NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹390.00 (Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (Price is Exclusive of GST)
Taparia PTB16 Compact Plastic Tool Box with Organizer
It Is Available With Metal Rod Hinges That Help You Carry More Load Easily. Store All The Small Objects And Fasteners In The Organiser Sections Available On The Top. It Is Highly Portable And Keeps Your Metal Organized. It Has Latch Type Lock That Locks
₹1,200.00 (Price is Exclusive of GST)Taparia PTB16 Compact Plastic Tool Box with Organizer
₹1,200.00 (Price is Exclusive of GST)TB6600 Stepper Motor Driver Controller
Features :
- H bridge bipolar constant current drive.
- The biggest 4.0 A Eight kinds of output current are optional.
- The biggest 32 To subdivide 6 kinds of subdivision modes selectable.
- Input signal high-speed photoelectric isolation.
- A total of standard single pulse interface.
- Offline retention function.
- The semi-enclosed casing can adapt to a more stringent environment.
- Provide energy saving half automatic current lock function.
₹300.00 (Price is Exclusive of GST)TB6600 Stepper Motor Driver Controller
₹300.00 (Price is Exclusive of GST)TB6612 Motor Driver Module
Motor Driver Module
- Output current: Iout=1.2A(average) / 3.2A (peak)
- Standby control to save power
- CW/CCW/short break/stop motor control modes
- Built-in thermal shutdown circuit and a low voltage detecting circuit
- All pins of the TB6612FNG broken out to 0.1″ spaced pins
- Filtering capacitors on both supply lines
₹195.00 (Price is Exclusive of GST)TB6612 Motor Driver Module
₹195.00 (Price is Exclusive of GST)TC-50 5V 2Amp Super Fast Charger with 1 Meter USB Cable
- Colour- White
- Compatible with any Android phone
- Connector GenderFemale-to-Male
₹300.00₹325.00(Price is Exclusive of GST)TC-50 5V 2Amp Super Fast Charger with 1 Meter USB Cable
₹300.00₹325.00(Price is Exclusive of GST)TCRT 5000 Dual Channel Line Tracking sensor
Features :
- Designed with the reflected infrared sensor, indicator light.
- Built in a potentiometer for sensitivity control.
- On-board LM393 voltage comparator chip and infrared sensing probe TCRT5000L
- Onboard signal output instructions, the output is the highly effective signal at the same time, the indicator lamp light output signal can be directly and single-chip microcomputer IO connection & middot
- Signal detection sensitivity can adjust
- Reserve all the way more circuits (P3 voltage drawn)
- Using the TCRT5000 infrared reflection sensor
- Output form: digital switch output (0 and 1)
- A fixed bolt hole, convenient installation.
₹55.00 (Price is Exclusive of GST)TCRT 5000 Dual Channel Line Tracking sensor
₹55.00 (Price is Exclusive of GST)TCS34725 RGB Color Sensor Module
- Operating Voltage: 3.3V–5V.
- Communication Interface: I2C (default address: 0x29).
- Dynamic Range: 3,800,000:1 for various lighting environments.
- Measurement Range: Up to 16-bit resolution for clear and RGB data.
- Field of View: ±35°.
- Dimensions: Compact module for easy integration.
₹180.00 (Price is Exclusive of GST)TCS34725 RGB Color Sensor Module
₹180.00 (Price is Exclusive of GST)TEC1 12706 Thermoelectric Cooler 6A Peltier Module
Features:
Colour: white
Material: plastic + ceramics
Rated voltage: 12v
Rated power: 50~72w₹200.00 (Price is Exclusive of GST)TEC1 12706 Thermoelectric Cooler 6A Peltier Module
₹200.00 (Price is Exclusive of GST)Telemetry Kit 433Mhz 100MW
Telemetry Kit
Features :
- Very small size & Lightweight (under 4 grams without antenna)
- Transparent serial link
- MAVLink protocol framing and status reporting
- Frequency hopping spread spectrum (FHSS)
- Adaptive time division multiplexing (TDM)
- Support for LBT and AFA
- Configurable duty cycle
- Interchangeable air and ground modules
- Micro-USB port
- 6-position DF13 connector
- 100 mW maximum output power (adjustable)
- Based on HopeRF’s HM-TRP module
- RP-SMA connector
- 2-way full-duplex communication through adaptive TDM
- UART interface
- Transparent serial link
- MAVLink protocol framing
- Frequency Hopping Spread Spectrum (FHSS)
- Configurable duty cycle
- Error correction corrects up to 25% of bit errors
- Configurable through Mission Planner and APM Planner
- Built-in error correcting code (can correct up to 25% data bit errors)
- The demonstrated range of several kilometers with a small Omni antenna
- Can be used with a bi-directional amplifier for even more range
- AT commands for radio configuration
- RT commands for remote radio configuration
- Adaptive flow control when used with APM
- Based on the HopeRF HM-TRP radio module, featuring a SiLabs Si1000 RF microcontroller.
₹6,000.00 (Price is Exclusive of GST)Telemetry Kit 433Mhz 100MW
₹6,000.00 (Price is Exclusive of GST)Temperature Humidity Time Display Meter with Clock – Hygrometer Thermometer Sensor
- Temperature Humidity Display Meter
- Wireless outdoor and indoor temperature (Fahrenheit or Celsius)
- Measures temperature and humidity level
- 1 x HTC (main unit) and 1 x AAA 1.5v Battery
- Includes clock, day, date and alarm function
- Provides for flip out bracket for free standing or wall fixing
₹300.00 (Price is Exclusive of GST)Temperature Humidity Time Display Meter with Clock – Hygrometer Thermometer Sensor
₹300.00 (Price is Exclusive of GST)Tensioner Torsion Spring for GT2 6MM Timing Belt used in 3D Printer – 5Pcs
Tensioner Torsion Spring
5 x Tensioner Torsion Spring for GT2 6MM Timing Belt used in 3D Printer
₹40.00 (Price is Exclusive of GST)Tensioner Torsion Spring for GT2 6MM Timing Belt used in 3D Printer – 5Pcs
₹40.00 (Price is Exclusive of GST)Tensioner Torsion Spring for GT2 6MM Timing Belt-5Pcs
Features:
- Maintain optimal belt tension to ensure high-quality prints every time.
- it is compatible with 6mm GT2 timing belts.
- It will absorb belt vibration.
- It can be mounted on top of the belts and requires no removal.
₹80.00 (Price is Exclusive of GST)Tensioner Torsion Spring for GT2 6MM Timing Belt-5Pcs
₹80.00 (Price is Exclusive of GST)TF02-Pro LiDAR Distance Ranging Sensor FOR DRONES UAV UAS Robots (40M) IP65 LiDAR
Features:
- The range up to 40 meters
- Ambient light resistance(Up to 100Klux)
- High frame rate(up to 1000Hz)
- Low power consumption
- Wide range of temperature adaptation and voltage input.
- Has higher Accuracy and frequency.
- Richer Interface – UART/I2C/IO
₹5,576.00 (Price is Exclusive of GST)TF02-Pro LiDAR Distance Ranging Sensor FOR DRONES UAV UAS Robots (40M) IP65 LiDAR
₹5,576.00 (Price is Exclusive of GST)
