No products in the cart.
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹390.00 (Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (Price is Exclusive of GST)
RFID 13.56MHz Card (Pack of 5)
Features:
- Contactless transmission of data and supply energy (no battery needed)
- Anticollision
- EEPROM
- 1Kbit, organized in 16 sectors, each district two passwords
- User definable access conditions for each memory block
- Data retention of 10 years.
- Write endurance 100 000 cycles
- Security
- Individual key set per sector (per application) to support multi-application with key hierarchy
- A unique serial number for each device
- Transport key protects access to EEPROM on-chip delivery
₹60.00 (Price is Exclusive of GST)RFID 13.56MHz Card (Pack of 5)
₹60.00 (Price is Exclusive of GST)- ₹5.00 (Price is Exclusive of GST)
RGB 5mm Light Emitting Diode (Red, Blue, Green LED)
₹5.00 (Price is Exclusive of GST) - ₹45.00
₹60.00(Price is Exclusive of GST)Jumper Wire Male to Female 20 cm (Set of 40 Piece)
₹45.00₹60.00(Price is Exclusive of GST) XT90 Male Connector with Housing (1pc)
Specifications and Features:
- Metal connector size: 4.5mm
- Housing shape provides protection against shorting and reverse polarity
- Can accept up to 8AWG wires
- Semicircular solder terminals make it easy to install wires
- Able to sustain 90A+ continuous current
₹36.00 (Price is Exclusive of GST)XT90 Male Connector with Housing (1pc)
₹36.00 (Price is Exclusive of GST)- ₹325.00 (Price is Exclusive of GST)
Motion Sensor Power Saver Auto On and Off Pir Switch
₹325.00 (Price is Exclusive of GST) LDR (Light Dependent Resistor) Sensor 5mm high quality
- Diameter: 5mm
- No. of Pins: 2
- Type of Mounting: PCB Through Hole
- Maximum Operating Temperature: +800°C (Approx.)
- Dark resistance:1-20 Mohm
₹9.00 (Price is Exclusive of GST)LDR (Light Dependent Resistor) Sensor 5mm high quality
₹9.00 (Price is Exclusive of GST)Durable Rubber Tire Yellow BO Motor Wheel
- Tire with sponge liner for more strength
- With upgraded tire tread for greater friction
- New design wheel for better combination with the motor
- Diameter: 65 mm
- Width : 28 mm
- The material of Wheel: High-strength plastic
- The material of Tyre: Rubber
- Color: Yellow
₹28.00 (Price is Exclusive of GST)Durable Rubber Tire Yellow BO Motor Wheel
₹28.00 (Price is Exclusive of GST)USB 2.0 Cable Type A/B for Arduino UNO
- Fully compatible with the PC.
- Molded strain relief and PVC over-molding to ensure a lifetime of error-free data transmissions.
- Aluminum under mold shield helps meet FCC requirements on KMI/RFI interference.
- Foil and braid shield complies with fully rated cable specifications reducing EMI/FRI interference.
₹18.00 (Price is Exclusive of GST)USB 2.0 Cable Type A/B for Arduino UNO
₹18.00 (Price is Exclusive of GST)BO Motor Wheel
- Tire with sponge liner for more strength
- With upgraded tire tread for greater friction
- New design wheel for better combination with the motor
- Diameter: 65 mm
- Width : 28 mm
- The material of Wheel: High-strength plastic
- The material of Tyre: Rubber
- Color: Blue
₹9.00 (Price is Exclusive of GST)BO Motor Wheel
₹9.00 (Price is Exclusive of GST)Jumper Wire Male to Male 20 cm (Set of 40 Piece)
40 pc male to male
- Each cable length about 20cm or 8-inch
- The male ends meant for insertion into standard 0.1 inch (2.54mm) female sockets and the female ends are meant for insertion onto standard 0.1 inch (2.54mm) male headers
- Suitable for Arduino breadboard kit project, PCB project, pc motherboard, etc
- Through the pin connection, without welding, fit for fast circuit test.
₹45.00₹60.00(Price is Exclusive of GST)Jumper Wire Male to Male 20 cm (Set of 40 Piece)
₹45.00₹60.00(Price is Exclusive of GST)IR Sensor Module Infrared based for Proximity/Object Detection
- Power: 3.3V ~ 5V
- Mounting holes size: 3mm
- Detection range: 2cm ~ 30cm (depending on the obstacle’s color, farthest for white)
- Detection angle: 35°
- LM393 voltage comparator
- Recommended environment: indoor, to avoid the sunshine effect
₹19.00₹24.00(Price is Exclusive of GST)IR Sensor Module Infrared based for Proximity/Object Detection
₹19.00₹24.00(Price is Exclusive of GST)MAX232 Dual Driver Converter IC
- Operates With Single 5V Power Supply
- LinBiCMOS Process Technology
- Two Drivers and Two Receivers
- ±30-V Input Levels
- Low Supply Current . . . 8 mA Typical
- Meets or Exceeds TIA/EIA-232-F and ITURecommendation V.28
- Designed to be Interchangeable WithMaxim MAX232
₹20.00 (Price is Exclusive of GST)MAX232 Dual Driver Converter IC
₹20.00 (Price is Exclusive of GST)