-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
-
PCB Power Drill Machine
Features:
- Model – MB140
- Key-pin chuck
- Chuck capacity 0.4 to 1.0mm; 2.1 to 2.5mm
- Operating Voltage – 0 to 18 volts (D.C.)
- Ergonomic design includes a pencil grip for comfort
- Motor is fan cooled for long periods of use and longevity
- Overall length: 170mm (approx)
- RPM: 0 – 30,000 rpm
- Collete – (0mm) 1piece; (2.3mm) 1piece
- Weight: ~275grams
₹800.00 (excl. GST)PCB Power Drill Machine
₹800.00 (excl. GST) -
Photosensitive Light Sensor ( LDR Sensor Board)
- Operating voltage 3.3V-5V
- Signal output indicator light
- Able to detect ambient brightness and light intensity Adjustable sensitivity
₹18.00₹35.00(excl. GST)Photosensitive Light Sensor ( LDR Sensor Board)
₹18.00₹35.00(excl. GST) -
Phototransistor L14G3 (L 14 G 3) Photodiode, Photo Diode, Photo detector
Phototransistor L14G3
Specifications:-
- Mounting Type : Through Hole
- Collector to Emitter Breakdown Voltage : 45V
- Collector to Base Breakdown Voltage : 45V
- Emitter to Base Breakdown Voltage : 5V
- On-State Collector Current : 0.5mA
- Reception Angle : ±10°
- Operating Temperature Range (°C) : -65 to 125
₹59.00 (excl. GST)Phototransistor L14G3 (L 14 G 3) Photodiode, Photo Diode, Photo detector
₹59.00 (excl. GST) -
Piezo Buzzer 15mm
- Clear sound
- Ultra-thin and lightweight
- No contacts: therefore, no noise and highly reliable
- Low power consumption for voltage type
- Excellent accessory for acoustic instrument pickups, stompboxes, contact mics, etc.
- Piezoelectric buzzer film. Can be fitted to used acoustic guitars, CBGs, drums, etc.
- 15mm brass outer diameter plate and ceramic inner diameter plate.
- All the discs are made from selected copper, ensuring excellent conductivity and long-lasting use.
₹15.00 (excl. GST)Piezo Buzzer 15mm
₹15.00 (excl. GST) -
Piezo Electronic Buzzer Beep 3v-5v Electromagnetic Buzzer
- Rated Voltage: 1.5 ~ 12 VDC
- Operation Voltage: 1.2 ~ 16 VDC
- Rated Current: ≤ 40 mA
- Rated Current: 6.5 ± 1.0 45 ± 5 140 ± 14(Ω)
- Coil Impedance: 16 ~ 240 Ω
- Sound Output: ≥ 85 DB
- Resonant Freq.: 2400 HZ
- Operating Temp: -20º C ~ 65º C
- Storage Temp: -20º C ~ 70º C
- Diameter: 10 mm
₹12.00 (excl. GST)Piezo Electronic Buzzer Beep 3v-5v Electromagnetic Buzzer
₹12.00 (excl. GST) -
Piezo Electronic Buzzer Beep 9v-12v Buzzer Electromagnetic
Rated Voltage: 5VDC
Operating Voltage: 4-8VDC
Max.Rated Current: 40mA
Coil Resistance(DC): 45±5Ω
Coil Resistance(DC): 80Ω
Min.Sound Pressure Level: 85dB/10cm
Resonant Frequency: 2400Hz
Operating Temperature: -20～+70℃
Storage Temperature: -30～+80℃₹15.00 (excl. GST)Piezo Electronic Buzzer Beep 9v-12v Buzzer Electromagnetic
₹15.00 (excl. GST) -
Piezo Sensor Disc Type 27mm high quality
- Based on the principle of piezo electricity
- They can also be used for custom pickup arrangements
- Shape: Round
- Weight: 11 gms
- perfect for using as touch-sensors, electronic drum triggers, buzzers or making your own contact mics
₹8.00 (excl. GST)Piezo Sensor Disc Type 27mm high quality
₹8.00 (excl. GST) -
PIR Motion Sensor Detector Module HC-SR501
- PIR infrared sensor module is based on infrared technology, automatic control products
- High sensitivity, high reliability, low power consumption, low voltage operation mode
- Widely used in various auto-sensing electrical equipment, especially for battery-powered automatic control products.
₹55.00₹64.00(excl. GST)PIR Motion Sensor Detector Module HC-SR501
₹55.00₹64.00(excl. GST) -
PIR Motion Sensor Switch with Light Sensor for Home Automation
- PIR Motion Sensor Switch can use with lamps, incandescent lamps (bulbs), old-fashioned fluorescent lamps, electronic fluorescent ring lamps, spotlights, transformers, small electrical appliances, and other all other appliance
- Good solution for energy saving and easy in installation. and Delay adjustment: 10 Seconds – 7 Minutes and Adjustable Lux: turn on the lights during the day or night
- Sensitivity Adjustable: Turn on Lights during Day or nights
₹410.00 (excl. GST)PIR Motion Sensor Switch with Light Sensor for Home Automation
₹410.00 (excl. GST) -
PL2303-PL2303HX USB To TTL(Serial) Converter Module – 5 Pin
Features of PL2303 USB to TTL USB Converter Module:-
- Adopt imported controller PL2303HX, which can stabilize the flash with high speed
- 500mA self-recovery fuse for protection
- Two data transmission indicator can monitor data transfer status in real time
- Reserve 3.3V and 5V pin interface, easy for the DDWRT of different voltage system that needs power
- The entire board is coated by the high quality transparent heat-shrinkable sleeve, making the PCB in insulation state from outside,
- so that the board won’t be burnt down by material shortcut.
- Electrostatic package ensures the board will not be damaged before use
- Excellent driver support–drivers are available for Windows 98 to Windows 7 (32 bit and 64 bit), Mac OS 8 to OS X (32 bit and 64 bit) and Linux. Even Android is supported.
₹65.00 (excl. GST)PL2303-PL2303HX USB To TTL(Serial) Converter Module – 5 Pin
₹65.00 (excl. GST) -
Plastic Gear Accessory Kit
Plastic Gear Accessory Kit
- Multipurpose gears and Pulley
- Four different types of propellors
- Rubber band
- Colorful kit
₹265.00 (excl. GST)Plastic Gear Accessory Kit
₹265.00 (excl. GST) -
Plastic Landing Gear for Quadcopter
Features :
- Good-Quality Gears
- Provides 200mm ground clearance
- Skid proof gears
- Compatible with Q450 and S500 and another large size frames
₹263.00 (excl. GST)Plastic Landing Gear for Quadcopter
₹263.00 (excl. GST)
