling 6.35mm X 8mm
NEMA23 Shaft Coupling
- Exhibits good strength.
- High-grade aluminum couplings.
- Fit for all CNC projects
₹70.00 (excl. GST)Aluminium NEMA23 Shaft Coupling 6.35mm X 8mm
₹70.00 (excl. GST)
