No products in the cart.
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹390.00 (Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (Price is Exclusive of GST)
TM1638 Button Digital LED Display Module
- Use TM1638 digital tube drive chip to drive a common cathode LED digital tube.
- Can be extended to 3 * 8 buttons, led digital tube and can be controlled separately.
- Support 8 brightness control, led digital tube and use the same brightness.
- Support cascading up to 6 of the same module.
- 8 LED, 8-bit digital tube and 8 buttons, common cathode LED digital tube, such as STC microcontroller can be directly connected.
₹122.00 (Price is Exclusive of GST)TM1638 Button Digital LED Display Module
₹122.00 (Price is Exclusive of GST)- ₹125.00 (Price is Exclusive of GST)
8051 Quick Starter Development Board
₹125.00 (Price is Exclusive of GST) 
L293D Motor Driver Shield Expansion Board
- Drive 4 DC motors with speed and direction control
- Drive 2 stepper motors
- Drive 2 servo motors
- 4.5 – 25V motor voltage range
- 1.2A peak current per channel (600mA continuous)
₹125.00 (Price is Exclusive of GST)L293D Motor Driver Shield Expansion Board
₹125.00 (Price is Exclusive of GST)18650 Li-Ion Rechargeable Battery – 3.7V 3000mAH
Features:
1. High quality and durable
2. Provide excellent continuous power sources to your device
3. High energy density, large capacity and long life battery
4. No memory effect, recharge up to many times
5. Rechargeable type and professional design, safe and convenient to use₹125.00 (Price is Exclusive of GST)18650 Li-Ion Rechargeable Battery – 3.7V 3000mAH
₹125.00 (Price is Exclusive of GST)Esp8266-01 Serial WIFI Wireless Transceiver Module
- 802.11 b/g/n Standards
- Wi-Fi Direct (P2P), soft-AP
- 1MB Flash Memory
- Integrated low power 32-bit CPU could be used as an application processor
- A-MPDU & A-MSDU aggregation & 0.4ms guard interval
- Wake up and transmit packets in < 2ms
- Standby power consumption of < 1.0mW (DTIM3)
₹125.00 (Price is Exclusive of GST)Esp8266-01 Serial WIFI Wireless Transceiver Module
₹125.00 (Price is Exclusive of GST)MFRC-522 RC522 RFID Module
- Integrated MF RC522
- 13.56MHz contactless communication card chip.
- The low-voltage, low-cost, small size of the non-contact card chip to read and write.
- Working current：13 – 26mA / DC 3.3V
- Standby current：10 – 13mA / DC 3.3V
- Sleep current：<80uA
- Peak current：<30mA
- Working frequency：13.56MHz
- Card reading distance ：0～60mm （Mifare1 card）
₹125.00 (Price is Exclusive of GST)MFRC-522 RC522 RFID Module
₹125.00 (Price is Exclusive of GST)RF Wireless Transmitter Receiver Module (Red) – 433 MHz
Features:
- Transmitter Module employs a crystal-stabilized oscillator, ensuring accurate frequency control for best range performance
- Range in open space (Standard Conditions) : 100 Meters
- No requirement of external RF components except Antenna
- RX Supply Current: 3.5 mA. RX Typical Sensitivity: 105 Dbm
- Low Power Consumption
₹125.00 (Price is Exclusive of GST)RF Wireless Transmitter Receiver Module (Red) – 433 MHz
₹125.00 (Price is Exclusive of GST)Automatic Dawn to Dusk Sensor Board with Relay and LDR for Solar Based Street Light
Features:
LDR Based Sensor
On Board 12V Relay to Control Solar street Light
Relay will automatically turn ON in Low lighting Condition and will turn OFF when lighting is adequate
Pefect to control Solar based Garden light or Street light
Works best in open Natural Light Source₹125.00 (Price is Exclusive of GST)Automatic Dawn to Dusk Sensor Board with Relay and LDR for Solar Based Street Light
₹125.00 (Price is Exclusive of GST)Raspberry Pi 3 Official ABS Case Box
The Raspberry Pi 3 Official Case for Raspberry Pi 3 Model B only Red/White is a 5-part Enclosure for Raspberry Pi 2 Model B and Raspberry Pi B+. Official case for the Raspberry Pi from the Raspberry Pi Foundation.This case has a very attractive strawberry red and white color. It is made up of ABS.
₹125.00 (Price is Exclusive of GST)Raspberry Pi 3 Official ABS Case Box
₹125.00 (Price is Exclusive of GST)Soldering Iron Temperature-280 to 450 Degree Celsius
Features :
- The workhorse of electronic industries. The highest and the most popular product.
- General purpose for all electronic applications.
- Attains full operating Temperature within a seconds.
- Slide on a Replaceable tip.
- Cool Grip Insulating Nylon Handle.
- High Quality Built Material.
- Hook provided to Hang.
- Portable, Lightweight and easy to use.
- With Durable heating element designed for long Life.
₹125.00 (Price is Exclusive of GST)Soldering Iron Temperature-280 to 450 Degree Celsius
₹125.00 (Price is Exclusive of GST)Aluminum GT2 20 Tooth Timing Pulley 6.35mm Bore For 6mm Belt
FEATURES-
- Material: Aluminum.
- No. of teeth: 20.
- Outer Diameter: 16mm.
- Inner Diameter: 6.35mm.
- Length: 14 mm.
- Weight: 6 gm.
₹125.00 (Price is Exclusive of GST)Aluminum GT2 20 Tooth Timing Pulley 6.35mm Bore For 6mm Belt
₹125.00 (Price is Exclusive of GST)SG90 Continuous Rotation 360 Degree Servo Motor
Features :
- High resolution
- Accurate positioning
- Fast control response
- Constant torque throughout the servo travel range
- Excellent holding power
₹125.00 (Price is Exclusive of GST)SG90 Continuous Rotation 360 Degree Servo Motor
₹125.00 (Price is Exclusive of GST)
