-
NE555 Frequency Adjustable Pulse Generator Module
- Single channel signal output, the output duty cycle about 50% square wave.
- Plate load resistor, adjust the resistance to control the output frequency.
- Onboard power indicator.
- Working voltage: 5V~12V.
- Onboard NE555 IC.
₹35.00 (excl. GST)NE555 Frequency Adjustable Pulse Generator Module
₹35.00 (excl. GST) -
UNO R3 with USB Cable Compatible with Arduino
- Micro-controller : ATmega328.
- Operating Voltage : 5V.
- Input Voltage (recommended) : 7-12V.
- Digital I/O Pins : 14 (of which 6 provide PWM output).
- Analog Input Pins : 6.
₹540.00₹690.00(excl. GST)UNO R3 with USB Cable Compatible with Arduino
₹540.00₹690.00(excl. GST) -
LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
- Operating Voltage (VDC) 3.3
- Digital I/O Pins 26
- Analog I/O Pins 12
- Clock Speed 240 MHz
- Flash Memory 4 MB
₹405.00 (excl. GST)LOLIN32 V1.0.0 based on ESP32 Rev1 Wifi Bluetooth Board
₹405.00 (excl. GST) -
4 Channel 5V Relay Module with Optocoupler
- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
₹160.00 (excl. GST)4 Channel 5V Relay Module with Optocoupler
₹160.00 (excl. GST) -
Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
- TDA7297 power amplifier board, connecting terminals all adopt XH2.54 needle seat, quick installation
- 2.0 dual channel 15W+15W output, can be connected to 4-8 Euro 10-50W speakers, wide range of applications
- Voltage: DC 9-15V, recommended DC voltage 12V, current 2A or more
- Power: 15W+15W
- Impedance: 4-8 ohms
₹215.00 (excl. GST)Dual Channel TDA7297 Amplifier Board AC/DC 12V Module
₹215.00 (excl. GST)
-
Leadshine DM542 Digital Stepper Motor Driver
Features:
- Extremely cost-effective
- Good high-speed performance
- Automatic idle-current reduction
- 3-state current control technology
- Self-adjustment technology
- Pure-sinusoidal current control technology
- TTL compatible and optically isolated input
- 15 selectable resolutions in decimal and binary, up to 25,600 steps/rev
- Suitable for 2-phase and 4-phase motors
- DIP switch current setting with 8 different values
- Support PUL/DIR and CW/CCW modes
- Short-voltage, over-voltage, over-current protection
₹2,536.00 (excl. GST)Leadshine DM542 Digital Stepper Motor Driver
₹2,536.00 (excl. GST) -
12mm Square Flange Bushing Linear Bearing LMK12LUU
Features :
- Smooth moving
- Low friction
- High rigid
- Long life
- Economical and easy to maintain.
₹206.00 (excl. GST)12mm Square Flange Bushing Linear Bearing LMK12LUU
₹206.00 (excl. GST) -
NEEMA 23-JK57HS76-2804-1.89N m Stepper Motor – Round Type Shaft
Features :
- The input pulse decides the rotation angle of the motor.
- High accuracy of around 3 to 5% a step.
- It provides good starting, stopping, and reversing.
- Control of this motor is less costly because of the exclusion of complex control circuitry.
- The speed is proportional to the frequency of the input pulses.
₹1,430.00 (excl. GST)NEEMA 23-JK57HS76-2804-1.89N m Stepper Motor – Round Type Shaft
₹1,430.00 (excl. GST) -
1m Cable Drag Chain 10 x 15mm Wire Carrier
Features :
- Reinforced nylon with high pressure and tensile load, good toughness, high elasticity and abrasion resistance, flame retardant,
- high-temperature stable performance can be used outdoors, nylon towline content determines how much to use strength and
- wear resistance and noise level up and running.
- Resistance to: oil, salt, and a certain acid, alkali capacity.
- Speed and acceleration (specific speed, acceleration, as the case may be running).
- Long operating life.
- Chain shape like gram chain link by a large number of units composed of freely rotating between links.
- A unit chain around the chain plate and the upper and lower cover plates, towline can open each section, easy assembly and disassembly without threading, to the cable, tubing, pipe, pipe, etc. into the towline open the cover.
₹410.00 (excl. GST)1m Cable Drag Chain 10 x 15mm Wire Carrier
₹410.00 (excl. GST) -
10mm Spiral Wrapping Band Black 10M for Wires
Features :
- Extremely versatile in flexibility
- Designed to Hold and Protect Cables, Harnesses, and Hoses
- Allows Flexibility while Providing Secure Bundling
- Quick and Easy to Install due to Flexible Polyethylene Construction
- Easily removed and re-applied
- Thick wall Provides Greater Resistance to Abrasions and Vibrations
- Breakout at Any Point
₹120.27 (excl. GST)10mm Spiral Wrapping Band Black 10M for Wires
₹120.27 (excl. GST) -
10mm Square Flange Bushing Linear Bearing LMK10LUU
Features :
- Smooth moving
- Low friction
- High rigid
- Long life
- Economical and easy to maintain.
₹206.00 (excl. GST)10mm Square Flange Bushing Linear Bearing LMK10LUU
₹206.00 (excl. GST) -
12mm Square Flange Bushing Linear Bearing LMK12LUU
Features :
- Smooth moving
- Low friction
- High rigid
- Long life
- Economical and easy to maintain.
₹206.00 (excl. GST)12mm Square Flange Bushing Linear Bearing LMK12LUU
₹206.00 (excl. GST) -
6MM Flange Linear Motion Ball Bearing LMF6UU
Features :
- Metric Flange Linear Bearing
- Circular Flange
- Four Mount Hole
₹139.00 (excl. GST)6MM Flange Linear Motion Ball Bearing LMF6UU
₹139.00 (excl. GST) -
Aluminum Flexible Shaft Coupling 5mm x 5mm
Features :
- Corrosion resistance and High Durability
- One piece construction with long-lasting performance
- Torsional stiffness: Zero backlash
- Low moment of inertia offering constant velocity
₹120.00 (excl. GST)Aluminum Flexible Shaft Coupling 5mm x 5mm
₹120.00 (excl. GST) -
Aluminum Flexible Coupling Coupler Helical Shaft 5mm x 8mm
Features :
- Corrosion resistance and High Durability
- One piece construction with long-lasting performance
- Torsional stiffness: Zero backlash
- Low moment of inertia offering constant velocity
₹110.00 (excl. GST)Aluminum Flexible Coupling Coupler Helical Shaft 5mm x 8mm
₹110.00 (excl. GST) -
8x19x6 698ZZ Stainless Steel Shielded Miniature Bearings (4Pcs)
The shield protects the working parts of the bearing from environmental debris that may be introduced and could reduce the ball bearing speed and lifespan. Rolling bearings are used in a range of applications from agricultural machinery to conveying equipment, robotics, dental equipment, elevators, rolling mills, ship rudder shafts, and aggregate crushers, among others.
₹160.00 (excl. GST)8x19x6 698ZZ Stainless Steel Shielded Miniature Bearings (4Pcs)
₹160.00 (excl. GST)
