202 Pot

• Type: RM065 2k
• Resistance: 2K ohm
• Tolerance: +10%
• Operating Temperature Range: -10℃ to +70℃
• Mounting Type: Through Hole
• Length (mm): 7
• Width (mm): 6.5
• Height (mm): 5
• This potentiometer is easy to mount on a PCB and can be adjusted using a screwdriver.

HX711

Specifications and Features :

1. Recommended excitation voltage: 5-10V.
2. Two selectable differential input channels.
3. On-chip active low noise PGA with a selectable gain of 32, 64 and 128.
4. On-chip power supply regulator for load-cell and ADC analogue power supply.
5. Selectable 10SPS or 80SPS output data rate.
6. On-chip oscillator requiring no external component with optional external crystal.
7. On-chip power-on-reset.
8. Simple digital control and serial interface: pin-driven controls, no programming needed.
9. Simultaneous 50 and 60Hz supply rejection.

M274 360 Degree Rotary Encoder

1. Model : KY-040.
2. Type : Incremental Encoder.
3. Cycles per revolution (CPR) : 20.
4. Working voltage : 0 – 5V.
5. Material : PCB + Brass.
6. Mounting Nut Thread diameter: 6.6mm
7. Weight : 10 gm.

Applications of bevel gears are as follows:

1. They are used in differential drives, which can transmit power to two axles spinning at different speeds, as as those on a cornering automobile
2. Bevel gears are used as the main mechanism for hand drills. The bevel gears have added an advantage of increasing the speed of rotation of the chuck and this makes it possible to drill a range of materials.
3. Standard bevel gears are mainly used in low speed applications.

Features:

1. Good Quality Material
2. Light Weight
3. Heavy Duty and Long Life
4. Good Temperature and Environmental Resistance

Features:

1. Plug Type: 5mm gold bullet connector in nylon shroud
2. Housing shape provides protection against shorting and reverse polarity
3. Can accept up to 8AWG wires
4. Semicircular solder terminals make it easy to install wires
5. Able to sustain 90A+ continuous current

Applications of bevel gears are as follows:

1. They are used in differential drives, which can transmit power to two axles spinning at different speeds, as as those on a cornering automobile
2. Bevel gears are used as the main mechanism for hand drills. The bevel gears have added an advantage of increasing the speed of rotation of the chuck and this makes it possible to drill a range of materials.
3. Standard bevel gears are mainly used in low speed applications.

Features:

1. Good Quality Material
2. Light Weight
3. Heavy Duty and Long Life
4. Good Temperature and Environmental Resistance