-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
-
Sim900A GSM Modem Module
- Quad-band 850/900/1800/1900MHz.
- GPRS class 2/10.
- Input Voltage : 9V-12V DC.
- Control via AT commands (3GPP TS 27.007, 27.005 and SIMCOM enhanced AT command set).
- Configurable baud rate.
- Built-in SIM Card holder.
- Built-in Network Status LED.
₹900.00 (excl. GST)Sim900A GSM Modem Module
₹900.00 (excl. GST) -
Stainless Steel Digital Vernier Caliper-150mm
- Â caliper type: digital calipers
- diy supplies: metalworking measurement range: 0-150mm
- good quality product
₹900.00 (excl. GST)Stainless Steel Digital Vernier Caliper-150mm
₹900.00 (excl. GST) -
37 in 1 Sensor Kit
37 in 1 Sensor Kit is a sensor kit with 37 different types of sensors. It can be used for various DIY projects and application according to the need.
₹950.00₹1,090.00(excl. GST)37 in 1 Sensor Kit
₹950.00₹1,090.00(excl. GST) -
Optical Fingerprint Reader R307 Sensor Module
- Integrated image collecting and algorithm chip together, ALL-in-One
- Low power consumption, small size, excellent performance. Please be informed that the product required prior knowledge regarding the usage.
- Good image processing capabilities can successfully capture an image up to resolution 500 dpi.
- Fingerprint reader can conduct secondary development, can be embedded into a variety of end products
- Professional optical technology, precise module manufacturing techniques.
₹950.00₹1,050.00(excl. GST)Optical Fingerprint Reader R307 Sensor Module
₹950.00₹1,050.00(excl. GST) -
Stanley STHT62511-8 9-way Screwdriver
Stanley STHT62511 Screwdriver are essential tools to carry out many of your household activities such as repairing and fixing. From assembling furniture to fixing up an old machine, it is used in fixing a number of things. STANLEY tools provides a set of 9 screwdriver set in different sizes which will come in handy for your house hold repairing needs.
₹950.00 (excl. GST)Stanley STHT62511-8 9-way Screwdriver
₹950.00 (excl. GST) -
Raspberry Pi Zero 2 W
At the heart of it is a 1GHz BCM2710A1 with 64-bit ARM Cortex-A53 CPUÂ with 512MB RAM. Quite frankly, this Pi is about four times faster than the original Raspberry Pi and is only a fraction of the cost of the current RPi3.
Features-
- Input voltage(V) – 5V DC 2.5A
- Bluetooth Version – 4.2
- Operating Temperature Range( °C) – -20 to 70
₹950.00 (excl. GST)Raspberry Pi Zero 2 W
₹950.00 (excl. GST) -
Intelligent road gate machine Science Kit Diy Kit
Category: Synthesis of Wooden ToysMaterial: Poplar WoodUsage: Puzzle₹950.00 (excl. GST)Intelligent road gate machine Science Kit Diy Kit
₹950.00 (excl. GST) -
₹958.00 (excl. GST)SeeedStudio Seeeduino Xiao SAMD21 (Pre-Soldered)
₹958.00 (excl. GST) -
₹970.00 (excl. GST) -
Q250 Quadcopter Super Strong Carbon Fiber 4mm Arm FPV Racing Frame(250mm) Kit
Q250 Quadcopter
Features :
- Lightweight and Durable.
- Made by super strong and advanced engineering material.
- The frame has excellent strength.
- The arm equips dampers for the safe landing.
- The arm has multiple motor mounting holes.
- Equips vibration-free mounting bracket for FPV camera.
₹975.00 (excl. GST)Q250 Quadcopter Super Strong Carbon Fiber 4mm Arm FPV Racing Frame(250mm) Kit
₹975.00 (excl. GST) -
Auto Hand Sanitizer Dispenser Kit with Ultrasonic HCSR-04 Sensor Module, Relay, Pump, Power Supply and Jumper Wires – V2
- Best kit for making automatic hand sanitizer dispenser machine.
- Automatic Relay Controller Board
- Easy to use DIY Kit with IR Sensor Module and 9v DC Water Pump
- Use 12v, 2 Ampere Adapter for best result
₹990.00 (excl. GST) -
Orange Lithium Polymer battery Pack 2200mAh 2S 30C/60C (7.4V)
Safety Precautions :
- Avoid over-charging or over-discharging the batteries.
- Do n0t put it beside the high-temperature condition.
- Don’t throw it into the fire or Water
Features :
- Product Type: Lithium Polymer Battery Pack
- The Orange LiPo battery has matched resistance.
- Good Temperature Control.
- Minimum weight in Class
₹1,010.00 (excl. GST)Orange Lithium Polymer battery Pack 2200mAh 2S 30C/60C (7.4V)
₹1,010.00 (excl. GST)
