-
MPR121 Touch Sensor Controller Module
- Connection Interface: I2C.
- Operating Voltage: 2.5-3.6 VDC
- Â Application: Capacitive Touch Sensor Controller
- Number of touch inputs:12
- Material: Alloy+Plastic
₹90.00 (Price is Exclusive of GST)MPR121 Touch Sensor Controller Module
₹90.00 (Price is Exclusive of GST) -
TTP224 4-channel Capacitive touch sensor Module
Feature:-
- Onboard capacitive touch sensor IC
- 4 board-level status indicator
- Working voltage: 2.4V – 5.5V
- Advanced Pins breakout, so that the output mode and working mode selectable.
- Low power selection
- PCB board size: 35 (mm) x 29 (mm)
₹60.00 (Price is Exclusive of GST)TTP224 4-channel Capacitive touch sensor Module
₹60.00 (Price is Exclusive of GST) -
SW-420 Vibration Sensor Module
- Using SW-420 normally closed type vibration sensor.
- Comparator output, clean signal, good waveform, strong driving ability, >15mA.
- Using a wide voltage LM393 comparator.
- With bolt holes for easy installation.
₹49.00 (Price is Exclusive of GST)SW-420 Vibration Sensor Module
₹49.00 (Price is Exclusive of GST) -
TTP223B Digital Capacitive Touch Sensor Module
- Low power consumption.
- Power supply for 2 ~ 5.5V DC
- Can replace the traditional touch of a button, touch area.
- Four m2 screws positioning holes for easy installation, power indicator green led, power on the right that is shiny.
- Control interface : A total of three pins (gnd, vcc, sig), gnd to ground , vcc is the power supply , sig digital signal output pin.
₹13.00₹35.00(Price is Exclusive of GST)TTP223B Digital Capacitive Touch Sensor Module
₹13.00₹35.00(Price is Exclusive of GST) -
SW420 Tilt Ball switch 2801 ball sensor
- Operating voltage: 5V
- Contact Resistance:Â < 10 Ohms
- Trigger Angle: 15°
- Pins have no polarity
- This series of products is a ball sensor switch, up and down, or. Tilt over 15 degrees is conductive
- The series switch is normally open at rest (OFF) state, when the external force to achieve the corresponding flip, or at a proper angle of tilt, trigger switch.
- The trigger sensitivity of the inductive switch is very high
- Fully sealed package, waterproof, dustproof.
₹12.00 (Price is Exclusive of GST)SW420 Tilt Ball switch 2801 ball sensor
₹12.00 (Price is Exclusive of GST) -
₹10.00 (Price is Exclusive of GST)TTP223 Touch Sensor Module
₹10.00 (Price is Exclusive of GST)
All Categories
- Atal Tinkering Lab (ATL)
- 3D Printer & Accessories
- Communications & Interfacing
- Connector & Cable Wires
- Consumer Products
- Development Boards
- Educational DIY & STEM Kits
- Electronic Components
- Electronic Modules & Displays
- Mechanical Hardware Tools and Accessories
- Power Supply and Prototypes
- Robotics and Hobbies
- Sensors
- Scientific Tools and Equipments
- Other Tools and Equipment’s
- Bulk/Wholesale
