-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹638.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹638.00(Price is Exclusive of GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹264.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹264.00 (Price is Exclusive of GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST) -
ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
- This DHT11 temperature and humidity sensor shield is specially designed for ESP8266 ESP-01 ESP-01S development board.
- On-board 8pin socket enable you plug the wifi transceiver to the board directly perfect for DIY your wireless temperature/humidity webserver system.
- Working Voltage: DC 3.7 – 12V
- The weight of about 10 grams
- Package Included: 1 X DHT11 Humidity Temperature Sensor
₹130.00 (Price is Exclusive of GST)ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
₹130.00 (Price is Exclusive of GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹207.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹207.00 (Price is Exclusive of GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)
-
DC PWM Motor Speed Controller
- The maximum output power:30W
- Input supply voltage:1.8V-15VDC
- The Maximum continuous output current:2A
- Duty Cycle adjustable:0%-100%
₹65.00 (Price is Exclusive of GST)DC PWM Motor Speed Controller
₹65.00 (Price is Exclusive of GST) -
Desoldering Pump Tool
- One-handed solder sucker with powerful suction whether you are right or left-handed, you can using the desoldering pump by just cocking it and pressing the trigger button with one hand when you are ready, the desoldering pump designed with double ring double open and “vacuum” button, which make the sucking power awesome
₹65.00 (Price is Exclusive of GST)Desoldering Pump Tool
₹65.00 (Price is Exclusive of GST) -
NRF24L01 Wireless Transceiver Module-2.4GHz
The embedded baseband protocol engine (Enhanced ShockBurst) is based on packet communication and supports various modes from manual operation to advanced autonomous protocol operation.
Features :
- Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability,
- Particularly suitable for industrial control applications.
- 125 Channels, Multi-point communication, and frequency hopping to meet the communication needs
- Built-in hardware CRC error detection, Multipoint communication address control.
- Low-power 1.9 ~ 3.6V, only 1uA on Power down mode
- Built-in 2.4Ghz antenna
- Available software to set the address only received local Address when output data(Provide interrupt instruction), can be directly connected to a variety of microcontrollers, Software programming is very convenient.
- Built-in voltage regulator
- Standard DIP Pitch Interface for embedded applications.
₹65.00 (Price is Exclusive of GST)NRF24L01 Wireless Transceiver Module-2.4GHz
₹65.00 (Price is Exclusive of GST) -
RFID Card 125kHz – Pack of 5
Features:
- Contactless transmission of data and supply energy (no battery needed)
- Anti-collision
- EEPROM
- 1Kbit, organized in 16 sectors, each district two passwords
- User definable access conditions for each memory block
- Data retention of 10 years.
- Write endurance 100 000 cycles
- Security
- Individual key set per sector (per application) to support multi-application with key hierarchy
- A unique serial number for each device
- Transport key protects access to EEPROM on-chip delivery
₹65.00 (Price is Exclusive of GST)RFID Card 125kHz – Pack of 5
₹65.00 (Price is Exclusive of GST) -
Round Plastic And Rubber Robot Track White Wheel 100×40 MM
Applications:
- Light robotics applications
- Remotely Operated Robotic
- Vehicles and Belt/Tank style robot
₹65.00 (Price is Exclusive of GST)Round Plastic And Rubber Robot Track White Wheel 100×40 MM
₹65.00 (Price is Exclusive of GST) -
Sensor Shield V5 Expansion Board For Arduino
- Retain the merits of the V4.0 version
- Laminated design
- PCB immersion gold processing technology
- IIC interface
- Bluetooth module communication interface
- SD card module communication interface
- APC220 wireless rf modules communication interface
- RB URF v1.1 ultrasonic sensors interface
- 12864 LCD string of line and parallel interface
- 32 servo controller interface
₹65.00₹70.00(Price is Exclusive of GST)Sensor Shield V5 Expansion Board For Arduino
₹65.00₹70.00(Price is Exclusive of GST) -
74LS27 (or 7427) IC – NOR Gate – 3 Input
74LS27
- Wide operating conditions
- Large operating voltage range
- Outputs directly interface to CMOS,NMOS, and TTL
₹65.00 (Price is Exclusive of GST)74LS27 (or 7427) IC – NOR Gate – 3 Input
₹65.00 (Price is Exclusive of GST) -
3*6*2.5 mm SMD Tactile Switch (Pack of 20)
3*6*2.5 mm SMD Tactile Switch
- Used in the fields of electronic products, household appliances and more.
-
This light touch switch is waterproof, prevent oil, anti-pollution, anti-static interference.
-
High precision mechanism design offers acute operation and long service life.
-
Compact and lightweight, easy to carry and dismantling.
-
Good electrical Conductivity.
₹66.00 (Price is Exclusive of GST)3*6*2.5 mm SMD Tactile Switch (Pack of 20)
₹66.00 (Price is Exclusive of GST) -
GT2 Timing Belt 400mm Width-6mm Closed-Loop Rubber Belt for 3D Printer
- Pitch: 2mm
- Material: Neoprene Rubber With Fiberglass Core
- Width: 6mm
- Total Length: 400mm
- Belt Height: 1.52 mm
- Tooth Height: 0.76mm
- Shape: Closed Loop
₹66.00 (Price is Exclusive of GST)GT2 Timing Belt 400mm Width-6mm Closed-Loop Rubber Belt for 3D Printer
₹66.00 (Price is Exclusive of GST) -
LM35 TO-92-3 Board Mount Temperature Sensors
- Calibrated directly in Celsius (Centigrade)
- Linear + 10.0 mV/C scale factor
- 5C accuracy guaranteeable (at +25C)
- Rated for full −55 to +150C range
- Suitable for remote applications
- Low cost due to wafer-level trimming
- Operates from 4 to 30 volts
- Less than 60 µA current drain
- Low self-heating, 0.08C in still air n Nonlinearity only ±1⁄4C typical
- Low impedance output, 0.1 for 1 mA load
₹66.20 (Price is Exclusive of GST)LM35 TO-92-3 Board Mount Temperature Sensors
₹66.20 (Price is Exclusive of GST) -
LM741 Op-amp IC
- Two Independent, High-Gain, Frequency Compensated Op-Amps
- Input Offset Voltage: 2 mV
- Input Offset Current: 20 nA
- Input Bias Current: 80 nA
- Supply Current: 1.7 mA
₹66.20 (Price is Exclusive of GST)LM741 Op-amp IC
₹66.20 (Price is Exclusive of GST) -
7812 Voltage Regulator IC
- Thermal Overload Protection
- Short-circuit Protection
- Output Transition SOA Protection
- 4% Output Voltage Tolerance
- Guaranteed in Extended Temperature Range
- Applications: Power Management
₹67.00 (Price is Exclusive of GST)7812 Voltage Regulator IC
₹67.00 (Price is Exclusive of GST)
