No products in the cart.
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹390.00 (Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (Price is Exclusive of GST)
PNP Transistor – BC557 and S8550
- Bi-Polar PNP Transistor
- DC Current Gain (hFE) is 300 maximum
- Continuous Collector current (IC) is 100mA
- Emitter Base Voltage (VBE) is 6V
- Base Current(IB) is 5mA maximum
Robo Car DIY Kit with UNO Line Follower Obstacle Detector Edge Detector Maze Solver
Package Contents:
1x UNO R3 Board with USB Cable
1x 2WD Robo Car Kit
4x IR Sensor Module
1x Ultrasonic Sensor
1x L293D Motor Driver Board
3x Jumper Wire , 1x Male to Male, 1x Male to Female, 1x Female to Female with 20 Wires Each₹1,400.00₹1,900.00(Price is Exclusive of GST)Robo Car DIY Kit with UNO Line Follower Obstacle Detector Edge Detector Maze Solver
₹1,400.00₹1,900.00(Price is Exclusive of GST)LED (Light Emitting Diode) 5MM
- Voltage : DC 1.5V – 3.0V
- Head Size (Approx) : 5mm
- Quantity: 60 Pieces (6 colors x 10pcs). Emitting Color: White/Red/Green/Blue/Yellow/Orange
- Every led diode are colored in head, use compartments to distinguish colors, easy to recognize and find the one you needed.
Arduino UNO DIY Kit – Professional Electronics Starter DIY Kit – V2
This DIY Kit with UNO R3, USB Cable, LEDs, Buzzer, Switch, Breadboard, Servo SG90 Motor, PIR Motion Sensor, Ultrasonic Sensor, LCD 16×2, 4×4 Keypad, IR sensors, Relay board, L293D Motor Driver Board, Male and Female Header Strips and Jumper Wires
₹1,699.99₹2,350.00(Price is Exclusive of GST)Arduino UNO DIY Kit – Professional Electronics Starter DIY Kit – V2
₹1,699.99₹2,350.00(Price is Exclusive of GST)YF-S201 Water flow sensor
Features:
- The simple and compact module.
- Easy to Install.
- High Sealing Performance.
- High-Quality Hall Effect Sensor.
- High amplitude: 4.6V
- Low amplitude: 0.5V
- Electric strength: 1250V/min
- Hydrostatic pressure testing: 2.0Mpa
- Insulation resistance: 100M
₹185.00 (Price is Exclusive of GST)YF-S201 Water flow sensor
₹185.00 (Price is Exclusive of GST)TTP224 4-channel Capacitive touch sensor Module
Feature:-
- Onboard capacitive touch sensor IC
- 4 board-level status indicator
- Working voltage: 2.4V – 5.5V
- Advanced Pins breakout, so that the output mode and working mode selectable.
- Low power selection
- PCB board size: 35 (mm) x 29 (mm)
₹72.00 (Price is Exclusive of GST)TTP224 4-channel Capacitive touch sensor Module
₹72.00 (Price is Exclusive of GST)MLX90614 Non-Contact Human Body Infrared Temperature Measurement Module
- Operating Voltage(V): 3- 5
- Operating Current(mA): 2
- Communication protocol: I2C
- Power saving mode
- Automotive grad
- Small size, low cost
₹1,500.00 (Price is Exclusive of GST)MLX90614 Non-Contact Human Body Infrared Temperature Measurement Module
₹1,500.00 (Price is Exclusive of GST)Force Sensor Resistor Square 38.1mm – Pressure Sensor
- Easily customizable to a wide range of sizes
- Cost-effective
- Ultra-thin; 0.45 mm
- Robust; up to 10 million actuations
- Simple and easy to Integrate.
₹290.00 (Price is Exclusive of GST)Force Sensor Resistor Square 38.1mm – Pressure Sensor
₹290.00 (Price is Exclusive of GST)- ₹115.00 (Price is Exclusive of GST)
ACS712 Test Current Sensor Module 20A
₹115.00 (Price is Exclusive of GST) ACS712 Test Current Sensor Module 5A
- Low-noise analog signal path.
- Device bandwidth is set via the new FILTER pin.
- 5 µs output rise time in response to step input current.
- Small footprint, low-profile SOIC8 package.
- 2.1 kV RMS minimum isolation voltage from pins 1-4 to pins 5-8.
₹115.00 (Price is Exclusive of GST)ACS712 Test Current Sensor Module 5A
₹115.00 (Price is Exclusive of GST)12 in 1 DIY Sensor Kit
Sensors Included:
PIR Motion Sensor HCSR501, Touch Sensor, Rain Sensor, Hear beat Sensor, Flame Sensor, Soil Moisture Sensor, Sound Sensor, Ultrasonic Sensor HCSR04, Temperature and Humidity Sensor DHT11, LDR Sensor, IR Sensor, Tilt Sensor.
₹550.00₹1,100.00(Price is Exclusive of GST)12 in 1 DIY Sensor Kit
₹550.00₹1,100.00(Price is Exclusive of GST)MQ9 Gas Carbon Monoxide, Methane and LPG Gas Sensor Module
- Good sensitivity to CO/Combustible Gas
- High sensitivity to Methane, Propane, and CO
- Long life and low cost
- Simple drive circuit
- Input voltage: DC 5±0.2V
- Current Consumption: 150mA
₹88.00 (Price is Exclusive of GST)MQ9 Gas Carbon Monoxide, Methane and LPG Gas Sensor Module
₹88.00 (Price is Exclusive of GST)
