-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST)
-
Stanley PLIER Long Nose, 203mm-8
- Features – Forged Steel Construction, Double dipped handles, Rust Resistant Finish
- Specifications – Part No. 84-102, Size: 203mm / 8″ Long Nose Plier
- Applications – Electric and Household applications
₹400.00 (excl. GST)Stanley PLIER Long Nose, 203mm-8
₹400.00 (excl. GST) -
84-096-23 127mm-5 Needle Nose Miniature Plier
- Long tempered jaws for working in hard to reach areas
- Forged steel construction
- Rust resistant finish
- Double dipped handle for comfort | Meets or exceeds ANSI standards
₹400.00 (excl. GST)84-096-23 127mm-5 Needle Nose Miniature Plier
₹400.00 (excl. GST) -
5 in 1 Stainless Steel Tweezer Set
- This craft tweezer set made of high strength stainless steel with, process by heat treatment and hardening to make the tweezers high elasticity
- The tip of the tweezers has a high hardness and can be used for precise operation such as board soldering or watch repair.
- We have a professional team and always ready to provide the best service
₹400.00 (excl. GST)5 in 1 Stainless Steel Tweezer Set
₹400.00 (excl. GST) -
Drill Bit Set Combo HSS-13 Pcs
- Industrial quality for smooth accurate drilling
- Use on plastic, metal and wood
- HSS drill set with standard 1/4″ hex shank that will fit
- cordless screwdrivers, drills etc or use in standard drill chuck.
₹400.00 (excl. GST)Drill Bit Set Combo HSS-13 Pcs
₹400.00 (excl. GST) -
Orange 12V 20 RPM Johnson Geared DC Motor Grade A Quality Encoder Compatible
Features :
- Grade A Quality branded Johnson DC Motor.
- It has sturdy construction.
- Shaft equips metal bushes for long life.
- It comes with High-Quality gears.
- The shaft has a hole for better coupling.
₹400.00 (excl. GST)Orange 12V 20 RPM Johnson Geared DC Motor Grade A Quality Encoder Compatible
₹400.00 (excl. GST) -
ESP32 CAM WiFi Module Bluetooth with OV2640 Camera Module 2MP For Face Recognization
Features :
ESP32-CAM :
- The smallest 802.11b/g/n Wi-Fi BT SoC module.
- Low power 32-bit CPU, can also serve the application processor.
- Up to 160MHz clock speed, summary computing power up to 600 DMIPS.
- Built-in 520 KB SRAM, external 4MPSRAM.
- Supports UART/SPI/I2C/PWM/ADC/DAC.
- Support OV2640 and OV7670 cameras, built-in flash lamp.
- Support image WiFI upload.
- Supports TF card.
- Supports multiple sleep modes.
- Embedded Lwip and FreeRTOS.
- Supports STA/AP/STA+AP operation mode.
- Support Smart Config/AirKiss technology.
- Support for serial port local and remote firmware upgrades (FOTA).
Specifications :
- Wireless Module: ESP32-S WiFi 802.11 b/g/n + Bluetooth 4.2 LE module with PCB antenna, u.FL connector, 32Mbit SPI flash, 4MBit PSRAM.
- External Storage: micro SD card slot up to 4GB.
- Camera
- FPC connector.
- Support for OV2640 (sold with a board) or OV7670 cameras.
- Image Format: JPEG( OV2640 support only ), BMP, grayscale.
- LED flashlight.
- Expansion: 16x through-holes with UART, SPI, I2C, PWM.
- Misc: Reset button.
- Power Supply: 5V via pin header.
- Power Consumption.
- Flash LED off: 180mA @ 5V.
- Flash LED on to maximum brightness: 310mA @ 5V.
- Deep-sleep: 6mA @ 5V min.
- Modem-sleep: 20mA @ 5V min.
- Light-sleep: 6.7mA @ 5V min.
- Dimensions (ESP32): 40 x 27 x 12 (LxWxH) mm.
- Temperature Range: Operating: -20 ℃ ~ 85 ℃; storage: -40 ℃ ~ 90 ℃ @ < 90%RH.
₹400.00 (excl. GST) -
2WD Mini Round Double-Deck Smart Robot Car Chassis DIY Kit
2 x Gear Motor
4 x “T” mode Fixed Motor Bracket
16 x M3X10mm Screw
8 x M3 Nut
4 x M3X12+6mm Copper Cylinder
4 x M3X30mm two-way Copper Colum₹400.00 (excl. GST)2WD Mini Round Double-Deck Smart Robot Car Chassis DIY Kit
₹400.00 (excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
Auto Hand Sanitizer Dispenser Kit with IR sensor, Relay, Pump, Power Supply and Jumper Wires – V1
The kit Contains:
1 pc IR Sensor
1 pc IR Control Board with Relay port
1 Pc Mini Submersible Pump
1 Pc 12V Adaptor
40 pc Jumper Wire ( Female to Female)₹410.00 (excl. GST) -
PIR Motion Sensor Switch with Light Sensor for Home Automation
- PIR Motion Sensor Switch can use with lamps, incandescent lamps (bulbs), old-fashioned fluorescent lamps, electronic fluorescent ring lamps, spotlights, transformers, small electrical appliances, and other all other appliance
- Good solution for energy saving and easy in installation. and Delay adjustment: 10 Seconds – 7 Minutes and Adjustable Lux: turn on the lights during the day or night
- Sensitivity Adjustable: Turn on Lights during Day or nights
₹410.00 (excl. GST)PIR Motion Sensor Switch with Light Sensor for Home Automation
₹410.00 (excl. GST) -
STM32F401CCU6 Minimum System Board Microcomputer STM32 ARM Core Board
Features :
- 100% Brand new and high-quality STM32 Board
- 84 MHz work frequency.
- 256K flash memory,64K SRAM.
- 1.7-3.6V power, I/O.
- 4-26MHz crystal.
- Onboard the Type-C USB interface, you can give the board power supply and USB communication.
₹410.00 (excl. GST)STM32F401CCU6 Minimum System Board Microcomputer STM32 ARM Core Board
₹410.00 (excl. GST) -
ESP WROOM 32 MCU Module Version: 1.1
The user may also power off the CPU and make use of the low-power coprocessor to constantly monitor the peripherals for changes or crossing of thresholds. ESP32S integrates a rich set of peripherals, ranging from capacitive touch sensors, Hall sensors, low-noise sense amplifiers, SD card interface, Ethernet, high-speed SDIO/SPI, UART, and I²C.
Application :
- Universal low power IoT sensor hub.
- Home automation.
- Universal low power IoT recorder.
- Mesh network.
- Video streaming of the camera.
- Industrial wireless control.
- OTT TV box / set-top box device.
- Baby monitor.
- Smart Socket.
- Sensor networks.
- Wi-Fi toys: Counters, toys, Anti-lost device.
- Wearable electronic products.
- Wi-Fi speech recognition device.
- Wi-Fi location-aware devices.
Features :
- Integrated 520 KB SRAM.
- Hybrid Wi-Fi & Bluetooth.
- High level of integration.
- Ultra-low-power management.
- 4 MB Flash.
- On-board PCB antenna.
₹410.00 (excl. GST)ESP WROOM 32 MCU Module Version: 1.1
₹410.00 (excl. GST)
