-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
-
10mm LDR Sensor Photoresistor Photo Cell 50-100k – GL10539
Feature:
- Epoxy encapsulation
- Good reliability
- Small size
- High sensitivity
- Fast response
- Good spectral characteristics
₹33.00 (excl. GST)10mm LDR Sensor Photoresistor Photo Cell 50-100k – GL10539
₹33.00 (excl. GST) -
10mm Spiral Wrapping Band Black 10M for Wires
Features :
- Extremely versatile in flexibility
- Designed to Hold and Protect Cables, Harnesses, and Hoses
- Allows Flexibility while Providing Secure Bundling
- Quick and Easy to Install due to Flexible Polyethylene Construction
- Easily removed and re-applied
- Thick wall Provides Greater Resistance to Abrasions and Vibrations
- Breakout at Any Point
₹120.27 (excl. GST)10mm Spiral Wrapping Band Black 10M for Wires
₹120.27 (excl. GST) -
10mm Square Flange Bushing Linear Bearing LMK10LUU
Features :
- Smooth moving
- Low friction
- High rigid
- Long life
- Economical and easy to maintain.
₹206.00 (excl. GST)10mm Square Flange Bushing Linear Bearing LMK10LUU
₹206.00 (excl. GST) -
10uF (10000nF) 50V Capacitor – 1206 SMD Package – (pack of 5)
Features:
- Supplied in tape on reel
- Nickel-barrier end termination
- RoHS compliant
- Halogen Free compliant
₹35.00 (excl. GST)10uF (10000nF) 50V Capacitor – 1206 SMD Package – (pack of 5)
₹35.00 (excl. GST) -
11.1V 2200mAh Lipo Lithium Polymer Rechargeable Battery
- Lithium-Polymer (Li-Po) Battery For RC, Planes and Drones
- 3 Cell (3S) 11.1V 2200MAH 35C
- Very Small in size and weight
- Connector Plug: XT60 Plug connector
- Discharge Current: 35*2200maH = 77Amp
₹1,500.00 (excl. GST)11.1V 2200mAh Lipo Lithium Polymer Rechargeable Battery
₹1,500.00 (excl. GST) -
11.1V 5400mAH LiPo Battery
- This is a 11.1V LiPo battery pack with a capacity of 5400mAh.
- It produces a maximum charging rate of 5C and maximum discharging rate of 40C.
- Experts recommend to maintain a charging rate of 1-3C for the5400mAh LiPo battery.
- Suitable for most RC models such as remote control racing drone, helicopter, car, boat, etc.
- Compatible with balance charger. Package Included : 1 x 5400mah lipo Battery
₹4,000.00 (excl. GST)11.1V 5400mAH LiPo Battery
₹4,000.00 (excl. GST) -
12 in 1 DIY Sensor Kit
Sensors Included:
PIR Motion Sensor HCSR501, Touch Sensor, Rain Sensor, Hear beat Sensor, Flame Sensor, Soil Moisture Sensor, Sound Sensor, Ultrasonic Sensor HCSR04, Temperature and Humidity Sensor DHT11, LDR Sensor, IR Sensor, Tilt Sensor.
₹550.00₹1,100.00(excl. GST)12 in 1 DIY Sensor Kit
₹550.00₹1,100.00(excl. GST) -
12 Volt LED Light Strips Aluminum for Holiday/Home/Party/Indoor/Outdoor Decoration
12 Volt LED Light Strips
- Very suitable for indoor outdoor lighting and decor
- the working voltage is 12V
- Super bright and Safe to use
- It is touchable
- Every 1-LED cuttable without damaging the rest strip, to help you meet different size need
₹140.00 (excl. GST) -
1200W DC-DC Boost Module 20A Step-up Boost Convertor 8-60V to 12-80V Adjustable Power Supply
- 1200W DC to DC step-up power supply module for electronic equipment with adjustable power supply module where you can set the output voltage according to device.
- Input and output are designed with screw terminals for convenient wire connection and disconnection.
- Input voltage: 8-60V
- Output voltage: 12-80V continuously adjustable
₹795.00 (excl. GST) -
12mm Square Flange Bushing Linear Bearing LMK12LUU
Features :
- Smooth moving
- Low friction
- High rigid
- Long life
- Economical and easy to maintain.
₹206.00 (excl. GST)12mm Square Flange Bushing Linear Bearing LMK12LUU
₹206.00 (excl. GST) -
12mm Square Flange Bushing Linear Bearing LMK12LUU
Features :
- Smooth moving
- Low friction
- High rigid
- Long life
- Economical and easy to maintain.
₹206.00 (excl. GST)12mm Square Flange Bushing Linear Bearing LMK12LUU
₹206.00 (excl. GST) -
12V 2 Channel Relay Module
1.Trigger Voltage(VDC):12
2.Trigger Current (MA):20
3.Switching Voltage (VAC):250@10A
4.Switching Voltage (VDC):30@10A
5.Operating Temperature (°C):-40 to 85
6.Opt. Relative Humidity(RH):20% ～ 85%
7.Storage condition (℃):-65 to 125
₹65.00 (excl. GST)12V 2 Channel Relay Module
₹65.00 (excl. GST)
