-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
-
MQ4 Gas Sensor Detector Module
- Detecting range: 300~10000ppm
- Signal output indicator.
- Dual Signal output (analog output and TTL output).
- The TTL output signal is low level, allows us to connect with SCM directly.
- Analog output 0~5V voltage.
- Quick response and recovery.
₹88.00 (excl. GST)MQ4 Gas Sensor Detector Module
₹88.00 (excl. GST) -
MQ5 Gas Sensor Detector Module
- Operating Voltage: 5V DC
- High sensitivity to LPG, natural gas, town gas.
- Small sensitivity to alcohol, smoke.
- Stable and long life.
- Simple drive circuit.
- Fast response.
- Has a long life and reliable stability
- Fast response and recovery characteristics Applications of MQ6 LPG Gas Sensor Module:-
- Gas leak detection system
- Fire/Safety detection system
- Domestic gas leakage detector
- Industrial Combustible gas detector
- Portable gas detector
- Gas leak alarm
- Gas detector
₹88.00 (excl. GST)MQ5 Gas Sensor Detector Module
₹88.00 (excl. GST) -
MQ6 Liquified Petroleum Isobutane Propane Gas Sensor module
- Operating Voltage: 5V DC
- Indication of the signal output
- Dual signal output (analog output, and TTL level output)
- 0 ~ 5V analog output voltage, the higher the concentration, the higher the voltage
- High sensitivity to hydrogen
- Can be resistant to ethanol steam, LPG (petroleum), smoke interference
- Has a long life and reliable stability
- Fast response and recovery characteristicsApplications of MQ6 LPG Gas Sensor Module:-
- Gas leak detection system
- Fire/Safety detection system
- Domestic gas leakage detector
- Industrial Combustible gas detector
- Portable gas detector
- Gas leak alarm
- Gas detector
₹88.00 (excl. GST)MQ6 Liquified Petroleum Isobutane Propane Gas Sensor module
₹88.00 (excl. GST) -
MQ7 Carbon Monoxide Gas Sensor Module
- Operating voltage: DC 5 V.
- The analog output voltage, the higher the concentration the higher the voltage.
- The carbon monoxide detection with better sensitivity.
- With a long service life and reliable stability.
- Rapid response and recovery characteristics.
- Range: 10 to 1000 ppm.
₹88.00 (excl. GST)MQ7 Carbon Monoxide Gas Sensor Module
₹88.00 (excl. GST) -
MQ9 Gas Carbon Monoxide, Methane and LPG Gas Sensor Module
- Good sensitivity to CO/Combustible Gas
- High sensitivity to Methane, Propane, and CO
- Long life and low cost
- Simple drive circuit
- Input voltage: DC 5±0.2V
- Current Consumption: 150mA
₹88.00 (excl. GST)MQ9 Gas Carbon Monoxide, Methane and LPG Gas Sensor Module
₹88.00 (excl. GST) -
MT30 3 Pole Motor/ESC Connector Set Female-1Pcs
Features:
- Brand: Amass
- Suitable for: 16AWG wire (Max)
- Color: Yellow
- Gender: Female
- Gold Plated Connector
- High-Quality Material
₹75.00 (excl. GST)MT30 3 Pole Motor/ESC Connector Set Female-1Pcs
₹75.00 (excl. GST) -
MT30 3 Pole Motor/ESC Connector Set Male-1Pcs
Features:
- Brand: Amass
- Suitable for: 16AWG wire (Max)
- Color: Yellow
- Gender: Male
- Gold Plated Connector
- High-Quality Material
₹60.00 (excl. GST)MT30 3 Pole Motor/ESC Connector Set Male-1Pcs
₹60.00 (excl. GST) -
MT8870 DTMF Audio/Speech Decoding Telephone Module
Features:
- Onboard voice input interface
- Low power consumption
- Internal gain setting amplifier
- Onboard LED, it is very convenient to check the output state.
- Adjustable guard time
- Central office quality
- Onboard 3.5mm input interface
- 5 Channel interface
- On-board MT8870 frequency decoder chip
- Power-down mode
- Inhibit mode
- Onboard audio input interface
- Onboard LED lights for output state indication Complete DTMF Receiver.
- Does not require external circuits or wiring, it can be inserted directly into the UNO/MEGA2560/DUE board to use.
- 12-Digital outputs decode mobile and fixed telephone keys (0-9, * #). Also, another 4 Digital output(ABCD) can use “DTMF Dial” for Software control.
₹147.00 (excl. GST)MT8870 DTMF Audio/Speech Decoding Telephone Module
₹147.00 (excl. GST) -
Multi Purpose Display PEG Board
It is spaced from wall with molded ribs for added strength with attractive finished sides…no spacers or furring needed like other boards.
₹700.00 (excl. GST)Multi Purpose Display PEG Board
₹700.00 (excl. GST) -
Multicolor Flat Ribbon Cable, 20 Wire per 1 meter
Features :
- Easily and directly inserted into PCB.
- Suitable for internal wiring in office equipment, audio, and video machines.
- Durable and reusable.
- Easy to install and use.
- A popular choice for construction or repair.
- Useful for the electronic project and Genuine Arduino product.
₹44.00₹55.00(excl. GST)Multicolor Flat Ribbon Cable, 20 Wire per 1 meter
₹44.00₹55.00(excl. GST) -
Multifunction Shield For Arduino Uno / Leonardo
Features:
- 4 digit 7-segment LED display module driven by two serial 74HC595’s.
- 4 x surface mount LED’s in a parallel configuration.
- 10K adjustable precision potentiometer.
- 3 x Independent push buttons.
- Piezo buzzer.
- DS18B20 temperature sensor interface.
- LM35 temperature sensor interface.
- Infrared receiver interface.
- Serial interface header for convenient connection to serial modules such as Bluetooth, a wireless interface, voice module, a voice recognition module, etc.
₹241.00 (excl. GST)Multifunction Shield For Arduino Uno / Leonardo
₹241.00 (excl. GST) -
N20 12V 300RPM Micro Metal Gear Motor With Encoder
Features :
- Model: GA12 N20.
- This is a DC Mini Metal Gear Motor, ideal for making robots
- Lightweight, high torque and low RPM.
- Fine craftsmanship, durable, not easy to wear.
- With excellent stall characteristics, can climb hills easily.
- You can also easily mount a wheel on the motor’s output shaft.
- Motor Size: 15 x 12 x 10 mm.
- Gearbox Length: 9 mm.
- Count: 3PPR(Pulse per Revolutions).
How to do wiring :
- Red – motor Power (Exchange can control the motor positive and negative rotation).
- Black – encoded power supply(VCC) – Positive (positive 3.3-5v).
- Yellow – signal feedback (motor turns 2 signals).
- Green – signal feedback (motor turns 2 signals).
- Blue – encoded power(GND).
- White – Motor power (Exchange can control the motor positive and negative rotation).
Dimensions :
₹310.00 (excl. GST)N20 12V 300RPM Micro Metal Gear Motor With Encoder
₹310.00 (excl. GST)
