No products in the cart.
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹390.00 (Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (Price is Exclusive of GST)
Universal Heat Sink (25 x 25 x 10 mm)
- Quantity of blade: 8
- Material: Aluminum
- Color: Black
- Blade thickness: 1mm
- Base plate thickness: 2mm
- Dimensions: 25 x 25 x 10 mm
₹9.00 (Price is Exclusive of GST)Universal Heat Sink (25 x 25 x 10 mm)
₹9.00 (Price is Exclusive of GST)650nm 6mm 5V DC 5mW Mini Laser Dot Diode Module
- Output Power: 5mW
- Working Voltage: 5V DC
- Working temperature: -10 ℃~＋40 ℃
- Housing material: Copper
- Working life: more than 2000 hours
- Spot mode: Dot Facula (continuous output)
- Laser wavelength: 650nm red-colored.
- Operating current: <40mA
- Power lead length: 120mm.
₹9.50 (Price is Exclusive of GST)650nm 6mm 5V DC 5mW Mini Laser Dot Diode Module
₹9.50 (Price is Exclusive of GST)Infrared IR Transmitter and Receiver (Photo-diode) Pair
Features:
- IR LED (TSFF5210)
- Package type: leaded
- Dimensions : 5mm
- Leads with stand-off
- Peak wavelength: λp = 870 nm
- High reliability
- High radiant power
- High radiant intensity
- Angle of half intensity: = ± 10°
- Low forward voltage
- Suitable for high pulse current operation
- High modulation bandwidth: fc = 24 MHz
- Good spectral matching with Si photodetectors
- IR Photodiode (BPV10NF)
- Package type: leaded
- Dimensions : 5mm
- Leads with stand-off
- Radiant sensitive area (in mm2): 0.78
- High radiant sensitivity
- Daylight blocking filter matched with 870 nm to 890 nm emitters
- High bandwidth: > 100 MHz at VR = 12 V
- Fast response times
- Angle of half sensitivity: ± 20°
₹10.00 (Price is Exclusive of GST)Infrared IR Transmitter and Receiver (Photo-diode) Pair
₹10.00 (Price is Exclusive of GST)- IR LED (TSFF5210)
SW420 Tilt Ball switch 2801 ball sensor
- Operating voltage: 5V
- Contact Resistance: < 10 Ohms
- Trigger Angle: 15°
- Pins have no polarity
- This series of products is a ball sensor switch, up and down, or. Tilt over 15 degrees is conductive
- The series switch is normally open at rest (OFF) state, when the external force to achieve the corresponding flip, or at a proper angle of tilt, trigger switch.
- The trigger sensitivity of the inductive switch is very high
- Fully sealed package, waterproof, dustproof.
₹10.00 (Price is Exclusive of GST)SW420 Tilt Ball switch 2801 ball sensor
₹10.00 (Price is Exclusive of GST)24 Pin IC Base – DIP IC Socket Connector
- Product type: IC base
- Function: to easy insert, remove and reinsert the programmable chips and ICs in the PCD and neglect the component damage because of heat during soldering
- Number of pins: 24
- Package contains: 5 x 24 pin IC base
₹10.00 (Price is Exclusive of GST)24 Pin IC Base – DIP IC Socket Connector
₹10.00 (Price is Exclusive of GST)40 Pin IC Base – DIP IC Socket Connector
- Product type: IC base
- Function: to easy insert, remove and reinsert the programmable chips and ICs in the PCD and neglect the component damage because of heat during soldering
- Number of pins: 40
- Package contains: 5 x 40 pin IC base
₹10.00 (Price is Exclusive of GST)40 Pin IC Base – DIP IC Socket Connector
₹10.00 (Price is Exclusive of GST)Glue Stick 10 MM for Glue Gun
Glue Stick 10 MM used for prototyping purposes. It can be used with big Glue Gun. The stick diameter is 10mm.
₹10.00 (Price is Exclusive of GST)Glue Stick 10 MM for Glue Gun
₹10.00 (Price is Exclusive of GST)- ₹10.00 (Price is Exclusive of GST)
100E 10W 5% Axial Lead Ceramic Encased White Wire Wound Resistors
₹10.00 (Price is Exclusive of GST) - ₹10.00 (Price is Exclusive of GST)
50E 5W% Axial Lead Ceramic Encased White Wire Wound Resistors
₹10.00 (Price is Exclusive of GST) - ₹10.00 (Price is Exclusive of GST)
68E 5W 5% Axial Lead Ceramic Encased White Wire Wound Resistors
₹10.00 (Price is Exclusive of GST) - ₹10.00 (Price is Exclusive of GST)
3E9 10W 5% Axial Lead Ceramic Encased White Wire Wound Resistors
₹10.00 (Price is Exclusive of GST) 47K ohm Resistor – 1 Watt (5 Pieces Pack)
Features
Electronics Components Passive Components Electronics Components Type Resistors Resistor Type Carbon Film Resistor Resistance Value 47 Ohms Power Rating of Resistor 1 Watt Tolerance 5% ₹10.00 (Price is Exclusive of GST)47K ohm Resistor – 1 Watt (5 Pieces Pack)
₹10.00 (Price is Exclusive of GST)
