No products in the cart.
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (Price is Exclusive of GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(Price is Exclusive of GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (Price is Exclusive of GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (Price is Exclusive of GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (Price is Exclusive of GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
- Operating Voltage: 3.3 ~ 5.5 VDC.
- Operating Current: 5mA.
- Interface: PH2.54-3P.
- Supports 3-Pin Gravity Sensor interface
- Intelligent agriculture
₹60.00 (Price is Exclusive of GST)Capacitive Soil Sensor V2.0
₹60.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
Wiring Connection
VCC: 3.3V-5V
GND: GND
DO: Digital output interface(0 and 1)
AO: Analog output interfaceFeatures :
- Dual output mode, analog output more accurate
- A fixed bolt hole for easy installation
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable.
₹690.00 (Price is Exclusive of GST)Soil Moisture Sensor Module Wholesale/B2B (Pack of 25)
₹690.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹390.00 (Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
- Robotics Kit Arduino based Do it Yourself Type Kit
- Explorer Board- UNO compatible microcontroller board with integrated motor controllers, RGB LED, and breadboard
- Power Supply Module- To be used with 18650 Li-Ion batteries with on-board charge and usage switches
- Acrylic Chassis- Consists of two layers for mounting the electronics and serves as the chassis of the robot. Also contains 4 nylon spacers for connecting the top and bottom layers.
- Micro Metal gear motors- Two motors used for robot mobility. Wheels & Tyres- Plastic wheels with silicone tyres for great traction.
- Line Following Array- Line following sensor consisting of 5 individual sensors to help in projects such as line following. Ultrasonic Sensor- Adds distance sensing capability to your project.
₹3,450.00₹4,500.00(Price is Exclusive of GST)Explorer Kit for Robotics and DIY Prototyping Compatible with Arduino IDE
₹3,450.00₹4,500.00(Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
- Voltage: 12V to 24V; Max Current: 25A
- Can work stably when the current is not more than 25A
- Maximum power of the heated bed: Over 300W (12V) or 600W (24V) Make sure that the cables that connect to the controller board and hotbed can withstand high current
₹200.00 (Price is Exclusive of GST)Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D Printer
₹200.00 (Price is Exclusive of GST)
Automatic Dawn to Dusk Sensor Board with Relay and LDR for Solar Based Street Light
Features:
LDR Based Sensor
On Board 12V Relay to Control Solar street Light
Relay will automatically turn ON in Low lighting Condition and will turn OFF when lighting is adequate
Pefect to control Solar based Garden light or Street light
Works best in open Natural Light Source₹125.00 (Price is Exclusive of GST)Automatic Dawn to Dusk Sensor Board with Relay and LDR for Solar Based Street Light
₹125.00 (Price is Exclusive of GST)Automatic Hand Sanitizer Dispenser with Ultrasonic Sensor – 8 Litre Capacity
Features:
Automatic Sensing
8 Liter Tank Capacity
Mist Spray for better output
Easy to Install, just need to plug and use
6 Months Manufacture Warranty
Works under Sunlight₹3,500.00 (Price is Exclusive of GST)Automatic Hand Sanitizer Dispenser with Ultrasonic Sensor – 8 Litre Capacity
₹3,500.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹390.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser Tunnel Control Board with inbuilt Sensor Interface Port for Ultrasonic and IR, Relay, Timer Control and Motor Kit
₹390.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser/Tunnel Control Board with inbuilt IR (InfraRed) Sensor Interface, Relay, Timer Control and Motor Port Kit
- Automatic relay controller board for sanitiser machine
- No extra connections required
- Just connect Ir sensor, water pump and power supply
- Easy to use DIY kit
₹175.00 (Price is Exclusive of GST)Automatic Sanitizer Dispenser/Tunnel Control Board with inbuilt IR (InfraRed) Sensor Interface, Relay, Timer Control and Motor Port Kit
₹175.00 (Price is Exclusive of GST)- ₹180.00 (Price is Exclusive of GST)
Avr Usb Programmer Usbasp Usbisp Isp For Atmel Atmega Attiny Microcontrollers
₹180.00 (Price is Exclusive of GST) BASIC NX3224T028 2.8″HMI LCD Touch Display
Features:
- 320 x 240 Resolution
- RGB 65K true to life colours
- TFT screen with integrated resistive touch panel
- 4 pin TTL serial interface
- 4M Flash memory for User Application Code and Data
- Onboard micro-SD card slot for firmware upgradation
- Visual Area: 57.6mm(L)×43.2mm(W)
- Adjustable Brightness: 0~180 nit, the interval of adjustment is 1%
- 5V65mA power consumption
- Compatible with Raspberry Pi A+, B+, Pi 2, Pi 3, Arduino.
- Certificates: CE/EMC, RoHS (certificates)
Software:
₹2,450.00 (Price is Exclusive of GST)BASIC NX3224T028 2.8″HMI LCD Touch Display
₹2,450.00 (Price is Exclusive of GST)Basic Robotics kit
Basic Robotics kit
Breadboard – 1
DC Motor – 1
Buzzer – 1
Green LED – 1
Red LEDs – 2
Push Button Switches – 3
Slide Switch – 1
Red Alligator Clip – 1
Black Alligator Clip – 1
Connecting Towers – 6
10kΩ Resistor – 1
20kΩ Resistor – 1
3.3kΩ Resistor – 1
Capacitor – 1
Jumper Wires – 3
₹10,170.00 (Price is Exclusive of GST)Basic Robotics kit
₹10,170.00 (Price is Exclusive of GST)BFD-1000 Five Channel Infrared Tracking Module Tracing Sensor
- Input voltage: 3.0 V – 5.5 V
- Output form: digital output (high and low level)
- Detection distance: 0 – 4 cm (black and white line sensors)
- 0 – 5 cm (adjustable distance detection)
₹138.00 (Price is Exclusive of GST)BFD-1000 Five Channel Infrared Tracking Module Tracing Sensor
₹138.00 (Price is Exclusive of GST)BFD-1000 Five Channel Infrared Tracking Module Tracing Sensor
- Input voltage: 3.0 V – 5.5 V
- Output form: digital output (high and low level)
- Detection distance: 0 – 4 cm (black and white line sensors)
- 0 – 5 cm (adjustable distance detection)
₹138.00 (Price is Exclusive of GST)BFD-1000 Five Channel Infrared Tracking Module Tracing Sensor
₹138.00 (Price is Exclusive of GST)BMP 280 Barometric Pressure and Altitude Sensor I2C/SPI Module
- Operating Voltage: 1.71V to 3.6V – would typically be operated from 3.3V
- Operating Temperature: -40 to +85 deg. Celsius (full accuracy between 0 and +65 deg. C)
- Operating Pressure: 300 hPa to 1100 hPa
- Peak current: 1.12mA
- Accuracy between 700 to 900hPa and 25 to 40 deg. C: ±0.12hPa and ±1.0m
₹40.00 (Price is Exclusive of GST)BMP 280 Barometric Pressure and Altitude Sensor I2C/SPI Module
₹40.00 (Price is Exclusive of GST)BMP180 Barometric Pressure Altitude Sensor I2C/SPI Module
Specifications and Features :
- Get more precise temperature, atmospheric pressure values, and approximate altitude data
- Enhancement of GPS navigation (e.g. time-to first-fix improvement, dead-reckoning, slope detection)
- Indoor navigation (floor detection, elevator detection)
- Outdoor navigation, leisure and sports applications
- Weather forecast
- Health care applications (e.g. spirometry)
- Vertical velocity indication (e.g. rise/sink speed)
- Libraries and tutorials available for Arduino and other microcontrollers
- Operating Voltage: 1.71V to 3.6V – would typically be operated from 3.3V
- Operating Temperature: -40 to +85 deg. Celsius (full accuracy between 0 and +65 deg. C)
- Peak current: 1.12mA
- Operating Pressure: 300 hPa to 1100 hPa
- Accuracy between 700 to 900hPa and 25 to 40 deg. C: ±0.12hPa and ±1.0m
₹32.00 (Price is Exclusive of GST)BMP180 Barometric Pressure Altitude Sensor I2C/SPI Module
₹32.00 (Price is Exclusive of GST)Bms 13S 40A 48V Waterproof Protection Circuit Module
- 13S 48V BMS
- Discharging current – 40A
- Charging current – 20 A
- Waterproof.
₹1,250.00 (Price is Exclusive of GST)Bms 13S 40A 48V Waterproof Protection Circuit Module
₹1,250.00 (Price is Exclusive of GST)
