-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST)
-
A4988 driver Stepper Motor Driver
Features :
- Automatic current decay mode detection/choice.
- Mixed with slow current decay mode.
- The low power dissipation of synchronous rectifier.
- Internal UVLO(ultra voltage lockout).
- Crossover current protection.
- Thermal shutdown circuit.
- Ground fault protection.
- Loading and short circuit protection.
- The optional five-step mode: full, 1/2, 1/4, 1/8 and 1/16.
₹78.00 (excl. GST)A4988 driver Stepper Motor Driver
₹78.00 (excl. GST) -
A4988 Stepper Motor Driver Controller Board- RED
Controller Board
- Compact size, easy to install and use.
- All jumpers hit the ON position to indicate 16 subdivisions (4988) or 32 subdivisions (8825).
- Jm connection motor: Jv Connects 5V and 12V-24V Power Supply.
- E /S /D /G of Jc corresponds to Enable /Step /Dir /Gnd driving signal output on the connection respectively.
₹49.00 (excl. GST)A4988 Stepper Motor Driver Controller Board- RED
₹49.00 (excl. GST) -
ABS Plastic Landing Gear for Quadcopter (Pack of 4) – Made in INDIA
ABS Plastic Landing Gear for Quadcopter
- Color: Black
- Material: ABS Plastic
- Length: ~190mm
- Ground Clearance: 150 mm
- Compatibility: Q450 and S500 Frames
- Weight: 75 gm (total of 4)
₹132.00 (excl. GST)ABS Plastic Landing Gear for Quadcopter (Pack of 4) – Made in INDIA
₹132.00 (excl. GST) -
AC Voltage Sensor Module ZMPT101B (Single Phase)
- Voltage – 250V
- Easy PCB mounting
- Good consistency
- Widely acclaimed
₹71.00 (excl. GST)AC Voltage Sensor Module ZMPT101B (Single Phase)
₹71.00 (excl. GST) -
₹115.00 (excl. GST)ACS712 Test Current Sensor Module 20A
₹115.00 (excl. GST) -
ACS712 – 30A Range Current Sensor Module
- Low-noise analog signal path
- Device bandwidth is set via the new FILTER pin
- 5 µs output rise time in response to step input current
- Small footprint, low-profile SOIC8 package
- 2.1 kVRMS minimum isolation voltage from pins 1-4 to pins 5-8
- Supply Voltage: 4.5V~5.5V DC
- Measure Current Range: 30A
- Sensitivity: 100mV/A
₹150.00 (excl. GST)ACS712 – 30A Range Current Sensor Module
₹150.00 (excl. GST) -
ACS712 Test Current Sensor Module 5A
- Low-noise analog signal path.
- Device bandwidth is set via the new FILTER pin.
- 5 µs output rise time in response to step input current.
- Small footprint, low-profile SOIC8 package.
- 2.1 kV RMS minimum isolation voltage from pins 1-4 to pins 5-8.
₹115.00 (excl. GST)ACS712 Test Current Sensor Module 5A
₹115.00 (excl. GST) -
AD633JNZ IC ANALOG MULTIPLIER 8-DIP
AD633JNZ IC
1.The AD633 is a complete four-quadrant multiplier offered in low cost 8-lead SOIC and PDIP packages. The result is a product that is cost effective and easy to apply.
2.No external components or expensive user calibration are required to apply the AD633.
3.Monolithic construction and laser calibration make the device stable and reliable.
4.High (10 MΩ) input resistances make signal source loading negligible.
5.Power supply voltages can range from ±8 V to ±18 V. The internal scaling voltage is generated by a stable Zener diode; multiplier accuracy is essentially supply insensitive.
₹1,600.00 (excl. GST)AD633JNZ IC ANALOG MULTIPLIER 8-DIP
₹1,600.00 (excl. GST) -
AD8232 ECG Sensor Module Kit for Heart Rate Monitoring
- This electrical activity can be charged as an ECG or Electrocardiogram and output as an analog reading.
- Leads-Off Detection.
- Shutdown Pin.
- LED Indicator.
- Analog Output.
- 3.5 mm Jack for Biomedical Pad Connection
₹550.00 (excl. GST)AD8232 ECG Sensor Module Kit for Heart Rate Monitoring
₹550.00 (excl. GST) -
ADC0809CCN-IC ADC 8BIT SAR 28DIP
ADC0809CCN
Reference Type :External
Voltage – Supply, Analog : 4.5V ~ 6.5V
Voltage – Supply, Digital : 4.5V ~ 6.5V
Features
-Operating Temperature : -40°C ~ 85°C
Package / Case : 28-DIP (0.600″, 15.24mm)
Supplier Device Package : 28-DIP
Mounting Type : Through Hole
₹75.00 (excl. GST)ADC0809CCN-IC ADC 8BIT SAR 28DIP
₹75.00 (excl. GST) -
Adjustable Resistor Box Kit 10 Values 3296W
Adjustable Resistor Box Kit
Package List
101 5pcs
201 5pcs
501 5pcs
102 5pcs
202 5pcs
502 5pcs
103 5pcs
203 5pcs
503 5pcs
104 5pcs₹460.00 (excl. GST)Adjustable Resistor Box Kit 10 Values 3296W
₹460.00 (excl. GST) -
Advanced Johnson/Mini Gear Motor L Clamp (Bracket)
Advanced Johnson/Mini Gear Motor L Clamp
- Material: Mild Steel
- Thickness: 1.5 mm
- Motor Mounting Hole: 3 mm
- Bracket Mounting Hole: 4 mm
- Weight: 34 gm
₹126.00 (excl. GST)Advanced Johnson/Mini Gear Motor L Clamp (Bracket)
₹126.00 (excl. GST)
