-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
-
3.3 Ohm Carbon Film Resistor- Pack of 50 pcs
- Resistance Value: 3.3 Ohms
- Rated Power: 0.25 Watt (1/4W); Tolerance : +/- 5%
- Carbon Film Resistor – Through Hole; Flame Retardant Coating
- Stiff 24 gauge leads (0.022 inches, 0.55 mm) perfect for solderless plug-in breadboards
- Package Include 10 x 3.3 Ohm (Note: Color of resistor may change, so please contact us if you need specific color resistors
₹25.00 (excl. GST)3.3 Ohm Carbon Film Resistor- Pack of 50 pcs
₹25.00 (excl. GST) -
TL084 Quad JFET Input Operational Amplifier (Op-Amp) IC DIP
TL084 Quad Amplifier
Features:-
• Low Power Consumption: 1.4 mA/ch Typical
• Wide Common-Mode and Differential Voltage Ranges
• Low Input Bias Current: 30 pA Typical
• Low Input Offset Current: 5 pA Typical
• Output Short-Circuit Protection
• Low Total Harmonic Distortion: 0.003% Typical
• High Input Impedance: JFET Input Stage
• Latch-Up-Free Operation
• High Slew Rate: 13 V/μs Typical
• Common-Mode Input Voltage Range
• Includes VCC+
₹24.00 (excl. GST)TL084 Quad JFET Input Operational Amplifier (Op-Amp) IC DIP
₹24.00 (excl. GST) -
330K Ohm 2W Carbon Film Resistor 5% (Pack of 5)
Features-
Resistance: 330K Ohm,
Power Rating: 2 Watt,
Tolerance: 5 %
₹24.00 (excl. GST)330K Ohm 2W Carbon Film Resistor 5% (Pack of 5)
₹24.00 (excl. GST) -
Universal Aluminium Heat Sink 11 x 11 x 5 mm – 5Pcs.
Features:
- Prevents overheating of board
- Absorbs heat quickly
- Fast cooling
- Quantity of blade: 4
- Material: Aluminum
- Color: Silver
₹23.76₹35.00(excl. GST)Universal Aluminium Heat Sink 11 x 11 x 5 mm – 5Pcs.
₹23.76₹35.00(excl. GST) -
RC4558P Operational Amplifiers
RC4558P Operational Amplifier
Subcategory:Amplifier ICs
Supply Type:Single, Dual
Technology:Bipolar
Voltage Gain dB:109.54 dB
Width:6.35 mm
Unit Weight:440.400mg
₹23.00 (excl. GST)RC4558P Operational Amplifiers
₹23.00 (excl. GST) -
FRC connector male 8 pin (Pack of 2)
-
Features/Specs:
- Gender: Female
- Connector Type: IDC
- Current Rating: 2A
- Mounting Type: Cable Mount
- Number Of Contacts: 8
- Number Of Rows: 2
- Pitch: 2.54mm
- Contact Material: Phosphor Bronze
- Minimum Operating Temperature: -65°C
- Maximum Operating Temperature: +105°C
- Housing Material: Thermoplastic
- Contact Plating: Nickel-plated terminals
- Color: Black
₹22.00 (excl. GST)FRC connector male 8 pin (Pack of 2)
₹22.00 (excl. GST) -
-
FRC connector Female 8 pin (Pack of 2)
-
Features/Specs:
- Gender: Female
- Connector Type: IDC
- Current Rating: 2A
- Mounting Type: Cable Mount
- Number Of Contacts: 8
- Number Of Rows: 2
- Pitch: 2.54mm
- Contact Material: Phosphor Bronze
- Minimum Operating Temperature: -65°C
- Maximum Operating Temperature: +105°C
- Housing Material: Thermoplastic
- Contact Plating: Nickel-plated terminals
- Color: Black
₹22.00 (excl. GST)FRC connector Female 8 pin (Pack of 2)
₹22.00 (excl. GST) -
-
Digital LDR Sensor Module for Light Detection Sensing
Features :
- LM393 based design.
- It can detect ambient brightness and light intensity.
- Adjustable sensitivity (via blue digital potentiometer adjustment).
- Output Digital – 0V to 5V, Adjustable trigger level from preset.
- LEDs indicating output and power.
₹22.00 (excl. GST)Digital LDR Sensor Module for Light Detection Sensing
₹22.00 (excl. GST) -
Resistance Box Assorted
-Precision quality with 12 mm thick rectangular brass blocks and silk covered non-inductive windings
– Coils are connected with double nut systems are fitted in spray painted teak wood box, standard quality
– Accuracy 0.05 to 0.1%
– These Boxes are available in several ranges₹22.00 (excl. GST)Resistance Box Assorted
₹22.00 (excl. GST) -
TTP223B Digital Capacitive Touch Sensor Module
- Low power consumption.
- Power supply for 2 ~ 5.5V DC
- Can replace the traditional touch of a button, touch area.
- Four m2 screws positioning holes for easy installation, power indicator green led, power on the right that is shiny.
- Control interface : A total of three pins (gnd, vcc, sig), gnd to ground , vcc is the power supply , sig digital signal output pin.
₹22.00₹35.00(excl. GST)TTP223B Digital Capacitive Touch Sensor Module
₹22.00₹35.00(excl. GST) -
NE5532 Dual Noise High-Speed Audio Operational Amplifier IC DIP-8 Package
NE5532
Features:-
• Equivalent Input Noise Voltage:
• 5 nV/√Hz Typ at 1 kHz
• Unity-Gain Bandwidth: 10 MHz Typ
• Common-Mode Rejection Ratio: 100 dB Typ
• High DC Voltage Gain: 100 V/mV Typ
• Peak-to-Peak Output Voltage Swing 26 V Typ With VCC± = ±15 V and RL = 600 Ω
• High Slew Rate: 9 V/μs Typ
₹20.00 (excl. GST)NE5532 Dual Noise High-Speed Audio Operational Amplifier IC DIP-8 Package
₹20.00 (excl. GST) -
PAM8403 5V Two-channel Stereo Mini Class-D 3W+3W Audio Amplifier
PAM8403
    Application :
- Bluetooth Stereo Audio hands-free/headsets
- In robots that speak or generate sounds to indicate activities
- Portable Speakers
- LCD Monitors / TV Projectors
- Arduino or Raspberry Pi Game Machines
- Speaker Phones
₹20.00 (excl. GST)PAM8403 5V Two-channel Stereo Mini Class-D 3W+3W Audio Amplifier
₹20.00 (excl. GST)
