No products in the cart.
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹390.00 (Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (Price is Exclusive of GST)
CP2102 USB 2.0 to TTL UART Serial convertor Module
Features:-
Stable and reliable chipset CP2102.
USB specification 2.0 compliant with full-speed 12Mbps.
Standard USB type A male and TTL 6pin connector.
6pins for 3.3V, RST, TXD, RXD, GND & 5V.
Baud rates: 300 bps to 1.5 Mbps
Byte receive buffer; 640 byte transmit buffer.
Hardware or X-On/X-Off handshaking supported.
Event character support Line break transmission.
USB suspend states supported via SUSPEND pins.
₹139.00 (Price is Exclusive of GST)CP2102 USB 2.0 to TTL UART Serial convertor Module
₹139.00 (Price is Exclusive of GST)BASIC NX3224T028 2.8″HMI LCD Touch Display
Features:
- 320 x 240 Resolution
- RGB 65K true to life colours
- TFT screen with integrated resistive touch panel
- 4 pin TTL serial interface
- 4M Flash memory for User Application Code and Data
- Onboard micro-SD card slot for firmware upgradation
- Visual Area: 57.6mm(L)×43.2mm(W)
- Adjustable Brightness: 0~180 nit, the interval of adjustment is 1%
- 5V65mA power consumption
- Compatible with Raspberry Pi A+, B+, Pi 2, Pi 3, Arduino.
- Certificates: CE/EMC, RoHS (certificates)
Software:
₹2,450.00 (Price is Exclusive of GST)BASIC NX3224T028 2.8″HMI LCD Touch Display
₹2,450.00 (Price is Exclusive of GST)10M Ohm Resistor -(Pack of 5)
Resistor Coloring Codes-
₹6.00 (Price is Exclusive of GST)10M Ohm Resistor -(Pack of 5)
₹6.00 (Price is Exclusive of GST)1K ohm Resistor (Pack of 5)
Features-
Resistance: 1K Ohm,
Power Rating: 8 Watt,
Tolerance: 5 %
₹5.00₹10.00(Price is Exclusive of GST)1K ohm Resistor (Pack of 5)
₹5.00₹10.00(Price is Exclusive of GST)330K Ohm 2W Carbon Film Resistor 5% (Pack of 5)
Features-
Resistance: 330K Ohm,
Power Rating: 2 Watt,
Tolerance: 5 %
₹24.00 (Price is Exclusive of GST)330K Ohm 2W Carbon Film Resistor 5% (Pack of 5)
₹24.00 (Price is Exclusive of GST)0.1MM Copper Soldering Solder PPA Enamelled Repair Reel Wire
Specifications and Features:
- Wire Diameter: 0.1 mm.
- Length: about 15m
- Color: Copper
- Flux Content:about 15m
- Material: Copper / Copper Alloy
- Spool Size: 3.1cm x 3.1cm x 1.9cm.
- 100% Brand new and high quality!
- 1 roll of 0.1 mm Enamelled wire.
- It can be used to connect Fly line(Jump wire) for computer and mobile phone motherboard repair.
- No need to remove the lacquer, welding directly.
₹38.00₹44.00(Price is Exclusive of GST)0.1MM Copper Soldering Solder PPA Enamelled Repair Reel Wire
₹38.00₹44.00(Price is Exclusive of GST)CA3130EZ CMOS Op-Amp IC DIP-8 Package
Features
- MOSFET Input Stage Provides: – Very High ZI = 1.5 T (1.5 x 1012) (Typ) – Very Low II 5pA (Typ) at 15V Operation = 2pA (Typ) at 5V Operation
- Ideal for Single-Supply Applications
- Common-Mode Input-Voltage Range Includes Negative Supply Rail; Input Terminals can be Swung 0.5V Below Negative Supply Rail
- CMOS Output Stage Permits Signal Swing to Either (or both) Supply Rails
- Pb-Free Plus Anneal Available (RoHS Compliant)
Applications
- Frequency Generator/Distorter
- Mobile jammers
- Voltage follower circuits
- DAC circuits
- Peak Signal/Noise detectors
- Oscillator circuits
Physical Attributes
- Length * Width * Height (mm): 9 x 7 x 7
- Weight (gm) : 0.2
₹35.00 (Price is Exclusive of GST)CA3130EZ CMOS Op-Amp IC DIP-8 Package
₹35.00 (Price is Exclusive of GST)- ₹25.00 (Price is Exclusive of GST)
22E 2w Carbon Film Resistor – Pack of 5
₹25.00 (Price is Exclusive of GST) 270k Ohm Resistors, 1/4 Watt, 5% (Pack of 5)
Features-
Resistance: 270K Ohm,
Power Rating: 1/4Watt,
Approximate Maximum Current: 1.1mA
₹5.00₹10.00(Price is Exclusive of GST)270k Ohm Resistors, 1/4 Watt, 5% (Pack of 5)
₹5.00₹10.00(Price is Exclusive of GST)170 Tie Point Mini Self-Adhesive Solderless Breadboard (Pack of 2)
Features :
- Use: experimental, testing, robot
- Matching jumper, diameter 0.8mm
- Accepts 20-29 AWG wire sizes.
- Adhesive-backed for permanent mounting.
- Color: Green, Yellow, Black.
₹57.00 (Price is Exclusive of GST)170 Tie Point Mini Self-Adhesive Solderless Breadboard (Pack of 2)
₹57.00 (Price is Exclusive of GST)Motor Driver Module TA6586 Based
Features:
- Heavy-duty screw terminal for the input.
- Can be connected directly to the 433MHz receiver output.
- Can drive up to 5A of current.
- Drives 2 motors.
₹165.00 (Price is Exclusive of GST)Motor Driver Module TA6586 Based
₹165.00 (Price is Exclusive of GST)15K ohm 5W Resistor (5 Pieces Pack)
Features
Electronics Components Passive Components Electronics Components Type Resistors Resistor Type Carbon Film Resistor Resistance Value 15 Ohms Power Rating of Resistor 5 Watt Tolerance 5% ₹60.00 (Price is Exclusive of GST)15K ohm 5W Resistor (5 Pieces Pack)
₹60.00 (Price is Exclusive of GST)
