-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST)
-
IRF540N (TO-220-3) MOSFET (Pack Of 2 ICs)
IRF540N (TO-220-3) MOSFET
- Drain to source voltage Vds is 100V
- Gate to source voltage is ±20V
- On Resistance Rds(on) of 44mohm at Vgs of 10V
- Power dissipation Pd of 130W at 25°C
₹40.00 (excl. GST)IRF540N (TO-220-3) MOSFET (Pack Of 2 ICs)
₹40.00 (excl. GST) -
IRS2104 PDIP-8 Gate Driver
IRS2104 PDIP-8 Gate Driver
Features:
- Floating channel designed for bootstrap operation
- Fully operational to +600 V
- Tolerant to negative transient voltage, dV/dt immune
- Gate drive supply range from 10 V to 20 V
- Undervoltage lockout
- 3.3 V, 5 V, and 15 V input logic compatible
- Cross-conduction prevention logic
- Internally set deadtime
- High-side output in phase with input
- Shutdown input turns off both channels
- Matched propagation delay for both channels
₹82.00 (excl. GST)IRS2104 PDIP-8 Gate Driver
₹82.00 (excl. GST) -
ISD1820 Sound/Voice Board Recording Module
Feature:
- Working voltage: 3 ~ 5V
- Board size:54 x 38 mm
- ISD1820 Sound/Voice Board Recording
- 100% Brand new and high-quality Board
- ISD1820 chip with an Onboard microphone.
₹135.00 (excl. GST)ISD1820 Sound/Voice Board Recording Module
₹135.00 (excl. GST) -
Johnson Geared Motor (Grade B) 10 RPM
- Base Motor RPM: 18000
- Operating Voltage: 6-18 V
- Rated Voltage: 12 V
- Rated Torque: 11.7 kg-cm
- Stall Torque: 46 kg-cm
- Gearbox Dimensions: 30×37 (LxW) mm
₹369.00 (excl. GST)Johnson Geared Motor (Grade B) 10 RPM
₹369.00 (excl. GST) -
Johnson Geared Motor (Grade B) 200 RPM
- Product: Johnson Geared Motor (Grade B) 200 RPM
- Rated Base Motor RPM: 18000
- Gear Material: Metal
- Rated Speed (RPM): 200
- Operating Voltage (VDC): 6 ~ 18
₹338.00 (excl. GST)Johnson Geared Motor (Grade B) 200 RPM
₹338.00 (excl. GST) -
Jumper Wire Female to Female 20 cm (Set of 40 Piece)
Features :
Compatible with 2.54mm spacing pin headers
40pcs chromatic color jump wire
High quality and in good working condition
Durable and reusable
Easy to install and use
A popular choice for construction or repair
Be used for the electronic project and Genuine Arduino product
Flexible Breadboard Jumper Cable Wire allows you to plug and unplug easily for prototyping.
₹45.00₹60.00(excl. GST)Jumper Wire Female to Female 20 cm (Set of 40 Piece)
₹45.00₹60.00(excl. GST) -
₹45.00
₹60.00(excl. GST)Jumper Wire Male to Female 20 cm (Set of 40 Piece)
₹45.00₹60.00(excl. GST) -
Jumper Wire Male to Male 20 cm (Set of 40 Piece)
40 pc male to male
- Each cable length about 20cm or 8-inch
- The male ends meant for insertion into standard 0.1 inch (2.54mm) female sockets and the female ends are meant for insertion onto standard 0.1 inch (2.54mm) male headers
- Suitable for Arduino breadboard kit project, PCB project, pc motherboard, etc
- Through the pin connection, without welding, fit for fast circuit test.
₹45.00₹60.00(excl. GST)Jumper Wire Male to Male 20 cm (Set of 40 Piece)
₹45.00₹60.00(excl. GST) -
Junior Hacksaw Blades – 12 inch
A pack of ten 150mm blades made from a strong but flexible carbon steel to ensure extra long life.
₹800.00 (excl. GST)Junior Hacksaw Blades – 12 inch
₹800.00 (excl. GST) -
KCX BT003 Bluetooth 4.2 Stereo Audio Receiver Wireless Module
- Operating Voltage: 3.3-5VDC
- Operating Current: 35mA
- Bluetooth Version: 4.2
- Stereo Channel Output
₹279.00 (excl. GST)KCX BT003 Bluetooth 4.2 Stereo Audio Receiver Wireless Module
₹279.00 (excl. GST) -
Key Display For AVR, Boards compatible | New 8-Bit Digital LED Tube 8-Bit TM638 Module | Robotics Science Project
- It only need to read the relevant register to send display data or test button so it save mcu resources effectively., Package contents: 1 key display module for avr arduino
- 8 bits, 8 keys, 8 leds, 8 digital tubes, common cathode led digital tube
- The advantage is only three io ports will be occupied when it drives
- Scm doesn’t need to work for scaning display and key scaning
₹150.00 (excl. GST) -
KK2.1.5 Flight Controller Board-Multi-Rotor LCD
- MCU : Atmega644 PA
- Gyro/Acc: MPU6050
- Auto-level: Yes
- Input Voltage: 4.8-6.0V
- AVR interface: standard 6 pin.
- Signal from Receiver: 1520us (5 channels).
- Signal to ESC: 1520us.
₹3,500.00 (excl. GST)KK2.1.5 Flight Controller Board-Multi-Rotor LCD
₹3,500.00 (excl. GST)
