-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
-
White Type C cable – 1m for Arduino Nano V3.0
Features:
- Allows you to connect Arduino NanoV3.0 with USB port to the computer.
- Good data transfer rate.
₹37.62 (excl. GST)White Type C cable – 1m for Arduino Nano V3.0
₹37.62 (excl. GST) -
DC Male Power Jack, Adapter Connector Plug For CCTV, Camera -(2.1 x 5.5mm)Pack of 2
DC Male Power Jack
Specifications:
- 2.1 x 5.5mm CCTV Camera DC Power Plug Connector.
- DC Power Plug with plastic construction and strain relief.
- This 2.1 x 5.5mm Power Plug features one power connector end DC plug male to another end terminal for CCTV camera connected.
- The internal diameter of the plug: 2.1mm
- The external diameter of the plug: 5.5mm
₹36.00 (excl. GST) -
3K3 10W Resistor 5% – (Pack of 5)
Specification
- Tolerance – 5%
- Power Rating – 3 W
- Resistance – 1 Ohm / 1R
- Resistor Type: Wire Wound
₹36.00 (excl. GST)3K3 10W Resistor 5% – (Pack of 5)
₹36.00 (excl. GST) -
23 Teeth Straight Bevel Plastic Gear ID 6mm Round
Applications of bevel gears are as follows:
- They are used in differential drives, which can transmit power to two axles spinning at different speeds, as as those on a cornering automobile
- Bevel gears are used as the main mechanism for hand drills. The bevel gears have added an advantage of increasing the speed of rotation of the chuck and this makes it possible to drill a range of materials.
- Standard bevel gears are mainly used in low speed applications.
Features:
- Good Quality Material
- Light Weight
- Heavy Duty and Long Life
- Good Temperature and Environmental Resistance
₹36.00 (excl. GST)23 Teeth Straight Bevel Plastic Gear ID 6mm Round
₹36.00 (excl. GST) -
XT90 Male Connector with Housing (1pc)
Specifications and Features:
- Metal connector size: 4.5mm
- Housing shape provides protection against shorting and reverse polarity
- Can accept up to 8AWG wires
- Semicircular solder terminals make it easy to install wires
- Able to sustain 90A+ continuous current
₹36.00 (excl. GST)XT90 Male Connector with Housing (1pc)
₹36.00 (excl. GST) -
Pointed Bit Tip for Micro Soldering Iron
Features/Specs:
- suitable for:Â micro soldering Iron
- Material: Nickel
- Tip Type: Pointed
₹35.00 (excl. GST)Pointed Bit Tip for Micro Soldering Iron
₹35.00 (excl. GST) -
70 x 40 mm Pulley Wheel with 6mm Shaft Hole Diameter
Features :
- Smooth surface
- Durable
- Lightweight
₹35.00 (excl. GST)70 x 40 mm Pulley Wheel with 6mm Shaft Hole Diameter
₹35.00 (excl. GST) -
10uF (10000nF) 50V Capacitor – 1206 SMD Package – (pack of 5)
Features:
- Supplied in tape on reel
- Nickel-barrier end termination
- RoHS compliant
- Halogen Free compliant
₹35.00 (excl. GST)10uF (10000nF) 50V Capacitor – 1206 SMD Package – (pack of 5)
₹35.00 (excl. GST) -
CA3130EZ CMOS Op-Amp IC DIP-8 Package
Features
- MOSFET Input Stage Provides: – Very High ZI = 1.5 T (1.5 x 1012) (Typ) – Very Low II 5pA (Typ) at 15V Operation = 2pA (Typ) at 5V Operation
- Ideal for Single-Supply Applications
- Common-Mode Input-Voltage Range Includes Negative Supply Rail; Input Terminals can be Swung 0.5V Below Negative Supply Rail
- CMOS Output Stage Permits Signal Swing to Either (or both) Supply Rails
- Pb-Free Plus Anneal Available (RoHS Compliant)
Applications
- Frequency Generator/Distorter
- Mobile jammers
- Voltage follower circuits
- DAC circuits
- Peak Signal/Noise detectors
- Oscillator circuits
Physical Attributes
- Length * Width * Height (mm): 9 x 7 x 7
- Weight (gm) : 0.2
₹35.00 (excl. GST)CA3130EZ CMOS Op-Amp IC DIP-8 Package
₹35.00 (excl. GST) -
₹35.00 (excl. GST)12V DC Cooling Fan CPU cooler 4.75 INCH, Black
₹35.00 (excl. GST) -
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
DC Mini Horizontal Submersible Pump
- Operating Voltage : 2.5 ~ 6V
- Operating Current : 130 ~ 220mA
- Flow Rate : 80 ~ 120 L/H
- Maximum Lift : 40 ~ 110 mm
- Outlet Outside Diameter: 7.5 mm
₹35.00 (excl. GST)DC Mini Horizontal Submersible Pump
₹35.00 (excl. GST)
