-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹638.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹638.00(Price is Exclusive of GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹264.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹264.00 (Price is Exclusive of GST) -
Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC:Â 3.3V-5V
GND:Â GND
DO:Â Digital output interface(0 and 1)
AO:Â Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST) -
Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST) -
ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
- This DHT11 temperature and humidity sensor shield is specially designed for ESP8266 ESP-01 ESP-01S development board.
- On-board 8pin socket enable you plug the wifi transceiver to the board directly perfect for DIY your wireless temperature/humidity webserver system.
- Working Voltage: DC 3.7 – 12V
- The weight of about 10 grams
- Package Included: 1 X DHT11 Humidity Temperature Sensor
₹130.00 (Price is Exclusive of GST)ESP8266 ESP-01/ESP-01S – DHT11 Temperature Humidity Sensor Module
₹130.00 (Price is Exclusive of GST) -
Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹207.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹207.00 (Price is Exclusive of GST) -
Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)
- “Orange ICR18650-22C 3.7V 2200mAh 3C Li-ion Battery” already exists in your wishlist
-
Pro-Range 11.1V 8000mAh 30C 3S Lithium Polymer Battery Pack
- Model No; Pro-Range 8000/3S-30C
- Weight :Â 615.0g
- Voltage :Â 11.1V
- Dimensions : 165 x 59.7 x 25.5(mm)
- Max Continuous Discharge : 30C(240.0A)
- Balance Plug : JST-XH
- Max Burst Discharge : 60C(480.0A)
- Discharge Plug : HXT-4mm
₹4,796.00 (Price is Exclusive of GST)Pro-Range 11.1V 8000mAh 30C 3S Lithium Polymer Battery Pack
₹4,796.00 (Price is Exclusive of GST) -
Flysky FS-I610 channel 2.4GHz AFHDS RC Transmitter with FS-iA6B Receiver
Features:
This radio system uses a high gain and multi directional antenna ;\Power: 6V (1.5V AA*4) ;
Transmitting Power:Â 20dBm ;
RF Receiver Sensitivity: -105dbm ;
Low Voltage Warning (V):Â 4.2
₹4,800.00 (Price is Exclusive of GST)Flysky FS-I610 channel 2.4GHz AFHDS RC Transmitter with FS-iA6B Receiver
₹4,800.00 (Price is Exclusive of GST) -
₹4,897.00 (Price is Exclusive of GST)
TL866II Plus Universal Programmer Kit with 6 IC Adapters
₹4,897.00 (Price is Exclusive of GST) -
Raspberry Pi 4 Model B – 4GB RAM
Raspberry RPi 4 4GB with the 4GB RAM capacity provides a huge scope for various multi-tasking activities, running powerful data servers, projects, virtual machines etc. This mini-computer is a better alternative since it is both energy efficient and cost effective. It is a silent machine and uses less energy than any other computer. It provides faster networking as it comes with a Gigabit Ethernet and onboard wireless networking along with better Bluetooth connectivity. It can transfer data 10 times faster with the help of two USB 3.0 ports and two USB 2.0 ports.
₹4,900.00₹8,500.00(Price is Exclusive of GST)Raspberry Pi 4 Model B – 4GB RAM
₹4,900.00₹8,500.00(Price is Exclusive of GST) -
PowerMax Dual Channel Brushed ESC Motor Controller with EBD – 60A
- PowerMax Series Brushed Motor Controllers are dual channel motor controllers capable of driving 2 brushed DC motors.
- Signal-loss failsafe
- Synchronous rectification,
- Rregenerative braking, and an
- Isolated heat sink plate.
- The Powermax series can be used with any standard RC signals.
- Best option for Robowar Use.
₹4,900.00₹6,500.00(Price is Exclusive of GST)PowerMax Dual Channel Brushed ESC Motor Controller with EBD – 60A
₹4,900.00₹6,500.00(Price is Exclusive of GST) -
Yahboom Tinybit Smart Robot Car Compatible with Micro:bit V2/1.5 board, without Micro:bit V2/V1.5 Board
Before Use Notice 1 Ensure that the Yahboom Tinybit Smart Robot Car Compatible with Micro:bit V2/1.5 board, without Micro:bit V2/V1.5 Board is properly connected to a stable Wi-Fi network for optimal performance. 2 Avoid placing the Yahboom Tinybit Smart Robot Car Compatible with Micro:bit V2/1.5 board, without Micro:bit V2/V1.5 Board near sources of moisture or extreme heat to maintain its longevity. 3 Follow the manufacturer’s instructions for software updates to ensure your Yahboom Tinybit Smart Robot Car Compatible with Micro:bit V2/1.5 board, without Micro:bit V2/V1.5 Board remains secure and up-to-date. ₹4,999.00 (Price is Exclusive of GST)Yahboom Tinybit Smart Robot Car Compatible with Micro:bit V2/1.5 board, without Micro:bit V2/V1.5 Board
₹4,999.00 (Price is Exclusive of GST) -
Flashforge Adventurer 4
-  Heated Build Plate Temperature: Up to 110°C (230°F) – Auto-Leveling Platform with An Aluminum Base
- Â Print Volume: 220 x 200 x 250 MM (8.7 x 7.9 x 9.8 IN) – Magnetic Removable Build Platform
-  Print Precision: ±0.1 MM (Tested with 100 MM Cube) – Quick Release Nozzle with Ultra-Fast Heat up
- Â Nozzle Diameter: 0.4 MM (Default); 0.6 MM & 0.3 MM (Optional) – Compatible with PLA, PETG, ABS, PC, PLA-CF, PETG-CF / Compatible with FlashForge 0.3 MM, 0.4 MM, and 0.6 MM Nozzles
- Â Fully Enclosed Printing Chamber & HEPA 13H Air Filter System Manage series of Adventurer 4 3D Printers remotely for ultra-efficiency with high output, scale-up, or do your production at will
₹5,415.00 (Price is Exclusive of GST)Flashforge Adventurer 4
₹5,415.00 (Price is Exclusive of GST) -
Pro-Range INR 21700 P42A 11.1V 12600mAh 3S3P 115A/140A Discharge Li-ion Drone Battery Pack
- Nominal Capacity (mAh): 12600
- Nominal Voltage (v): 11.1
- Max Charging Voltage (v): 12.6
- Charge Port: 4 Pin JST XH
- Discharge Port: Amass XT90 AS
₹5,452.00 (Price is Exclusive of GST)Pro-Range INR 21700 P42A 11.1V 12600mAh 3S3P 115A/140A Discharge Li-ion Drone Battery Pack
₹5,452.00 (Price is Exclusive of GST) -
JK86HS155-4208 NEMA34 122Kg-cm Stepper Motor- Keyway Type
- Step Angle:1.8°
- No. of Leads: 8
- Shaft Type: Keyway Type
- Holding Torque (kg-cm): 122
- Current: 4.2A
₹5,476.00 (Price is Exclusive of GST)JK86HS155-4208 NEMA34 122Kg-cm Stepper Motor- Keyway Type
₹5,476.00 (Price is Exclusive of GST) -
Orange 6200 mAh 4S 35C/70C Lithium Polymer Battery Pack
Features :
- Product Type: Lithium Polymer Battery Pack
- The Orange LiPo battery has matched resistance.
- Good temperature control.
- Minimum weight in Class
₹5,480.00 (Price is Exclusive of GST)Orange 6200 mAh 4S 35C/70C Lithium Polymer Battery Pack
₹5,480.00 (Price is Exclusive of GST) -
GSB600RE 13MM 600W Drilling Machine Set
- Rated power: 600 W, No-load speed : 0-2800 rpm
- Forward / Reverse switch for screw driving work; Advantages: Robust and powerful 600 W motor; Extremely handy: No bigger than a glove and 1.7 kg light; Soft in line grip for a secure hold
- Hammering/drilling mode selector switch
₹5,500.00 (Price is Exclusive of GST)GSB600RE 13MM 600W Drilling Machine Set
₹5,500.00 (Price is Exclusive of GST) -
VEER 360 Altitude hold drone double Battery
- Speed level : Beginner, Moderate and Sports for racing mode.
- 3D Flip Stuns : Get fun with just one click. || Control Mode : Fly with 2.4 GHz Remote.
- One Key Take-Off / Landing : to fly like PRO with safety. || One-Key-Return and Head-Less : So that you don’t worry about losing your Drone.
- Double Battery : Included Double fun with double batteries.
- Package contains :- 1 Drone module, 1 2.4 GHz remote control, 4 safety guards, 2 pcs LiPo battery, 1 charging cable, 1 Instruction manual for operation, 4 Landing Gears, & 1 Screwdriver.
₹5,500.00 (Price is Exclusive of GST)VEER 360 Altitude hold drone double Battery
₹5,500.00 (Price is Exclusive of GST)
