-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹638.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹638.00(Price is Exclusive of GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹264.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹264.00 (Price is Exclusive of GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST) -
ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
- This DHT11 temperature and humidity sensor shield is specially designed for ESP8266 ESP-01 ESP-01S development board.
- On-board 8pin socket enable you plug the wifi transceiver to the board directly perfect for DIY your wireless temperature/humidity webserver system.
- Working Voltage: DC 3.7 – 12V
- The weight of about 10 grams
- Package Included: 1 X DHT11 Humidity Temperature Sensor
₹130.00 (Price is Exclusive of GST)ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
₹130.00 (Price is Exclusive of GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹207.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹207.00 (Price is Exclusive of GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)
- “Pro-Range NEMA17 PR42HS40-1204AF-02 4.2kg-cm Stepper Motor-D Type Shaft” already exists in your wishlist
-
Original Arduino Nano
Nano’s got the breadboard-ability of the Boarduino and the Mini+USB with a smaller footprint than either, so users have more breadboard space. It’s got a pin layout that works well with the Mini or the Basic Stamp (TX, RX, ATN, GND on one top, power and ground on the other).
This new version 3.0 comes with ATMEGA328 which offers more programming and data memory space. It is two layers. That makes it easier to hack and more affordable.
You end up paying less with Nano than Mini and USB combined.
₹1,291.00 (Price is Exclusive of GST)Original Arduino Nano
₹1,291.00 (Price is Exclusive of GST) -
6 Flexible Arms Soldering Station With Swiveling Alligator Clip
- Total Weight: 400 gm
- Each Arm length: 34 cm
- Alligator clip(L): 44mm (large size)
- Alligator clips maximum thickness limit: 6mm
- Built-in Trays for components and screws.
- 6 flexible arms each with a large swiveling alligator clip.
- 6+1 pockets in beautifully base to hold loose components.
- 6 Silicon clip tips for the ultimate heat resistance.
₹1,272.00 (Price is Exclusive of GST)6 Flexible Arms Soldering Station With Swiveling Alligator Clip
₹1,272.00 (Price is Exclusive of GST) -
Pro-Range 11.1V 1300mAh 40C 3S Lithium Polymer Battery Pack
- Model No : Pro-Range 1300 3S-40C
- Capacity: 1300 mAh.
- Max Burst Discharge: 50C (10sec)
- Max Continuous Discharge : 40C
- Discharge Plug: XT60
- Charge Rate : 1-3 C Recommended, 5 C Max.
- weight : 110 gm.
₹1,264.00 (Price is Exclusive of GST)Pro-Range 11.1V 1300mAh 40C 3S Lithium Polymer Battery Pack
₹1,264.00 (Price is Exclusive of GST) -
Orange 14.8V 850mAh 25C 4S Lithium Polymer Battery Pack
- Model No: ORANGE 850 4S
- Voltage: 14.8V
- Max Continuous Discharge: 25C
- Discharge Plug: XT-60
- Dimensions: 6 x 3 x 3CM
- Weight: 94g
₹1,263.00 (Price is Exclusive of GST)Orange 14.8V 850mAh 25C 4S Lithium Polymer Battery Pack
₹1,263.00 (Price is Exclusive of GST) -
Orange 11.1V 1800mAh 30C 3S Lithium Polymer Battery Pack
Features :
- Product Type: Lithium Polymer Battery Pack
- The Orange LiPo battery has matched resistance.
- Good Temperature Control.
- Minimum weight in Class
₹1,257.00 (Price is Exclusive of GST)Orange 11.1V 1800mAh 30C 3S Lithium Polymer Battery Pack
₹1,257.00 (Price is Exclusive of GST) -
Bms 13S 40A 48V Waterproof Protection Circuit Module
- 13S 48V BMS
- Discharging current – 40A
- Charging current – 20 A
- Waterproof.
₹1,250.00 (Price is Exclusive of GST)Bms 13S 40A 48V Waterproof Protection Circuit Module
₹1,250.00 (Price is Exclusive of GST) -
Otto Wheel Based Robot Kit for Robotics Learning
- Part Reference: Otto DIY Bot Wheel Based
- Application: For Robotics Learning
- Color: Varies and not constant as per image
- Structure Type: 3D Printed
- Microcontroller: Arduino Nano V3
₹1,250.00 (Price is Exclusive of GST)Otto Wheel Based Robot Kit for Robotics Learning
₹1,250.00 (Price is Exclusive of GST) -
Orange 11.1V 1300mAh 30C 3S Lithium Polymer Battery Pack
Features :
- Product Type: Lithium Polymer Battery Pack
- The Orange LiPo battery has matched resistance.
- Good Temperature Control.
- Minimum weight in Class
₹1,250.00₹1,299.00(Price is Exclusive of GST)Orange 11.1V 1300mAh 30C 3S Lithium Polymer Battery Pack
₹1,250.00₹1,299.00(Price is Exclusive of GST) -
6 Flexible Arms Soldering Station With Swiveling Alligator Clip
Features :
- Built-in Trays for components and screws.
- 6 flexible arms each with a large swiveling alligator clip.
- 6+1 pockets in beautifully base to hold loose components.
- 6 Silicon clip tips for the ultimate heat resistance.
- 6 Removable feet for a stable standalone operation.
- Integrates perfectly with Panavise vices and base mounts.
₹1,249.00₹1,307.00(Price is Exclusive of GST)6 Flexible Arms Soldering Station With Swiveling Alligator Clip
₹1,249.00₹1,307.00(Price is Exclusive of GST) -
₹1,244.00 (Price is Exclusive of GST)
Orange 7.4V 2200mAh 30C 2S Lithium Polymer Battery Pack
₹1,244.00 (Price is Exclusive of GST) -
Pro-Range 11.1V 1500mAh 40C 3S Lithium Polymer Battery Pack
- Model No: Pro-Range 1500/3S-40C
- Voltage : 11.1V
- Constant Discharge : 40C
- Max discharge : 50C (10 sec)
- Dimensions : 74 x 34 x 24 (L x W x H)(mm )
- Weight : 120 gm
- Charge Rate : 1-3C Recommended, 5C Max
- Good Temperature Control.
- Minimum weight in Class
₹1,236.00 (Price is Exclusive of GST)Pro-Range 11.1V 1500mAh 40C 3S Lithium Polymer Battery Pack
₹1,236.00 (Price is Exclusive of GST) -
Waveshare 320×240 Resistive Touch LCD Display (2.8 Inch)
Features:
- Onboard touch controller, smoother touch experience than solutions that directly use AD pins for touching.
- SPI interface requires a few pins.
- Programmable backlight control, power saving.
- Comes with development resources and a manual (examples for STM32/AVR/PIC).
₹1,220.00 (Price is Exclusive of GST)Waveshare 320×240 Resistive Touch LCD Display (2.8 Inch)
₹1,220.00 (Price is Exclusive of GST)
