-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹638.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹638.00(Price is Exclusive of GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹264.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹264.00 (Price is Exclusive of GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST) -
ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
- This DHT11 temperature and humidity sensor shield is specially designed for ESP8266 ESP-01 ESP-01S development board.
- On-board 8pin socket enable you plug the wifi transceiver to the board directly perfect for DIY your wireless temperature/humidity webserver system.
- Working Voltage: DC 3.7 – 12V
- The weight of about 10 grams
- Package Included: 1 X DHT11 Humidity Temperature Sensor
₹130.00 (Price is Exclusive of GST)ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
₹130.00 (Price is Exclusive of GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹207.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹207.00 (Price is Exclusive of GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)
-
Weighing Load Cell Sensor 3KG For Electronic Kitchen Scale YZC-131 With Wires
Wheatstone bridge formation of Load Cell:
HX711 (24 bit Analog to Digital Converter)
HX 711 is a precision 24-bit analog to digital converter (ADC) specially designed for Weigh scales and industrial control applications to interface directly with a bridge sensor.
Simply connect Load cell wires to the HX711 module based on their color, then connect DAT (Data) pin to Arduino Analog pin A1 and connect CLK (Clock) pin to Arduin0 Analog pin A0, Put Vcc and GND supply from Arduino power source pins.
₹222.00 (Price is Exclusive of GST)Weighing Load Cell Sensor 3KG For Electronic Kitchen Scale YZC-131 With Wires
₹222.00 (Price is Exclusive of GST) -
₹225.00 (Price is Exclusive of GST)Raspberry Pi 3 Official Case Box ABS
₹225.00 (Price is Exclusive of GST) -
N20-3V-100 RPM Micro Metal Gear-box DC Motor
Features :
- This is a DC Mini Metal Gear Motor, ideal for making robots
- Lightweight, high torque and low RPM.
- Fine craftsmanship, durable, not easy to wear.
- With excellent stall characteristics, can climb hills easily.
- You can also easily mount a wheel on the motor’s output shaft.
₹225.00 (Price is Exclusive of GST)N20-3V-100 RPM Micro Metal Gear-box DC Motor
₹225.00 (Price is Exclusive of GST) -
Gas Detection Alarm Sensor DIY Kit
Function Description:
With the continuous improvement of people’s living standards, gas and natural gas have entered thousands of households, bringing convenience to everyone but also posing many safety hazards. Gas poisoning accidents also occur from time to time. Therefore, we must conduct regular inspections of areas where gas leakage may occur. The gas detection and alarm circuit is composed of gas sensor MQ5, voltage comparator LM393, voice chip COO2, and other components. It can detect combustible gases in the air and automatically sound and light alarms₹225.00 (Price is Exclusive of GST)Gas Detection Alarm Sensor DIY Kit
₹225.00 (Price is Exclusive of GST) -
Electronics Component Pack Kit
Electronics Component Pack Kit LED ,Switch, Potentiometer, Resistors ,Headers
₹225.00 (Price is Exclusive of GST)Electronics Component Pack Kit
₹225.00 (Price is Exclusive of GST) -
₹230.00 (Price is Exclusive of GST)Dual Channel Stereo Mini Class D Digital Audio Power Amplifier Board (PAM8610 2 x 10W with Volume)
₹230.00 (Price is Exclusive of GST) -
12V-40V 10A PWM DC Motor Speed Controller, 400W DC Motor Speed Controller
- 1.6mm FR4 double-sided circuit board, perfectly working
- Potentiometer you can adjust power supply output High efficiency, small heating,widely used in the industrial production
- The board can control motor speed to change between 10% to 100%
- With Power supply reverse polarity protection and high current protection
₹230.00 (Price is Exclusive of GST)12V-40V 10A PWM DC Motor Speed Controller, 400W DC Motor Speed Controller
₹230.00 (Price is Exclusive of GST) -
5V WiFi Relay Module v1.0 for ESP8266 ESP01S- IOT Smart Home Remote Control Switch
- Operating Voltage: DC 5V
- Transmission range: the maximum transmission range of 400m (open environment, mobile phone equipped with WIFI module)
- Load capacity: 10A / 250VAC 10A / 30VDC, the relay pulls 100,000 times
- Designed for smart home, internet of thing and other DIY project.
₹230.00 (Price is Exclusive of GST)5V WiFi Relay Module v1.0 for ESP8266 ESP01S- IOT Smart Home Remote Control Switch
₹230.00 (Price is Exclusive of GST) -
Stanley Combination Mini Plier, For Cutting, Size: 205 mm
- Color: Yellow and Black, Material: Plastic and Sturdy Steel
- Jaws and Cutting Edge are Induction Hardened & Tempered
- Black phosphate finish anti-rust protected
- Anti-rust Protected
- Package Contents: 1-Piece Plier
- Limited lifetime warranty offered on the product
₹230.00 (Price is Exclusive of GST)Stanley Combination Mini Plier, For Cutting, Size: 205 mm
₹230.00 (Price is Exclusive of GST) -
Orange A Grade ISR 18650 3.7V 2500mAh 8C Li-ion Battery
- Model No.: ISR18650-2500
- Capacity (mAh): 2500
- Output Voltage: 3.7V
- High energy density
- High working voltage for single battery cells.
- Pollution-free
- Long cycle life
₹231.00 (Price is Exclusive of GST)Orange A Grade ISR 18650 3.7V 2500mAh 8C Li-ion Battery
₹231.00 (Price is Exclusive of GST) -
HX IFR32700 3.2V 6000mAh 1C LiFePO4 Battery Solar Grade
- Model: IFR 32700
- Nominal Rated Voltage:3.2 V
- Rechargeable: Yes
- Nominal Capacity: 6000mAh
- Discharge Cut-off Voltage: 2V
₹234.00 (Price is Exclusive of GST)HX IFR32700 3.2V 6000mAh 1C LiFePO4 Battery Solar Grade
₹234.00 (Price is Exclusive of GST) -
Orange ICR18650-25C 3.7V 2500mAh 3C Li-ion Battery
- Model No.: ICR18650-25C
- Capacity (mAh): 2500
- Output Voltage: 3.7V
- Charge Rate: 2C
- High energy density
- High working voltage for single battery cells.
- Pollution-free
- Long cycle life
₹234.00 (Price is Exclusive of GST)Orange ICR18650-25C 3.7V 2500mAh 3C Li-ion Battery
₹234.00 (Price is Exclusive of GST)
