-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
-
L clamp for Johnson Gear Motor Mounting
- Material: Mild Steel
- Thickness: 1.5 mm
- Motor Mounting Hole: 3 mm
- Bracket Mounting Hole: 3 mm
- Weight: 18 gm (each)
₹12.00 (excl. GST)L clamp for Johnson Gear Motor Mounting
₹12.00 (excl. GST) -
100 RPM Johnson Geared Motor
- Base Motor RPM: 18000
- Operating Voltage: 6-18 V
- Rated Voltage: 12 V
- Rated Torque: 5.7 kg-cm
- Stall Torque: 37.6 kg-cm
- Gearbox Dimensions: 25×37 (LxW) mm
₹315.00 (excl. GST)100 RPM Johnson Geared Motor
₹315.00 (excl. GST) -
Flysky FS-I610 channel 2.4GHz AFHDS RC Transmitter with FS-iA6B Receiver
Features:
This radio system uses a high gain and multi directional antenna ;\Power: 6V (1.5V AA*4) ;
Transmitting Power:Â 20dBm ;
RF Receiver Sensitivity: -105dbm ;
Low Voltage Warning (V):Â 4.2
₹4,900.00 (excl. GST)Flysky FS-I610 channel 2.4GHz AFHDS RC Transmitter with FS-iA6B Receiver
₹4,900.00 (excl. GST) -
₹3,900.00 (excl. GST)Flysky CT6B Remote 6 Channel Transmitter and Receiver
₹3,900.00 (excl. GST) -
Durable Rubber Tire Yellow BO Motor Wheel
- Tire with sponge liner for more strength
- With upgraded tire tread for greater friction
- New design wheel for better combination with the motor
- Diameter: 65 mm
- Width : 28 mm
- The material of Wheel: High-strength plastic
- The material of Tyre: Rubber
- Color: Yellow
₹28.00 (excl. GST)Durable Rubber Tire Yellow BO Motor Wheel
₹28.00 (excl. GST) -
DC Straight BO Motor for Smart Car Robot
- Operating Voltage(VDC): 3~12
- Shaft Length (mm): 8.5
- Shaft Diameter (mm): 5.5 (Double D-type)
- No Load Current: 40-180mA.
- Rated Speed(After Reduction): 300 RPM
- Rated Torque: 0.35 Kgcm
₹55.00 – ₹75.00 (excl. GST)DC Straight BO Motor for Smart Car Robot
₹55.00 – ₹75.00 (excl. GST) -
DC Pump 24V 150PSI for Mist Fog Spray in Sanitizer Dispenser Tunnel
- Watering configuration: much the same, additional sprinklers and timers are required
- The price is the price of a pump, without other accessories
- Maximum pressure: 0.48MP.
₹1,500.00 (excl. GST)DC Pump 24V 150PSI for Mist Fog Spray in Sanitizer Dispenser Tunnel
₹1,500.00 (excl. GST) -
DC Motor 2000 RPM – 3V to 6V
Features:
Length: 25mm
Diameter:21mm
Shaft Diameter:2mm
Shaft Length:9mm
Voltage:3-5V₹20.00 (excl. GST)DC Motor 2000 RPM – 3V to 6V
₹20.00 (excl. GST) -
DC Mini Horizontal Submersible Pump
- Operating Voltage : 2.5 ~ 6V
- Operating Current : 130 ~ 220mA
- Flow Rate : 80 ~ 120 L/H
- Maximum Lift : 40 ~ 110 mm
- Outlet Outside Diameter: 7.5 mm
₹35.00 (excl. GST)DC Mini Horizontal Submersible Pump
₹35.00 (excl. GST) -
DC L-Shaped BO Motor for Smart Car Robot
- Low density: lightweight, low inertia.
- Capability to absorb shock and vibration as a result of elastic compliance.
- Ability to operate with minimum or no lubrication, due to inherent lubricity.
- The relatively low coefficient of friction.
- Operating Voltage(VDC): 3~12
- Shaft Length (mm): 8.5
- Shaft Diameter (mm): 5.5 (Double D-type)
- No Load Current: 40-180mA.
- Rated Speed(After Reduction): 150 RPM
- Rated Torque: 0.8 Kgcm
-
DC Geared Motor Clamp for Mounting
- Material: Mild Steel
- Thickness: 1.5 mm
- Motor Mounting Hole: 3 mm
- Bracket Mounting Hole: 3 mm
- Weight: 18 gm (each)
₹27.00 (excl. GST)DC Geared Motor Clamp for Mounting
₹27.00 (excl. GST) -
DC Geared Motor – 12V (10 to 1000 RPM)
- DC supply: 4 to 12V
- Total length: 46mm
- Motor diameter: 36mm
- Motor length: 25mm
- Brush type: Precious metal
- Gear head diameter: 37mm
- Gear head length: 21mm
- Output shaft: Centred
- Shaft diameter: 6mm
- Shaft length: 22mm
- Gear assembly: Spur
- Same size motor available in various RPM
