-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
-
Raspberry Pi 5 MP Camera Module
Raspberry Pi 5 MP Camera Module is a portable light weight camera that supports Raspberry Pi. It communicates with Pi using the MIPI camera serial interface protocol. It is normally used in image processing, machine learning or in surveillance projects. It is commonly used in surveillance drones since the payload of camera is very less. Apart from these modules Pi can also use normal USB webcams that are used along with computer.
₹450.00 (excl. GST)Raspberry Pi 5 MP Camera Module
₹450.00 (excl. GST) -
Raspberry Pi Pico
Designed by Raspberry Pi, RP2040 features a dual-core Arm Cortex-M0+ processor with 264KB internal RAM and support for up to 16MB of off-chip Flash. A wide range of flexible I/O options includes I2C, SPI, and — uniquely — Programmable I/O (PIO). These support endless possible applications for this small and affordable package.
₹290.00 (excl. GST)Raspberry Pi Pico
₹290.00 (excl. GST) -
Raspberry Pi Zero 2 W
At the heart of it is a 1GHz BCM2710A1 with 64-bit ARM Cortex-A53 CPU with 512MB RAM. Quite frankly, this Pi is about four times faster than the original Raspberry Pi and is only a fraction of the cost of the current RPi3.
Features-
- Input voltage(V) – 5V DC 2.5A
- Bluetooth Version – 4.2
- Operating Temperature Range( °C) – -20 to 70
₹950.00 (excl. GST)Raspberry Pi Zero 2 W
₹950.00 (excl. GST) -
RC4558P Operational Amplifiers
RC4558P Operational Amplifier
Subcategory:Amplifier ICs
Supply Type:Single, Dual
Technology:Bipolar
Voltage Gain dB:109.54 dB
Width:6.35 mm
Unit Weight:440.400mg
₹23.00 (excl. GST)RC4558P Operational Amplifiers
₹23.00 (excl. GST) -
RCWL-0516 Microwave Radar Human Body Induction Switch Module Intelligent Sensor
- Transmission signal processing control chip RCWL-9196.
- Wide operating voltage range 4.0V to 28.0V
- Penetrating detection capability, compared with the traditional infrared feeling PIR
- Adjustable Block time and distance
- 3.3V output power supply
₹40.00 (excl. GST) -
Readytosky 80A ESC 2-6S Brushless ESC Speed Controller for RC Drone
Features:
- Security power function: When the power is turned on, regardless of the throttle stick at any position will not start the motor immediately to prevent personal injury
- Throttle range calibrated function: to adapt the throttle differences between different strokes, improve the linearity of throttle response
- programmed project (available throttle stick or card LED parameter settings):
- Brake setting: No brake / with brake
- Battery Type: Lithium battery / NiMH
- Low Voltage Protection Mode: Soft Shutdown / hard off
- Low Voltage Protection Threshold: low / medium / high
- start mode: Normal / Soft / Super-soft and start
- Timing: low / medium / high
- Restore factory defaults
- Comprehensive protection features:
- Under-voltage protection: the program set by the user when the battery voltage is below the protection threshold, ESC automatically reduces the output power
- Overvoltage Protection: input voltage exceeds the input range are not allowed to start, automatic protection, also issued a hasty “beep” Warning
- Overheat protection: built-in temperature detection circuit that automatically reduces the output power ESC temperature is too high
- Remote signal loss protection: remote control signal is lost for 1 second to reduce the power, and then have two seconds to turn off without the remote control signal output
₹1,866.00 (excl. GST)Readytosky 80A ESC 2-6S Brushless ESC Speed Controller for RC Drone
₹1,866.00 (excl. GST) -
₹540.00 (excl. GST)Red 2WD Aluminum Smart Robot Car Chassis Kit DIY
₹540.00 (excl. GST) -
Resistance Box Assorted
-Precision quality with 12 mm thick rectangular brass blocks and silk covered non-inductive windings
– Coils are connected with double nut systems are fitted in spray painted teak wood box, standard quality
– Accuracy 0.05 to 0.1%
– These Boxes are available in several ranges₹22.00 (excl. GST)Resistance Box Assorted
₹22.00 (excl. GST) -
Resistor 5 Watt 220 Ohm Resistance Axial Lead Ceramic Cement Power Resistor
Product:5W 220 Ohm,
cement resistorPower:5W
Resistance:220 Ohm
Body material:Cement
Tolerance: +/-5%
Color: White
Body Size (approx. ):0.87 x 0.37 x 0.37inch / 22 x 9.5 x 9.5mm(L * W * H)
Lead length(approx. ):0.8inch/21mm,
Lead diameter(approx. ): 0.026 inch/0.65mmPer Piece,
Weight(approx. ):0.18oz/5g
PACKAGE CONTENT: 5 x Cement Resistors
₹140.00 (excl. GST)Resistor 5 Watt 220 Ohm Resistance Axial Lead Ceramic Cement Power Resistor
₹140.00 (excl. GST) -
Resistor 5 Watt 5 Ohm Resistance Axial Lead Ceramic Cement Power Resistor
Product:5W 220 Ohm,
cement resistorPower:5W
Resistance:5 Ohm
Body material:Cement
Tolerance: +/-5%
Color: White
Body Size (approx. ):0.87 x 0.37 x 0.37inch / 22 x 9.5 x 9.5mm(L * W * H)
Lead length(approx. ):0.8inch/21mm,
Lead diameter(approx. ): 0.026 inch/0.65mmPer Piece,
Weight(approx. ):0.18oz/5g
PACKAGE CONTENT: 5 x Cement Resistors
₹55.00 (excl. GST)Resistor 5 Watt 5 Ohm Resistance Axial Lead Ceramic Cement Power Resistor
₹55.00 (excl. GST) -
Resistor Kit 150 Pieces 30 Values 1/4W for Electronics DIY
- Carbon film assorted resistors
- 30 values
- Quantity: 150 pieces (5 each)
- Tolerance: 5%
- Power Rating: 0.25 wat
₹150.00 (excl. GST)Resistor Kit 150 Pieces 30 Values 1/4W for Electronics DIY
₹150.00 (excl. GST)
