NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹390.00 (Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (Price is Exclusive of GST)
400KV Step Up Power Module
Input Voltage: DC3.6V-6V
Input Current: 2A-5A
Output Voltage: DC 400KV (Please pay attention to safety when used)
Input Line Length: about 100mm (red is positive)
Output Line Length: about 160mm₹87.00 (Price is Exclusive of GST)400KV Step Up Power Module
₹87.00 (Price is Exclusive of GST)IRF1404 MOSFET – 40V 202A N-Channel HEXFET Power MOSFET
IRF1404 MOSFET
Number of Channels: 1 Channel
Transistor Polarity: N-Channel
Drain-Source Breakdown Voltage (Vds): 40V
Continuous Drain Current (Id): 202A
Drain-Source Resistance (Rds On): 4mOhms
₹87.00 (Price is Exclusive of GST)IRF1404 MOSFET – 40V 202A N-Channel HEXFET Power MOSFET
₹87.00 (Price is Exclusive of GST)- ₹87.00 (Price is Exclusive of GST)
Yellow 0.28″ Mini 2 Wire Dc Voltmeter 0.2-100v Digital Display Voltmeter Gauge LED Voltage
₹87.00 (Price is Exclusive of GST) 400KV Step Up Power Module
Input Voltage: DC3.6V-6V
Input Current: 2A-5A
Output Voltage: DC 400KV (Please pay attention to safety when used)
Input Line Length: about 100mm (red is positive)
Output Line Length: about 160mm₹86.00 (Price is Exclusive of GST)400KV Step Up Power Module
₹86.00 (Price is Exclusive of GST)ESP-01 ESP8266 Serial WIFI Wireless Transceiver Module
Features :
- Wi-Fi Direct (P2P), soft-AP
- Integrated TCP/IP protocol stack
- It features an integrated TR switch, balun, LNA, power amplifier and matching network
- Equips integrated PLL, regulators, DCXO and power management units
- Integrated low power 32-bit CPU could be used as an application processor
- SDIO 1.1 / 2.0, SPI, UART
- STBC, 1×1 MIMO, 2×1 MIMO
- A-MPDU & A-MSDU aggregation & 0.4ms guard interval
- Wake up and transmit packets in < 2ms
- Standby power consumption of < 1.0mW (DTIM3)
₹86.00 (Price is Exclusive of GST)ESP-01 ESP8266 Serial WIFI Wireless Transceiver Module
₹86.00 (Price is Exclusive of GST)P35 Small Float Level Control Switch Plastic Float Switch
Features:
- Long-lasting life
- Easy to use
₹85.00 (Price is Exclusive of GST)P35 Small Float Level Control Switch Plastic Float Switch
₹85.00 (Price is Exclusive of GST)Desoldering Pump Tool
- One-handed solder sucker with powerful suction whether you are right or left-handed, you can using the desoldering pump by just cocking it and pressing the trigger button with one hand when you are ready, the desoldering pump designed with double ring double open and “vacuum” button, which make the sucking power awesome
₹85.00 (Price is Exclusive of GST)Desoldering Pump Tool
₹85.00 (Price is Exclusive of GST)- ₹85.00 (Price is Exclusive of GST)
6 Feet USB 2.0 to RS232 DB9 Serial Adapter Cable
₹85.00 (Price is Exclusive of GST) - ₹85.00 (Price is Exclusive of GST)
USB to TTL Serial Converter Adapter Cable
₹85.00 (Price is Exclusive of GST) Nano And Uno Multi-Purpose Expansion Board For Nano 3.0
- Compatible with Arduino NANO
- All digital and analog pins breakout
- Compact size;
- External power supply current support
- Leads all pins out, convenient for wiring and doing experiments.
₹85.00 (Price is Exclusive of GST)Nano And Uno Multi-Purpose Expansion Board For Nano 3.0
₹85.00 (Price is Exclusive of GST)Metal Robot Chassis for 4WD Robo Car
- Metal Body
- Available in two color red & grey
- Many perforated holes have given for easy attachment of the development board and sensors
- Center Shaft gear motor and side shaft gear motor can be used for this chassis.
₹85.00 (Price is Exclusive of GST)Metal Robot Chassis for 4WD Robo Car
₹85.00 (Price is Exclusive of GST)EasyMech Aluminium NEMA23 Shaft Coupling 6.35mm X 8mm
Aluminium Shaft Coupling
- Material: Aluminium.
- Bore Diameter d1: 6.35 mm.
- Bore Diameter d2: 8 mm.
- Overall Length: 30 mm.
- Outer Diameter (OD): 16 mm.
₹83.00 (Price is Exclusive of GST)EasyMech Aluminium NEMA23 Shaft Coupling 6.35mm X 8mm
₹83.00 (Price is Exclusive of GST)
