-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹638.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹638.00(Price is Exclusive of GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹264.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹264.00 (Price is Exclusive of GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST) -
ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
- This DHT11 temperature and humidity sensor shield is specially designed for ESP8266 ESP-01 ESP-01S development board.
- On-board 8pin socket enable you plug the wifi transceiver to the board directly perfect for DIY your wireless temperature/humidity webserver system.
- Working Voltage: DC 3.7 – 12V
- The weight of about 10 grams
- Package Included: 1 X DHT11 Humidity Temperature Sensor
₹130.00 (Price is Exclusive of GST)ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
₹130.00 (Price is Exclusive of GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹207.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹207.00 (Price is Exclusive of GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)
-
Samsung INR18650-25R 2500Mah (8C) Li-Ion Battery
- Brand: SAMSUNG
- Model: INR 18650 Lithium Battery
- Battery Capacity: 2500mAh
- Nominal Voltage: 3.7V
- Rechargeable: Yes
- Charging time; Standard charge 3hours/100mA deadline
- Quick charge: 1hours/100mA deadline (25 °C)
₹393.00 (Price is Exclusive of GST)Samsung INR18650-25R 2500Mah (8C) Li-Ion Battery
₹393.00 (Price is Exclusive of GST) -
2WD Mini Round Double-Deck Smart Robot Car Chassis DIY Kit
2 x Gear Motor
4 x “T” mode Fixed Motor Bracket
16 x M3X10mm Screw
8 x M3 Nut
4 x M3X12+6mm Copper Cylinder
4 x M3X30mm two-way Copper Colum₹399.00 (Price is Exclusive of GST)2WD Mini Round Double-Deck Smart Robot Car Chassis DIY Kit
₹399.00 (Price is Exclusive of GST) -
VL53L0X Time Flight (ToF) Laser Ranging Sensor Breakout 940nm GY-VL53L0XV2 Laser Distance Module I2C IIC
- Maximum Sensoring Distance: 2m
- Working Voltage: 2.6V – 5.5V
- Communication mode: serial output, PWM output, the chip itself IIC output.
- Default configuration: serial baud rate 9600, automatic output, high precision mode.
₹400.00 (Price is Exclusive of GST)VL53L0X Time Flight (ToF) Laser Ranging Sensor Breakout 940nm GY-VL53L0XV2 Laser Distance Module I2C IIC
₹400.00 (Price is Exclusive of GST) -
5 in 1 Stainless Steel Tweezer Set
- This craft tweezer set made of high strength stainless steel with, process by heat treatment and hardening to make the tweezers high elasticity
- The tip of the tweezers has a high hardness and can be used for precise operation such as board soldering or watch repair.
- We have a professional team and always ready to provide the best service
₹400.00 (Price is Exclusive of GST)5 in 1 Stainless Steel Tweezer Set
₹400.00 (Price is Exclusive of GST) -
Drill Bit Set Combo HSS-13 Pcs
- Industrial quality for smooth accurate drilling
- Use on plastic, metal and wood
- HSS drill set with standard 1/4″ hex shank that will fit
- cordless screwdrivers, drills etc or use in standard drill chuck.
₹400.00 (Price is Exclusive of GST)Drill Bit Set Combo HSS-13 Pcs
₹400.00 (Price is Exclusive of GST) -
Orange 12V 20 RPM Johnson Geared DC Motor Grade A Quality Encoder Compatible
Features :
- Grade A Quality branded Johnson DC Motor.
- It has sturdy construction.
- Shaft equips metal bushes for long life.
- It comes with High-Quality gears.
- The shaft has a hole for better coupling.
₹400.00 (Price is Exclusive of GST)Orange 12V 20 RPM Johnson Geared DC Motor Grade A Quality Encoder Compatible
₹400.00 (Price is Exclusive of GST) -
SanDisk Micro SD/SDHC 32GB Class 10 Memory Card
- SanDisk 32GB Memory Card
- Card Type: Micro SD
- Speed: up to 98MB/s
- Class: 10
- High-speed Card can be used for both Mobile phone and Raspberry Pi
- 5 years of manufacturing defect Warranty Given by Sandisk.
₹402.00 (Price is Exclusive of GST)SanDisk Micro SD/SDHC 32GB Class 10 Memory Card
₹402.00 (Price is Exclusive of GST) -
Molicel A Grade INR-18650-P28A 3.6V 2800mAh 13C Li-ion Battery
- Manufacturer Rated Capacity: 2800mAh
- Manufacturer Rated Standard Discharge Capacity: 2600mAh (Minimum)
- Manufacturer Rated Max Discharge Current: 35A
- Nominal Voltage: 3.6V
- Peak Voltage: 4.2V
- Certifications: UN38.3, UL1642, IEC 62133
- Cost-Effective
- High power density
- Easy maintenance
₹404.00 (Price is Exclusive of GST)Molicel A Grade INR-18650-P28A 3.6V 2800mAh 13C Li-ion Battery
₹404.00 (Price is Exclusive of GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST) -
PIR Motion Sensor Switch with Light Sensor for Home Automation
- PIR Motion Sensor Switch can use with lamps, incandescent lamps (bulbs), old-fashioned fluorescent lamps, electronic fluorescent ring lamps, spotlights, transformers, small electrical appliances, and other all other appliance
- Good solution for energy saving and easy in installation. and Delay adjustment: 10 Seconds – 7 Minutes and Adjustable Lux: turn on the lights during the day or night
- Sensitivity Adjustable: Turn on Lights during Day or nights
₹410.00 (Price is Exclusive of GST)PIR Motion Sensor Switch with Light Sensor for Home Automation
₹410.00 (Price is Exclusive of GST) -
1m Cable Drag Chain 10 x 15mm Wire Carrier
Features :
- Reinforced nylon with high pressure and tensile load, good toughness, high elasticity and abrasion resistance, flame retardant,
- high-temperature stable performance can be used outdoors, nylon towline content determines how much to use strength and
- wear resistance and noise level up and running.
- Resistance to: oil, salt, and a certain acid, alkali capacity.
- Speed and acceleration (specific speed, acceleration, as the case may be running).
- Long operating life.
- Chain shape like gram chain link by a large number of units composed of freely rotating between links.
- A unit chain around the chain plate and the upper and lower cover plates, towline can open each section, easy assembly and disassembly without threading, to the cable, tubing, pipe, pipe, etc. into the towline open the cover.
₹410.00 (Price is Exclusive of GST)1m Cable Drag Chain 10 x 15mm Wire Carrier
₹410.00 (Price is Exclusive of GST) -
UREC ESD Splicing Tape, Yellow, 8 mm, 1 Box (500 Tapes), Pack of 1 Box
Brand UREC ESD Colour Yellow Material Polyester Number of Items 1 Recommended Uses For Product Film Editing, Film Preservation ₹410.00 (Price is Exclusive of GST)UREC ESD Splicing Tape, Yellow, 8 mm, 1 Box (500 Tapes), Pack of 1 Box
₹410.00 (Price is Exclusive of GST)






















