AD633JNZ IC

1.The AD633 is a complete four-quadrant multiplier offered in low cost 8-lead SOIC and PDIP packages. The result is a product that is cost effective and easy to apply.

2.No external components or expensive user calibration are required to apply the AD633.

3.Monolithic construction and laser calibration make the device stable and reliable.

4.High (10 MΩ) input resistances make signal source loading negligible.

5.Power supply voltages can range from ±8 V to ±18 V. The internal scaling voltage is generated by a stable Zener diode; multiplier accuracy is essentially supply insensitive.

Features:

1. Security power function: When the power is turned on, regardless of the throttle stick at any position will not start the motor immediately to prevent personal injury
2. Throttle range calibrated function: to adapt the throttle differences between different strokes, improve the linearity of throttle response
3. programmed project (available throttle stick or card LED parameter settings):
   1. Brake setting: No brake / with brake
   2. Battery Type: Lithium battery / NiMH
   3. Low Voltage Protection Mode: Soft Shutdown / hard off
   4. Low Voltage Protection Threshold: low / medium / high
   5. start mode: Normal / Soft / Super-soft and start
   6. Timing: low / medium / high
   7. Restore factory defaults
4. Comprehensive protection features:
   1. Under-voltage protection: the program set by the user when the battery voltage is below the protection threshold, ESC automatically reduces the output power
   2. Overvoltage Protection: input voltage exceeds the input range are not allowed to start, automatic protection, also issued a hasty “beep” Warning
   3. Overheat protection: built-in temperature detection circuit that automatically reduces the output power ESC temperature is too high
   4. Remote signal loss protection: remote control signal is lost for 1 second to reduce the power, and then have two seconds to turn off without the remote control signal output

Features:

1. 4inch IPS screen, 480×800 hardware resolution.
2. Resistive touch control.
3. Compatible and Direct-connect with any revision of Raspberry Pi (except the Pi 1 Model B or Pi Zero, which requires an HDMI cable).
4. Drivers provided (works with your own Raspbian/Ubuntu/Kali/Retropie).
5. Also works as a computer monitor, in this case, the touch panel is unavailable and an HDMI cable is required.
6. HDMI interface for displaying, no I/Os required (however, the touch panel still needs I/Os).
7. 3.5mm audio jack, supports HDMI audio output.
8. The backlight can be turned off to lower power consumption.

Features:

1. Extremely cost-effective
2. Good high-speed performance
3. Automatic idle-current reduction
4. 3-state current control technology
5. Self-adjustment technology
6. Pure-sinusoidal current control technology
7. TTL compatible and optically isolated input
8. 15 selectable resolutions in decimal and binary, up to 25,600 steps/rev
9. Suitable for 2-phase and 4-phase motors
10. DIP switch current setting with 8 different values
11. Support PUL/DIR and CW/CCW modes
12. Short-voltage, over-voltage, over-current protection