-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹638.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹638.00(Price is Exclusive of GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹264.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹264.00 (Price is Exclusive of GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST) -
ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
- This DHT11 temperature and humidity sensor shield is specially designed for ESP8266 ESP-01 ESP-01S development board.
- On-board 8pin socket enable you plug the wifi transceiver to the board directly perfect for DIY your wireless temperature/humidity webserver system.
- Working Voltage: DC 3.7 – 12V
- The weight of about 10 grams
- Package Included: 1 X DHT11 Humidity Temperature Sensor
₹130.00 (Price is Exclusive of GST)ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
₹130.00 (Price is Exclusive of GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹207.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹207.00 (Price is Exclusive of GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)
-
UNO SMD Atmega328P Development Board compatible with Arduino
Features-
- Flash Memory – 32 KB (ATmega32u4) of which 4 KB used by boot loader
- SRAM – 2 KB (ATmega328P)
- EEPROM – 1 KB (ATmega328P)
₹190.00₹243.30(Price is Exclusive of GST)UNO SMD Atmega328P Development Board compatible with Arduino
₹190.00₹243.30(Price is Exclusive of GST) -
2.4GHz NRF24L01+PA+LNA SMA Wireless Transceiver Antenna
Features :
- It uses 2.4GHz global open ISM band, with license-free.
- Transmit power is greater than +20 dBm.
- Support six-channel data reception.
- 2Mbit/s speed makes high-quality VoIP possible
- Multi-frequency points: 125 frequency points meet the needs of multi-point communications and frequency hopping.
- Low cost: integrated with high-speed signal processing parts associated with RF protocol, such as: automatically re-send lost packets and generate acknowledge signal;
- SPI interface facilitates the communication with MCU I/O port.
- Facilitate the development for customers, without development RF part.
- Software programming is fully compatible with NRF24L01 modules.
₹192.00 (Price is Exclusive of GST)2.4GHz NRF24L01+PA+LNA SMA Wireless Transceiver Antenna
₹192.00 (Price is Exclusive of GST) -
Orange A Grade IFR26650 3000mAh (3c) LiFePO4 Battery
- Shape:Â Cylindrical Battery
- Battery Type: LiFePO4 Battery
- High performance and capacity
- Flat top to suit many devices fitting
- Suitable for portable devices
₹192.00 (Price is Exclusive of GST)Orange A Grade IFR26650 3000mAh (3c) LiFePO4 Battery
₹192.00 (Price is Exclusive of GST) -
Orange A Grade IFR26650 3000mAh (3c) LiFePO4 Battery
- Shape:Â Cylindrical Battery
- Battery Type: LiFePO4 Battery
- High performance and capacity
- Flat top to suit many devices fitting
- Suitable for portable devices
₹192.00 (Price is Exclusive of GST)Orange A Grade IFR26650 3000mAh (3c) LiFePO4 Battery
₹192.00 (Price is Exclusive of GST) -
Orange A Grade ISR 18650 3.7V 2200mAh 10C Li-ion Battery
- Model No.: ISR18650-2200
- Capacity (mAh): 2200
- Output Voltage: 3.7V
- Charge Rate: 2C
- High energy density
- High working voltage for single battery cells.
- Pollution-free
- Long cycle life
₹192.00 (Price is Exclusive of GST)Orange A Grade ISR 18650 3.7V 2200mAh 10C Li-ion Battery
₹192.00 (Price is Exclusive of GST) -
₹195.00 (Price is Exclusive of GST)
XH-M401 DC Step Down Buck Converter Voltage Regulator 4V-40V to 1.25V-36V DC Voltage Converter Power Supply
₹195.00 (Price is Exclusive of GST) -
CN3791 12V MPPT Solar Charger Module
CN3791 12V MPPT Solar Charger Module
Features:
- Maximum Power Point Tracking (MPPT) Solar Charger Module
- 2-Pin JST Connectors for Solar Panel and Battery Connection
- PWM Switching Frequency of 300KHz
- Maximum Charging Current of 2A
₹195.00 (Price is Exclusive of GST)CN3791 12V MPPT Solar Charger Module
₹195.00 (Price is Exclusive of GST) -
Force Sensor Resistor Square 38.1mm – Pressure Sensor
- Easily customizable to a wide range of sizes
- Cost-effective
- Ultra-thin; 0.45 mm
- Robust; up to 10 million actuations
- Simple and easy to Integrate.
₹196.00 (Price is Exclusive of GST)Force Sensor Resistor Square 38.1mm – Pressure Sensor
₹196.00 (Price is Exclusive of GST) -
WLY902025 3.7V 400mAh 1S LiPo Battery – Micro Rechargeable Battery Pack for Wearables / Micro Drone / IoT
- Capacity (mAh): 400
- Dimension: 9mm X 20mm X 25mm
- Max. Charge/Discharge Rate (C): 1C
- Model No: WLY902025
- Applications: Wearables / Micro Drone / IoT
₹196.00 (Price is Exclusive of GST)WLY902025 3.7V 400mAh 1S LiPo Battery – Micro Rechargeable Battery Pack for Wearables / Micro Drone / IoT
₹196.00 (Price is Exclusive of GST) -
Pagkis: 5pcs Non-Magnetic Stainless Steel Tweezers
- These are non-magnetic & self opening type (squeeze to close) tweezers.
- These can also be used for watch repair and jewelry repair work etc.
- These are made from good quality brushed stainless steel and are non magnetic
₹200.00 (Price is Exclusive of GST)Pagkis: 5pcs Non-Magnetic Stainless Steel Tweezers
₹200.00 (Price is Exclusive of GST) -
EM-18 RFID Reader module
- Operating Voltage: 5V DC Supply
- Reading Distance: 6-10 cm.
- Read frequency: 125 kHz.
- EM4001 64 – bit RFID tag compatible.
- 9600bps ASCII output.
- Current : <50 mA
- Operating Frequency : 125 Khz
- Read Distance : 5 cm
- Compatible Tags : 125KHz EM4100 Tags
₹200.00 (Price is Exclusive of GST)EM-18 RFID Reader module
₹200.00 (Price is Exclusive of GST) -
Aluminum Electrolytic Capacitor Assorted Kit – 12 Kinds 0.22-F-470-F
Features:
1.Made of high-quality material, durable, and practical to use.
2.Durable and easy to install.
3.Very convenient and practical.
4.Very popular with electronics enthusiasts.
5.A variety of types of electrolytic capacitors to meet your different needs.₹200.00 (Price is Exclusive of GST)Aluminum Electrolytic Capacitor Assorted Kit – 12 Kinds 0.22-F-470-F
₹200.00 (Price is Exclusive of GST)
