-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
- “Servo Motor S3003” already exists in your wishlist
-
SPDT ON-Off 3 Pin 2 Position Slide Switch 0.3A
- This is a mountable SPDTÂ switch great for use as a general control switch. The pins are spaced by 3.7mm (0.14″).
- This switch has two handy 2mm mounting holes on each side of the actuator, making it easy to install while providing a discreet slide switch for your next project.
- It is rated for 300mA at 125VAC
₹4.00 (excl. GST)SPDT ON-Off 3 Pin 2 Position Slide Switch 0.3A
₹4.00 (excl. GST) -
14 Pin IC Base – DIP IC Socket Connector
- Product type: IC base
- Function: to easy insert, remove and reinsert the programmable chips and ICs in the PCD and neglect the component damage because of heat during soldering
- Number of pins: 14
- Package contains: 5 x 14 pin IC base
₹5.00 (excl. GST)14 Pin IC Base – DIP IC Socket Connector
₹5.00 (excl. GST) -
16 Pin IC Base – DIP IC Socket Connector
- Product type: IC base
- Function: to easy insert, remove and reinsert the programmable chips and ICs in the PCD and neglect the component damage because of heat during soldering
- Number of pins: 16
- Package contains: 5 x 16 pin IC base
₹5.00 (excl. GST)16 Pin IC Base – DIP IC Socket Connector
₹5.00 (excl. GST) -
18 Pin IC Base – DIP IC Socket Connector
- Product type: IC base
- Function: to easy insert, remove and reinsert the programmable chips and ICs in the PCD and neglect the component damage because of heat during soldering
- Number of pins: 18
- Package contains: 5 x 18 pin IC base.
₹5.00 (excl. GST)18 Pin IC Base – DIP IC Socket Connector
₹5.00 (excl. GST) -
PBT Connector Terminal Block 2 Pin
- 5.08mm pitch.
- Pin header: Tin plated brass.
- Contacts: Nickel plated brass.
- Strong, compact, lightweight.
- Heat resistant.
₹5.00 (excl. GST)PBT Connector Terminal Block 2 Pin
₹5.00 (excl. GST) -
₹5.00 (excl. GST)RGB 5mm Light Emitting Diode (Red, Blue, Green LED)
₹5.00 (excl. GST) -
270k Ohm Resistors, 1/4 Watt, 5% (Pack of 5)
Features-
Resistance: 270K Ohm,
Power Rating: 1/4Watt,
Approximate Maximum Current:Â 1.1mA
₹5.00₹10.00(excl. GST)270k Ohm Resistors, 1/4 Watt, 5% (Pack of 5)
₹5.00₹10.00(excl. GST) -
1K ohm Resistor (Pack of 5)
Features-
Resistance: 1K Ohm,
Power Rating: 8 Watt,
Tolerance: 5 %
₹5.00₹10.00(excl. GST)1K ohm Resistor (Pack of 5)
₹5.00₹10.00(excl. GST) -
22pF 1206 Surface Mount Multilayer Ceramic Capacitor (Pack of 3)
Features:
- Supplied in tape on reel
- Nickel-barrier end termination
- RoHS compliant
- Halogen-free compliant
₹5.00 (excl. GST)22pF 1206 Surface Mount Multilayer Ceramic Capacitor (Pack of 3)
₹5.00 (excl. GST) -
220pF 1206 Surface Mount Multilayer Ceramic Capacitor– (pack of 5)
Features:
- Supplied in tape on reel
- Nickel-barrier end termination
- RoHS compliant
- Halogen Free compliant
₹5.00 (excl. GST)220pF 1206 Surface Mount Multilayer Ceramic Capacitor– (pack of 5)
₹5.00 (excl. GST) -
1uF (1000nF) 50V Capacitor 1206 SMD Package – (pack of 5)
Features:
- Supplied in tape on reel
- Nickel-barrier end termination
- RoHS compliant
- Halogen Free compliant
₹5.00 (excl. GST)1uF (1000nF) 50V Capacitor 1206 SMD Package – (pack of 5)
₹5.00 (excl. GST) -
1X40 Right Angle Female Header Berg Strip
- Connector: Pin Header
- Connector type: Pin Strips female
- Number of pins: 40
- Pin Length: 12mm.
- Pitch: 2.54mm.
₹6.00₹7.00(excl. GST)1X40 Right Angle Female Header Berg Strip
₹6.00₹7.00(excl. GST)
