-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹638.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹638.00(Price is Exclusive of GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹264.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹264.00 (Price is Exclusive of GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST) -
ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
- This DHT11 temperature and humidity sensor shield is specially designed for ESP8266 ESP-01 ESP-01S development board.
- On-board 8pin socket enable you plug the wifi transceiver to the board directly perfect for DIY your wireless temperature/humidity webserver system.
- Working Voltage: DC 3.7 – 12V
- The weight of about 10 grams
- Package Included: 1 X DHT11 Humidity Temperature Sensor
₹130.00 (Price is Exclusive of GST)ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
₹130.00 (Price is Exclusive of GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹207.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹207.00 (Price is Exclusive of GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)
-
High Sensitivity Sound Sensor Module
- Main chip: LM393, Electret condenser microphone
- Working voltage:Â DC 3.3-5V
- Induction distance is 0.5M
- Signal output Indication
- Single channel signal output
- The output effective signal is low level.
.
₹35.00₹40.00(Price is Exclusive of GST)High Sensitivity Sound Sensor Module
₹35.00₹40.00(Price is Exclusive of GST) -
DT830D Small Digital Multimeter
- A portable, general purpose digital volt meter multimeter to test wires, batteries, cells, fuses and other electrical components
- Includes large, easy-to-read LCD screen and accurately measures resistance, current and voltage with maximum reading up to 1999
- Red and black leads to test electrical system components including diodes, transistors, wires, fuses
- Checks continuity of wires, fuses and electrical system components
- Built-in overload protector keeps the meter from any possible damage
- Digital AC/DC millimeter with diode and transistor test function
₹140.00 (Price is Exclusive of GST)DT830D Small Digital Multimeter
₹140.00 (Price is Exclusive of GST) -
₹277.00 (Price is Exclusive of GST)
Official Raspberry Pi 4 Case-Black-Grey
₹277.00 (Price is Exclusive of GST) -
₹257.00 (Price is Exclusive of GST)
Official Raspberry Pi 4 Case-Red-White
₹257.00 (Price is Exclusive of GST) -
₹383.00 (Price is Exclusive of GST)
Official Raspberry Pi 5 Active Cooler
₹383.00 (Price is Exclusive of GST) -
₹965.00 (Price is Exclusive of GST)
EBYTE E32-433T30D-V8 LoRa 433MHz UART IoT Long Range Wireless Transceiver Transmitter Receiver EBYTE E32-433T30D V8 Module 1W SMA Antenna
₹965.00 (Price is Exclusive of GST) -
ADS1115 16-Bit ADC- 4 Channel with Programmable Gain Amplifier
- Wide Supply Range: 2.0v To 5.5v
- Low Current Consumption
- Continuous Mode: Only 150µa Single-shot
- Auto Shut-down
- Programmable Data Rate: 8SPS to 860SPS
- It has Internal low-drift voltage reference
₹90.00 (Price is Exclusive of GST)ADS1115 16-Bit ADC- 4 Channel with Programmable Gain Amplifier
₹90.00 (Price is Exclusive of GST) -
₹2,795.00 (Price is Exclusive of GST)SmartElex Bharat AI Innovators Kit Powered by Arduino | UNO EK R4 WiFi
₹2,795.00 (Price is Exclusive of GST) -
Pro-Range NEMA17 PR42HS40-1204AF-02 4.2kg-cm Stepper Motor-D Type Shaft
- Model: NEMA17 PR42HS40-1204AF-02
- Shaft Type: D Type
- Step Angle: 1.8
- Holding Torque: 4.2kg-cm
- The input pulse decides the rotation angle of the motor.
- High accuracy of around 3 to 5% a step.
- Provides good starting, stopping, and reversing.
- Control of this motor is less costly because of the exclusion of complex control circuitry.
- The speed is proportional to the frequency of the input pulses.
₹540.00 (Price is Exclusive of GST)Pro-Range NEMA17 PR42HS40-1204AF-02 4.2kg-cm Stepper Motor-D Type Shaft
₹540.00 (Price is Exclusive of GST) -
Electronic Metal Detector DIY Kit
- Operating Voltage: 3-5VDC
- Operating Current: 40mA
- DIY Kit
- Comes With all components.
- Comes with all the components
- Good Quality PCB
- Onboard detection coil
₹92.00 (Price is Exclusive of GST)Electronic Metal Detector DIY Kit
₹92.00 (Price is Exclusive of GST) -
ESP32-CAM-MB WIFI BLUETOOTH DEVELOPMENT BOARD WITH OV2640 CAMERA MICRO USB CONNECTION TO SERIAL
- The heart of the ESP32-CAM-MB is the ESP32
- WiFi and Bluetooth Connectivity
- OV2640 Camera Module
- Micro USB Connection
- I/O Pins and GPIO Headers
- MicroSD Card Slot
₹527.00 (Price is Exclusive of GST)ESP32-CAM-MB WIFI BLUETOOTH DEVELOPMENT BOARD WITH OV2640 CAMERA MICRO USB CONNECTION TO SERIAL
₹527.00 (Price is Exclusive of GST) -
PANASONIC NCR18650GA 3300mAh (3c) LI-ION BATTERY
- Size: 18650.
- Chemistry: NCR
- Nominal Capacity (min.) (mAh): 3350
- Nominal Capacity (typ.) (mAh): 3300
- Nominal Voltage: 3.6V
- Discharge: 10A Max Continuous
₹503.00 (Price is Exclusive of GST)PANASONIC NCR18650GA 3300mAh (3c) LI-ION BATTERY
₹503.00 (Price is Exclusive of GST)
