-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (excl. GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (excl. GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (excl. GST)Capacitive Soil Sensor V2.0
₹60.00 (excl. GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (excl. GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(excl. GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(excl. GST) -
Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (excl. GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (excl. GST)
-
Stainless Steel Digital Vernier Caliper-150mm
- Â caliper type: digital calipers
- diy supplies: metalworking measurement range: 0-150mm
- good quality product
₹900.00 (excl. GST)Stainless Steel Digital Vernier Caliper-150mm
₹900.00 (excl. GST) -
Stanley 12 Pieces Spanner Set, 70-380E
- Anti-slip design on open end.
- Chrome Vanadium Steel.
- Matte Finsih.
₹650.00 (excl. GST)Stanley 12 Pieces Spanner Set, 70-380E
₹650.00 (excl. GST) -
STANLEY 66-052 Bi Material Handle Precision Screwdriver Set (6 Piece)
Bi-material handle design
Tips hardened to 53 HRC
Chrome vanadium steel blade with black oxide finish
Overall length 110mm
Set contains Philips No. 0,1, Slotted tip 1.4, 2.0, 2.4, 3.0mm₹550.00 (excl. GST)STANLEY 66-052 Bi Material Handle Precision Screwdriver Set (6 Piece)
₹550.00 (excl. GST) -
STANLEY 84-214-22 130mm/5.25” Wire Stripper (Black and Yellow)
FEATURES & BENEFITS
- Adjustable slide stop and hole designed for bending and looping wire
- Oil-resistant dipped handle allows for a comfortable grip
- Meets ANSI specifications
₹250.00 (excl. GST)STANLEY 84-214-22 130mm/5.25” Wire Stripper (Black and Yellow)
₹250.00 (excl. GST) -
Stanley 84-214-22 Wire Stripper 130mm
- Size: 130mm / 5 1/4- Inch
- Convenient hole for looping or bending wire
- Ideal for cutting, stripping speaker wire, appliance cords, etc
- Slide adjust for various gauge wire
₹200.00 (excl. GST)Stanley 84-214-22 Wire Stripper 130mm
₹200.00 (excl. GST) -
Stanley Adjustable Wrench
Features
- Forged chrome vanadium steel construction for improved rigidity and durability providing long service life
- Black phosphate finish provides superb corrosion and abrasion resistance and improved grip for confident operation
- Etched measurement markings on jaw opening in both metric and SAE for convenient identification of fastener sizing
₹220.00 (excl. GST)Stanley Adjustable Wrench
₹220.00 (excl. GST) -
Stanley Allen Key Set
- Material: Metal
- Package Contains Hex Key Size: 1.5mm, 2mm, 2.5mm, 3mm ,4mm, 5mm, 6mm, 8mm, 10mm ball tips
- Made using chrome vanadium steel so will resist corrosion
- Anti-corrosion treatment
₹500.00 (excl. GST)Stanley Allen Key Set
₹500.00 (excl. GST) -
Stanley Bent Nose Pliers 200mm
The angled nose is capable of gripping and maneuvering objects in obstructed situations
Bent nose plier 6”, 8” carbon steel polished₹300.00 (excl. GST)Stanley Bent Nose Pliers 200mm
₹300.00 (excl. GST) -
Stanley Combination Mini Plier, For Cutting, Size: 205 mm
- Color: Yellow and Black, Material: Plastic and Sturdy Steel
- Jaws and Cutting Edge are Induction Hardened & Tempered
- Black phosphate finish anti-rust protected
- Anti-rust Protected
- Package Contents: 1-Piece Plier
- Limited lifetime warranty offered on the product
₹450.00 (excl. GST)Stanley Combination Mini Plier, For Cutting, Size: 205 mm
₹450.00 (excl. GST) -
Stanley Hot Glue Gun 69-GR20B
Secure your wooden furniture or the fabric cover of your cushions with the Stanley 69-GR20B Standard Temperature Corded
₹780.00 (excl. GST)Stanley Hot Glue Gun 69-GR20B
₹780.00 (excl. GST) -
Stanley PLIER Long Nose, 203mm-8
- Features – Forged Steel Construction, Double dipped handles, Rust Resistant Finish
- Specifications – Part No. 84-102, Size: 203mm / 8″ Long Nose Plier
- Applications – Electric and Household applications
₹400.00 (excl. GST)Stanley PLIER Long Nose, 203mm-8
₹400.00 (excl. GST) -
Stanley STHT62511-8 9-way Screwdriver
Stanley STHT62511 Screwdriver are essential tools to carry out many of your household activities such as repairing and fixing. From assembling furniture to fixing up an old machine, it is used in fixing a number of things. STANLEY tools provides a set of 9 screwdriver set in different sizes which will come in handy for your house hold repairing needs.
₹950.00 (excl. GST)Stanley STHT62511-8 9-way Screwdriver
₹950.00 (excl. GST)