-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹638.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹638.00(Price is Exclusive of GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹264.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹264.00 (Price is Exclusive of GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST) -
ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
- This DHT11 temperature and humidity sensor shield is specially designed for ESP8266 ESP-01 ESP-01S development board.
- On-board 8pin socket enable you plug the wifi transceiver to the board directly perfect for DIY your wireless temperature/humidity webserver system.
- Working Voltage: DC 3.7 – 12V
- The weight of about 10 grams
- Package Included: 1 X DHT11 Humidity Temperature Sensor
₹130.00 (Price is Exclusive of GST)ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
₹130.00 (Price is Exclusive of GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹207.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹207.00 (Price is Exclusive of GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)
-
2mm x 3mm PTFE Teflon Tube
2mm * 3mm PTFE Teflon Tube has 2mm inner diameter and 3mm outer diameter. PTFE Tube to is used to get the best printing performance out of your 3D Printer. It increases print quality, reduces filament jams, and improves retraction.
₹52.00₹65.00(Price is Exclusive of GST)2mm x 3mm PTFE Teflon Tube
₹52.00₹65.00(Price is Exclusive of GST) -
DS1302 Real Time Clock Module (RTC)
Features:-
- Real-Time Clock Counts Seconds, Minutes, Hours, Date of the Month, Month, Day of the Week, and Year with Leap-Year Compensation Valid Up to 2100
- Serial I/O for Minimum Pin Count
- 2.0V to 5.5V Full Operation
- Uses Less than 300nA at 2.0V
- Single-Byte or Multiple-Byte (Burst Mode) Data Transfer for Read or Write of Clock or RAM Data
₹52.00 (Price is Exclusive of GST)DS1302 Real Time Clock Module (RTC)
₹52.00 (Price is Exclusive of GST) -
A4988 driver Stepper Motor Driver
Features :
- Automatic current decay mode detection/choice.
- Mixed with slow current decay mode.
- The low power dissipation of synchronous rectifier.
- Internal UVLO(ultra voltage lockout).
- Crossover current protection.
- Thermal shutdown circuit.
- Ground fault protection.
- Loading and short circuit protection.
- The optional five-step mode: full, 1/2, 1/4, 1/8 and 1/16.
₹51.10 (Price is Exclusive of GST)A4988 driver Stepper Motor Driver
₹51.10 (Price is Exclusive of GST) -
3.3V/5V MB102 Breadboard Power Supply Module
Features :
- Breadboard power supply module, compatible with 5V, 3.3V.
- Apply to MB102 breadboard
- Fluctuation two road independent control can switch over to 0 V, 3.3 V, 5 V
- On-board two groups of 3.3V, 5V DC output plug pin, convenient external lead use.
₹51.00 (Price is Exclusive of GST)3.3V/5V MB102 Breadboard Power Supply Module
₹51.00 (Price is Exclusive of GST) -
₹50.00 (Price is Exclusive of GST)8 Channel Bi-Directional Logic Level Converter Module
₹50.00 (Price is Exclusive of GST) -
Round Plastic And Rubber Robot Track White Wheel 100x20MM
Applications:
- Light robotics applications
- Remotely Operated Robotic
- Vehicles and Belt/Tank style robot
₹50.00 (Price is Exclusive of GST)Round Plastic And Rubber Robot Track White Wheel 100x20MM
₹50.00 (Price is Exclusive of GST) -
1K ohm 5W Resistor (5 Pieces Pack)
Features
Electronics Components Passive Components Electronics Components Type Resistors Resistor Type Carbon Film Resistor Resistance Value  1 Ohms Power Rating of Resistor 5 Watt Tolerance       5% ₹50.00 (Price is Exclusive of GST)1K ohm 5W Resistor (5 Pieces Pack)
₹50.00 (Price is Exclusive of GST) -
GL-12 840 Points Solderless Breadboard
Features:
- 100% brand new and high quality
- Practical and useful
- Solderless breadboard with 840 points
- Completely reusable and have a self-adhesive back
- Easy component placement
₹50.00 (Price is Exclusive of GST)GL-12 840 Points Solderless Breadboard
₹50.00 (Price is Exclusive of GST) -
Metal Bracket for HC-SR04 Ultrasonic Module
Features:
- Metal Body.
- Easy to install.
- Attractive Design and Structure.
₹50.00 (Price is Exclusive of GST)Metal Bracket for HC-SR04 Ultrasonic Module
₹50.00 (Price is Exclusive of GST) -
Glass Fuses 250V for Power Inverter
Features:
- Designed to UL/CSA/ ANCE 248 Standard
- Available in cartridge and axial lead format
- RoHS compliant and lead-free
₹50.00 (Price is Exclusive of GST)Glass Fuses 250V for Power Inverter
₹50.00 (Price is Exclusive of GST) -
Breadboard-MB102 830 Points Bread Board/Solderless Pcb Circuit Test Board, White
- No soldering required
- Circuit electronics DIY
- Fit for jumper wire of 0. 8Mm diameter standard 2. 54Mm hole spacing
- Reusable for fast build a prototype of an electronic circuit will accept transistors, diodes, leds, resistors, capacitors and virtually all types of components
₹50.00 (Price is Exclusive of GST)Breadboard-MB102 830 Points Bread Board/Solderless Pcb Circuit Test Board, White
₹50.00 (Price is Exclusive of GST) -
Breadboard Power Supply Module 3.3V 5V
Input Voltage: 6.5-12 V (DC) or USB power supply
Output Voltage: 3.3V or 5V can switch over
Maximum Output Current: <700 ma
Fluctuation two road independent control, can switch over to 0 V, 3.3 V, 5 V
On-board two groups of 3.3V, 5V DC output plug pin, convenient external lead use₹50.00 (Price is Exclusive of GST)Breadboard Power Supply Module 3.3V 5V
₹50.00 (Price is Exclusive of GST)
