No products in the cart.
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹390.00 (Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (Price is Exclusive of GST)
Pro-Range 11.1V 10000mAh 35C 3S Lithium Polymer Battery Pack
- Model No: Pro-Range 10000 3S
- Voltage: 11.1V
- Max Continuous Discharge: 35C
- Balance Plug: JST-XH
- Discharge Plug: XT-60
₹7,778.00 (Price is Exclusive of GST)Pro-Range 11.1V 10000mAh 35C 3S Lithium Polymer Battery Pack
₹7,778.00 (Price is Exclusive of GST)Pro-Range 11.1V 4500mAh 35C 3S Lithium Polymer Battery Pack
- Model No: Pro-Range 4500 3S
- Voltage: 11.1V
- Max Continuous Discharge: 35C
- Balance Plug: JST-XH
- Discharge Plug: XT-60
₹3,244.00 (Price is Exclusive of GST)Pro-Range 11.1V 4500mAh 35C 3S Lithium Polymer Battery Pack
₹3,244.00 (Price is Exclusive of GST)Pro-Range 11.1V 1300mAh 40C 3S Lithium Polymer Battery Pack
- Model No : Pro-Range 1300 3S-40C
- Capacity: 1300 mAh.
- Max Burst Discharge: 50C (10sec)
- Max Continuous Discharge : 40C
- Discharge Plug: XT60
- Charge Rate : 1-3 C Recommended, 5 C Max.
- weight : 110 gm.
₹1,264.00 (Price is Exclusive of GST)Pro-Range 11.1V 1300mAh 40C 3S Lithium Polymer Battery Pack
₹1,264.00 (Price is Exclusive of GST)Pro-Range 11.1V 6200mAh 40C 3S Lithium Polymer Battery Pack
- Model No. ORANGE 6200/3S-40C
- Voltage: 11.1V
- Constant Discharge: 40C
- Max Discharge : 50C (10 sec)
- The Orange LiPo battery has matched resistance.
- Good Temperature Control.
- Minimum weight in Class
₹4,407.00 (Price is Exclusive of GST)Pro-Range 11.1V 6200mAh 40C 3S Lithium Polymer Battery Pack
₹4,407.00 (Price is Exclusive of GST)Pro-Range 11.1V 850mAh 30C 3S Lithium Polymer Battery Pack
- Model No : PRO-RANGE 850/ 3S-30C
- Capacity: 850 mAh.
- Max Burst Discharge: 60 C(51 A).
- Max Continuous Discharge : 30 C (25.5 A).
- Discharge Plug: T-Connector Female.
- Charge Rate : 1-3 C Recommended, 5 C Max.
₹902.00 (Price is Exclusive of GST)Pro-Range 11.1V 850mAh 30C 3S Lithium Polymer Battery Pack
₹902.00 (Price is Exclusive of GST)Pro-Range 11.1V 1000mAh 40C 3S Lithium Polymer Battery Pack
- Model No: Pro-Range 1000/3S-40C
- Weight: 85 gm.
- Voltage : 11.1 V.
- Dimensions : 17 x 34 x 72(mm ).
- Max Continuous Discharge : 40 C(40 A).
- Balance Plug : JST-XH.
- Discharge Plug : XT-60.
₹1,082.00 (Price is Exclusive of GST)Pro-Range 11.1V 1000mAh 40C 3S Lithium Polymer Battery Pack
₹1,082.00 (Price is Exclusive of GST)Orange 11.1V 1500mAh 30C 3S Lithium Polymer Battery Pack
Model No: ORANGE 1500/3S-30CVoltage : 11.1VConstant Discharge : 30CMax discharge : 40C (10 sec)Dimensions : 74 x 34 x 23 (LxWxH)(mm )Weight : 115 gm
Charge Rate : 1-3C Recommended, 5C Max₹1,173.00 (Price is Exclusive of GST)Orange 11.1V 1500mAh 30C 3S Lithium Polymer Battery Pack
₹1,173.00 (Price is Exclusive of GST)Pro-Range 11.1V 1500mAh 40C 3S Lithium Polymer Battery Pack
- Model No: Pro-Range 1500/3S-40C
- Voltage : 11.1V
- Constant Discharge : 40C
- Max discharge : 50C (10 sec)
- Dimensions : 74 x 34 x 24 (L x W x H)(mm )
- Weight : 120 gm
- Charge Rate : 1-3C Recommended, 5C Max
- Good Temperature Control.
- Minimum weight in Class
₹1,236.00 (Price is Exclusive of GST)Pro-Range 11.1V 1500mAh 40C 3S Lithium Polymer Battery Pack
₹1,236.00 (Price is Exclusive of GST)Pro-Range 11.1V 3300mAh 25C 3S Lithium Polymer Battery Pack
- Model No: Pro-Range 3300/3S-25C
- Weight : 260 g
- Voltage : 11.1V
- Dimensions : 136 x 43 x 20(mm )
- Balance Plug : JST-XH
- Discharge Plug : XT-60
₹2,128.00 (Price is Exclusive of GST)Pro-Range 11.1V 3300mAh 25C 3S Lithium Polymer Battery Pack
₹2,128.00 (Price is Exclusive of GST)Pro-Range 11.1V 3300mAh 35C 3S Lithium Polymer Battery Pack
- Model No: Pro-Range 3300/3S 35C
- Weight : 260g
- Voltage : 11.1V
- Dimensions : 134 x 43 x 20(mm )
- Balance Plug : JST-XH
- Discharge Plug : XT-60
₹1,989.00 (Price is Exclusive of GST)Pro-Range 11.1V 3300mAh 35C 3S Lithium Polymer Battery Pack
₹1,989.00 (Price is Exclusive of GST)Orange 7.4V 8000mAh 35C 2S Lithium Polymer Battery Pack
- Model No: ORANGE 8000mAh 2S
- Voltage: 7.4V
- Max Continuous Discharge: 35C
- Discharge Plug: XT-60
- Dimension: 18 x 6 x 2cm
- Weight: 403g
₹4,033.00 (Price is Exclusive of GST)Orange 7.4V 8000mAh 35C 2S Lithium Polymer Battery Pack
₹4,033.00 (Price is Exclusive of GST)472 1KV HIGH VOLTAGE CERAMIC DISC CAPACITOR
Features:
- Capacitance has linear temperature coefficient
- Capacitance high stability
- RoHS Compliance
- Halogen free products are available
- Low lost at wide range of frequency
- The stability of the capacitor is dependent on the ceramic dielectric
- Does not vary much with Temperature
₹2.00 (Price is Exclusive of GST)472 1KV HIGH VOLTAGE CERAMIC DISC CAPACITOR
₹2.00 (Price is Exclusive of GST)
