-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹638.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹638.00(Price is Exclusive of GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹264.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹264.00 (Price is Exclusive of GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST) -
ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
- This DHT11 temperature and humidity sensor shield is specially designed for ESP8266 ESP-01 ESP-01S development board.
- On-board 8pin socket enable you plug the wifi transceiver to the board directly perfect for DIY your wireless temperature/humidity webserver system.
- Working Voltage: DC 3.7 – 12V
- The weight of about 10 grams
- Package Included: 1 X DHT11 Humidity Temperature Sensor
₹130.00 (Price is Exclusive of GST)ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
₹130.00 (Price is Exclusive of GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹207.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹207.00 (Price is Exclusive of GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)
- “0.28inch 0-100V Three Wire DC Mini Voltmeter Display Green” already exists in your wishlist
-
Power Adaptor Dual Pin 9 Volt 1 Amps
- AC Input Voltage: 100 ~ 240 V.
- Output Voltage(V): 9.
- Output Current (Amp): 1.
- Rated Frequency (Hz): 50 – 60.
- Cable Length: Approx 1.1m
₹177.00 (Price is Exclusive of GST)Power Adaptor Dual Pin 9 Volt 1 Amps
₹177.00 (Price is Exclusive of GST) -
Orange A Grade IFR18650 3.2V 1500mAh 3C LiFePO4 Battery
- Shape:Â Cylindrical Battery
- Battery Type: LiFePO4 Battery
- High performance and capacity
- Flat top to suit many devices fitting
- Suitable for portable devices
₹177.00 (Price is Exclusive of GST)Orange A Grade IFR18650 3.2V 1500mAh 3C LiFePO4 Battery
₹177.00 (Price is Exclusive of GST) -
WLY602040 3.7V 400mAh 1S LiPo Battery – Micro Rechargeable Battery Pack for Wearables / Micro Drone / IoT
- Capacity (mAh): 400
- Dimension: 6mm X 20mm X 40mm
- Max. Charge/Discharge Rate (C): 1C
- Model No: WLY602040
- Applications: Wearables / Micro Drone / IoT
₹179.00 (Price is Exclusive of GST)WLY602040 3.7V 400mAh 1S LiPo Battery – Micro Rechargeable Battery Pack for Wearables / Micro Drone / IoT
₹179.00 (Price is Exclusive of GST) -
716 Hollow Cup Coreless Motor with Propeller – Set of 2
Features:
- 716 Coreless motor is a High Speed and Low Torque motor.
- Less noisy operation.
- Offers low resistance.
- They are equipped with high-quality magnets.
- This coreless motor supports a 1S battery.
₹180.00 (Price is Exclusive of GST)716 Hollow Cup Coreless Motor with Propeller – Set of 2
₹180.00 (Price is Exclusive of GST) -
Esp8266-12E WIFI Module
- WS2812 Led on board.
- 802.11 b/g/n
- Wi-Fi Direct (P2P), soft-AP
- Integrated TCP/IP protocol stack
- Integrated TR switch, balun, LNA, power amplifier and matching network
- Integrated PLL, regulators, DCXO and power management units
₹180.00 (Price is Exclusive of GST)Esp8266-12E WIFI Module
₹180.00 (Price is Exclusive of GST) -
₹180.00 (Price is Exclusive of GST)Avr Usb Programmer Usbasp Usbisp Isp For Atmel Atmega Attiny Microcontrollers
₹180.00 (Price is Exclusive of GST) -
₹180.00 (Price is Exclusive of GST)Ceramic Capacitor Kit -300pcs (30 Kinds )
₹180.00 (Price is Exclusive of GST) -
GY-9960-3.3 APDS-9960 RGB Infrared Gesture Sensor Motion Direction Recognition Module
- Model: GY-APDS9960-3.3
- Chip: APDS-9960
- Power Supply: 3.3VDC
- Communication Through I2C Protocol
₹180.00 (Price is Exclusive of GST)GY-9960-3.3 APDS-9960 RGB Infrared Gesture Sensor Motion Direction Recognition Module
₹180.00 (Price is Exclusive of GST) -
Motor Driver Module TA6586 Based
Features:
- Heavy-duty screw terminal for the input.
- Can be connected directly to the 433MHz receiver output.
- Can drive up to 5A of current.
- Drives 2 motors.
₹182.80 (Price is Exclusive of GST)Motor Driver Module TA6586 Based
₹182.80 (Price is Exclusive of GST) -
XH-M603 HW-632 Charging Control Module With LED Display
Features:
- Â Automatic control circuit connection
- Â Automatic charging and power off
- Â Real-time voltage monitor
- Â Autosave setting
- Â ST core chip
- Â LM2596 switch voltage regulator
₹183.70 (Price is Exclusive of GST)XH-M603 HW-632 Charging Control Module With LED Display
₹183.70 (Price is Exclusive of GST) -
LDR Sensor Module with Relay for Motion Detection
How to use
- Photosensitive resistor module most sensitive to environmental light intensity is generally used to detect the ambient brightness and light intensity.
- Module light conditions or light intensity reach the set threshold, DO port output high, when the external ambient light intensity exceeds a set threshold, the module D0 output low;
- Digital output D0 directly connected to the MCU, and detect high or low TTL, thereby detecting ambient light intensity changes;
- Digital output module DOÂ can directly drive the relay module, which can be composed of a photoelectric switch;
- Analog output module AO and AD modules can be connected through the AD converter, you can get a more accurate light intensity value
₹185.00 (Price is Exclusive of GST)LDR Sensor Module with Relay for Motion Detection
₹185.00 (Price is Exclusive of GST) -
75pcs. Gears Assorted Kit for DIY Robotics and Household Repair
These gears are used in laboratories, science education, and DIY models and RC-airplane/helicopter repair, as well as many household repairs like old music system etc. its a great toolkit for promoting DIY abilities, improving children’s, teen’s hands-on skills and divergent thinking.
- Material: plastic;
- Colour: white, orange, Blue, yellow
₹185.00 (Price is Exclusive of GST)75pcs. Gears Assorted Kit for DIY Robotics and Household Repair
₹185.00 (Price is Exclusive of GST)
